SGL0622Z

RFMD + TriQuint = Qorvo SGL0622Z 5 MHz to 4000 MHz, Low-Noise SiGe HBT MMIC Amplifier The SGL0622Z is a low noise, high gain MMIC LNA designed for low power single-supply operation from +2.7 V to +3.6 V. It’s Class-2 ESD protection and high input overdrive capability ensures rugged performance, while its integrated active bias circuit maintains robust stable bias over temperature and process beta variation. The SGL0622Z is internally matched from 5 MHz to 4000 MHz and requires only 4 to 5 external biasing components (DC blocks, bypass caps, inductive choke). The SGL0622Z is fabricated using highly repeatable Silicon Germanium technology and is housed in a cost effective RoHS/WEEE compliant 2 x 2 mm DFN package. 8 Pin, 2.0 mm x 2.0 mm DFN Package Features       Functional Block Diagram High Gain, 28.6 dB at 1575 MHz Low Noise Figure, 1.4 dB at 1575 MHz Low Power Consumption 10.5 mA at +3.3 V Battery Operation:+2.7 V to +3.6 V (Active Bias) Fully Integrated Matching Class 2 ESD Protection (>2000 V HBM) Applications   High Gain GPS Receivers ISM and WiMAX LNAs Ordering Information SGL0622Z 7" Reel with 3000 pieces SGL0622ZSQ Sample Bag with 25 pieces SGL0622ZSR 7" Reel with 100 pieces SGL0622ZPCK1 100MHz to 3500MHz PCBA with 5-piece Sample Bag Revision DS20160114 © 2016 Qorvo, Inc. - 1 of 8 - Disclaimer: Subject to change without notice www.rfmd.com / www.qorvo.com SGL0622Z RFMD + TriQuint = Qorvo Absolute Maximum Ratings Parameter Device Voltage(VD) Device Current (ID) RF Input Power Storage Temperature ESD Rating (HBM) Moisture Sensitivity Level Rating Units +4.0 30 −10 -55 to +150 +2000 (Class 2) MSL1 V mA dBm °C V - Notes: 1. Load Condition 1: ZL = 50 Ω 2. Load Condition 2: ZL = 10:1 VSWR 3. Input Power may be driven above −10 dBm provided device current does not exceed the absolute maximum. Device current can be limited by means of a dropping resistor (typically 27 Ω) between VS and Pin 1. Device current in an overdrive scenario will vary according to the operation frequency. 4. Operation of this device beyond any one of these limits may cause permanent damage. For reliable continuous operation the device voltage and current must not exceed the maximum operating values specified in this table. 5. Bias Conditions should also satisfy the following expression: IDVD