AWS5506S14

AWS5506 GaAs IC SPDT Reflective Switch Positive Control DC - 2.5 GHz Data Sheet - Rev 2.1 FEATURES • • • • • Low Insertion Loss (0.4 dB @ 0.9 GHz) Complementary Positive Control Voltages (0/ +3V to 0/+5V) Positive Voltage Supply (+3 to +5 V) Low DC Power Consumption Ultra Miniature 6 Lead SOT-6 Package APPLICATIONS • Typical applications include: selection of synthesizers, filters, amplifiers in dual mode, and dual band handsets. S14 SOT-6 6 Pin Plastic Package DESCRIPTION The AWS5506 is a Single Pole Double Throw GaAs MMIC switch assembled in a SOT-6 plastic package. The AWS5506 is designed for analog and digital application that require for insertion loss, small size, and low cost. State selection is achieved with a complimentary positive voltage (requires positive bias Vs, and blocking caps) or negative voltage (no Vs or blocking caps required). Table 1: Pin Description RF1 (J2) RF2 (J3) V1 RFCOM (J1) C4 10KΩ Vs PIN 1 2 3 4 5 6 NAME RF 1 (J2) GND RF2 (J3) V2 RF COM (J1)/Vs V1 DESCRIPTION RF port (can be used as an input and as an output) Ground connection (keep as short as possible) RF port (can be used as an input or as an output) Control voltage 2 (low 0V, High 3V to 5V) RF common port and bias voltage for positive control (3V to 5V) Control voltage 1 (low 0V, High 3V to 5V) 1 6 C1 GND C2 DC blocking capacitors (C1, 2, 4) and biasing resistor (R1) must be supplied externally for positive voltage operation. C1, 2, 4 = 100 pF for operation >500 MHz. Figure 1: Pin Out Diagram 2 3 5 V2 4 08/2001 AWS5506 ELECTRICAL CHARACTERISTICS Table 2: Absolute Minimum and Maximum Ranges PARAMETER RF Input Power > 500 MHz, 0/+7 V Control Control Voltage Operating Temperature Storage Temperature Θ JC MIN -0.2 -40 -50 - MAX 2 +8 +125 +150 25 UNIT W V °C °C ° C/W Stresses in excess of the absolute ratings may cause permanent damage. Functional operation is not implied under these conditions. Exposure to absolute ratings for extended periods of time may adversely affect reliability. (8 pt bold) Table 3: Operating Ranges at 25° C (0, +3V) PARAMETER CONDITION Rise, Fall (10/90% or 90/10% RF) On, Off (50% CTL to 90%/10% RF) Video Feedthru For Two-tone Input Power +10 dBm @ +3V @ +5V FREQUENCY 0.5 - 2.0 GHz 0.5 - 2.0 GHz 0.5 - 2.0 GHz MIN TYP 10 20 25 +45 +21 +28 MAX UNIT ns ns mV dBm dBm Switching Characteritics 5 Intermodulation Intercept Point (IP3) Input Power for 1dB Compression Control Voltage V LOW = 0 to 0.2 V @ 20 uA Max V HIGH = +3 V @ 100 uA Max to +5 V @ 200 uA Max V S = VHIGH + 0.2V The device may be operated safely over these conditions; however, parametric performance is guaranteed only over the conditions defined in the electrical specifications. Notes: 1. All measurements made in a 50 ohm system, unless otherwise specified. 2. DC = 300 kHz. 3. Insertion loss changes by 0.003 dB/°C. 4. Insertion loss state. 5. Video feedthru measured with 1 ns rise time pulse and 500 MHz bandwidth. 2 Data Sheet - Rev 2.1 08/2001 AWS5506 Table 4: Electrical Specifications at 25 °C (0, +3V) PARAMETER 1 FREQUENCY 2 DC - 0.5 GHz DC - 1.0 GHz DC - 2.0 GHz DC - 2.5 GHz DC - 0.5 GHz DC - 1.0 GHz DC - 2.0 GHz DC - 2.5 GHz DC - 1.0 GHz DC - 2.5 GHz MIN 22 17 11 10 - TYP 0.4 0.45 0.6 0.9 25 20 14 13 1.2:1 1.5:1 MAX 0.5 0.6 0.8 1.1 1.3:1 1.7:1 UNIT dB dB dB dB dB dB dB dB - Insertion Loss 3 Isolation VSWR 4 Table 5: Truth Table Positive Operation V1 VHigh 0 V2 0 VHigh J1 - J2 Insertion Isolation J1 - J3 Isolation Insertion VHigh = +3 to +5 V (VS = VHigh + 0.2 V) Data Sheet - Rev 2.1 08/2001 3 AWS5506 Figure 2: Test Circuit Schematic 4 Data Sheet - Rev 2.1 08/2001 AWS5506 PACKAGE OUTLINE θ SYMBOLS DIMENSIONS IN MILLIMETERS DIMENSIONS IN INCHES A A1 A2 b C D E e H L θ1 MIN 1.00 0.00 0.70 0.35 0.10 2.70 1.40 2.60 0.37 1° NOM 1.10 −−− 0.80 0.40 0.15 2.90 1.60 1.90(TYP) 2.80 −−− 5° MAX 1.30 0.10 0.90 0.50 0.25 3.10 1.80 3.00 −−− 9° MIN 0.039 0.00 0.027 0.014 0.004 0.106 0.055 NOM 0.043 −−− 0.031 0.016 0.006 0.114 0.063 0.075(TYP) 0.102 0.110 0.015 −−− 1° 5° MAX 0.051 0.004 0.035 0.020 0.010 0.122 0.071 0.118 −−− 9° NOTES: 1. Package body sizes exclude mold flash and gate burrs. 2. Dimension L is measured in gage plane 3. Coplanarity: 0.1000 mm 4. Tolerance + 0.1000 mm (4 mil) unless otherwise specified. Figure 3: Package Outline Data Sheet - Rev 2.1 08/2001 5 AWS5506 NOTES 6 Data Sheet - Rev 2.1 08/2001 AWS5506 NOTES Data Sheet - Rev 2.1 08/2001 7 AWS5506 ORDERING INFORMATION ORDER NUMBER AWS5506S14 PACKAGE DESCRIPTION S14 COMPONENT PACKAGING 6 Pin Plastic Package ANADIGICS, Inc. 35 Technology Drive Warren, New Jersey 07059 Tel: (908) 668-5000 Fax: (908) 668-5132 http://www.anadigics.com Mktg@anadigics.com IMPORTANT NOTICE ANADIGICS, Inc. reserves the right to make changes to its products or to discontinue any product at any time without notice. The product specifications contained in Advanced Product Information sheets and Preliminary Data Sheets are subject to change prior to a product’s formal introduction. Information in Data Sheets have been carefully checked and are assumed to be reliable; however, ANADIGICS assumes no responsibilities for inaccuracies. ANADIGICS strongly urges customers to verify that the information they are using is current before placing orders. WARNING ANADIGICS products are not intended for use in life support appliances, devices, or systems. Use of an ANADIGICS product in any such application without written consent is prohibited. 8 Data Sheet - Rev 2.1 08/2001