NSL-32SR2

Optocoupler NSL 32SR2 Precision – Control – Results WWW.LUNAINC.COM 5.7 min. 25.4 min. Photocell 2.54 Anode lead 0.25 x 0.51 + LED Photocell - - ∅ 0.45-0.56 + LED 3.30 Color dot ∅ 6.0 - 6.5 5.72 - 6.22 Cathode lead 0.25 x 0.64 Dimensions in mm. Lead spacing tolerance: +/-0.13 Circuit Schematic cell leads DESCRIPTION FEATURES This optocoupler consists of an LED input optically coupled to a photocell. The photocell resistance is high when the LED current is “off” and low resistance when the LED current is “on”. • • • • • RELIABILITY APPLICATIONS Contact Luna for recommendations on specific test conditions and procedures. • Compact, moisture resistant package Low LED current Very low “on” resistance Passive resistance output Low distortion Industrial ABSOLUTE MAXIMUM RATINGS SYMBOL Isolation Voltage MIN MAX UNITS - - 2000 V Ta = 23°C UNLESS OTHERWISE NOTED Operating Temperature -40 to +75 °C Non condensing Soldering Temperature -40 - +75 °C - Soldering Temperature - - +260 °C >2mm from case for < 5 sec. NOTE: 1.Measure after 1 minute ON @ IF = 20mA and followed by 10 sec OFF 2. Print “NSL-32SR2” and date code YYWW Information in this technical datasheet is believed to be correct and reliable. However, no responsibility is assumed for possible inaccuracies or omission. Specifications are subject to change without notice. REV 01-04-16 Page 1/2 © 2016 Luna Optoelectronics. All rights reserved. Luna Optoelectronics, 1240 Avenida Acaso, Camarillo CA 93012 • Phone (805) 987-0146 • Fax (805) 484-9935 Optocoupler NSL 32SR2 Precision – Control – Results WWW.LUNAINC.COM Ta = 23°C UNLESS NOTED OTHERWISE OPTO-ELECTRICAL PARAMETERS TEST CONDITIONS PARAMETER MIN TYP MAX UNITS LED Forward Current - - - 25 mA Forward Current If = 20 mA - - 2.5 V Reverse Current VR = 4V - 10 µA Maximum Cell Voltage Peak AC or DC - - 60 V Power Dissipation 2 - - 50 mW If=20 mA - - 40 Ω If=5 mA - 140 - Ω 25 5 - MΩ CELL COUPLED On Resistance Off Resistance 10 sec after If = V-0.5 Vdc on cell Rise Time Time to reach 63% of final conductive @ If = 5mA - 5 - m sec Decay Time Time to reach 100KΩ from removal of If = 5mA - 80 - m sec Cell Temp Coefficient If > 5 mA - 0.7 - %/K NOTE: 1.Derate linearly to 0 at 75°C 2.>2 mm from case for