U6803B

Features • • • • • • Three Input Comparators with Schmitt-trigger Characteristic Input Clamping Current Capability of ±10 mA Integrated Protection Cells (EMC, ESD, RF) Dedicated to all Input Stages Common Shutdown by Junction-temperature Monitor Reset with Hysteresis at Low Voltage ESD Protection Acording to Human Body Model: ±2000 V (C = 100 pF, R = 1.5 kΩ) • Output Stages: – Short-circuit Protected – Load-dump Protected at 1 kΩ – No Crosstalk on Adjacent Channels – Jump Start Possible Triple Driver IC with Thermal Monitoring U6803B Description The triple driver IC includes three non-inverted and current-limited output stages with an open collector. Common thermal shutdown protects the outputs against critical junction temperatures. Each output can sink a current of 20 mA, parallel output operation is possible. The digital inputs have Schmitt-trigger function with pull-up resistors to 5 V. Figure 1. Block Diagram VO1 1 3 VO2 VO3 4 VS 7 Thermal shutdown 2 GND Undervoltage detection VS = 5 V 8 VI1 6 VI2 5 VI3 VS Rev. 4762A–AUTO–11/03 Pin Configuration Figure 2. Pinning SO8 VO1 1 8 VI1 GND 2 7 VS VO2 3 6 VI2 VO3 4 5 VI3 Pin Description Pin 1 2 3 4 5 6 7 8 Symbol VO1 GND VO2 VO3 VI3 VI2 VS VI1 Function Output 1 Ground Output 2 Output 3 Input 3 Input 2 Supply voltage 5 V Input 1 2 U6803B 4762A–AUTO–11/03 U6803B Basic Circuitry The integrated circuit U6803B requires a stabilized supply voltage (VS = 5 V ±5%) to comply with its electrical characteristics. An external buffer capacitor of C = 100 nF is recommended. An integrated 14 V Zener diode between VS and ground protects the supply pin. All input stages are provided with an integrated 250 k W pull-up resistor and can be directly connected to a microcontroller. All output stages are open collectors, each capable of sinking 20 mA. Recommended external components: • • Pull-up resistor, R = 1 kW Capacitor to GND, C = 470 pF, see Figure 3 on page 4 Functional Description General ON state: A low level at the input stage activates the corresponding output stage. OFF state: The internal pull-up resistor provides a high level to the input comparator and deactivates the output stage. 7 V Zener diodes between each input pin and GND are capable of ±10 mA clamping currents without crosstalk on adjacent input stages. A total clamping current of ±30 mA should be observed with respect to the power dissipation. Current Limitation of the Output Stages and Overtemperature Shutdown Transients and Load Dump A temperature-dependent current limitation in the range of 25 to 100 mA protects the stages in case of a short. Additionally, the chip temperature is monitored. For TChip > 148°C, all outputs are disabled and automatically enabled with a hysteresis of TChip > 5°C. An integrated 28 V Zener diode protects each output stage against transients and loaddump (Schaffner pulses). With the help of an external 1 kW resistor, the output transistor is capable of handling the corresponding current which flows during each of these conditions. Apart from that, the outputs are short-circuit and overload protected. When the supply voltage is switched on, a power-on reset pulse is generated internally which disables all output stages until a defined supply-voltage level is reached. The low-voltage detection is provided with a hysteresis of Vhyst = 0.5 V typically. Low-voltage Detection 3 4762A–AUTO–11/03 Figure 3. Application Schematic VS = 5 V VBatt Load 100 nF VI1 Microcontroller VI2 VI3 VO1 R R R 3 × 1 kΩ U6803B VO2 VO3 C C C 3 × 470 pF Absolute Maximum Ratings Stresses beyond those listed under “Absolute Maximum Ratings” may cause permanent damage to the device. This is a stress rating only and functional operation of the device at these or any other conditions beyond those indicated in the operational sections of this specification is not implied. Exposure to absolute maximum rating conditions for extended periods may affect device reliability. Parameters Supply voltage Ambient temperature range Storage temperature range Maximum junction temperature Symbol VS Tamb Tstg Tj Value 7.0 -40 to +125 -50 to +150 +150 Unit V °C °C °C Thermal Resistance Parameters Junction ambient Symbol RthJA Value 160 Unit K/W 4 U6803B 4762A–AUTO–11/03 U6803B Electrical Characteristics VS = 5 V ±5%, Tamb = 27°C, reference point pin 2 (GND), unless otherwise specified, see Figure 1 on page 1 and Figure 3 on page 4 Parameters Supply, Pin 7 Supply voltage Supply current Low-voltage detection threshold Low-voltage hysteresis Temperature shutdown Temperature shutdown hysteresis Input; Pins 5, 6, 8 Zener-diode protection voltage Zener-diode clamping current Pull-up resistor Switching threshold Hysteresis Output; Pins 1, 3, 4 Zener-diode protection voltage Integrated capacitor Leakage current Saturation voltage Current limitation Propagation delay (470 pF, 1 kW, 20 V) (IO = 20 mA) ILeak VSat Ilimit td 25 IO = 10 mA VO 26.5 5 2.5 0.7 100 5 V pF µA V mA µs OFF ON II = 10 mA VI II RI VI VI Vhyst 170 250 3.3 1.8 1.5 6.7 8.5 ±10 305 V mA kW V V V Inputs open Inputs closed to GND ON OFF VS IS IS VTH(ON) VTH(OFF) Vhyst TChip Thyst 4.75 0.8 7 3.7 3.0 0.55 140 5 5.25 3.2 13 4.6 3.8 1.05 149 V mA mA V V V °C °C Test Conditions Symbol Min. Typ. Max. Unit 5 4762A–AUTO–11/03 Ordering Information Extended Type Number U6803B-MFP U6803B-MFPG3 Package SO8 SO8 Remarks Tube Taped and reeled Package Information Package SO8 Dimensions in mm 5.00 4.85 1.4 0.4 1.27 3.81 8 5 0.25 0.10 0.2 3.8 6.15 5.85 5.2 4.8 3.7 technical drawings according to DIN specifications 1 4 6 U6803B 4762A–AUTO–11/03 Atmel Corporation 2325 Orchard Parkway San Jose, CA 95131, USA Tel: 1(408) 441-0311 Fax: 1(408) 487-2600 Atmel Operations Memory 2325 Orchard Parkway San Jose, CA 95131, USA Tel: 1(408) 441-0311 Fax: 1(408) 436-4314 RF/Automotive Theresienstrasse 2 Postfach 3535 74025 Heilbronn, Germany Tel: (49) 71-31-67-0 Fax: (49) 71-31-67-2340 1150 East Cheyenne Mtn. Blvd. Colorado Springs, CO 80906, USA Tel: 1(719) 576-3300 Fax: 1(719) 540-1759 Regional Headquarters Europe Atmel Sarl Route des Arsenaux 41 Case Postale 80 CH-1705 Fribourg Switzerland Tel: (41) 26-426-5555 Fax: (41) 26-426-5500 Microcontrollers 2325 Orchard Parkway San Jose, CA 95131, USA Tel: 1(408) 441-0311 Fax: 1(408) 436-4314 La Chantrerie BP 70602 44306 Nantes Cedex 3, France Tel: (33) 2-40-18-18-18 Fax: (33) 2-40-18-19-60 Biometrics/Imaging/Hi-Rel MPU/ High Speed Converters/RF Datacom Avenue de Rochepleine BP 123 38521 Saint-Egreve Cedex, France Tel: (33) 4-76-58-30-00 Fax: (33) 4-76-58-34-80 Asia Room 1219 Chinachem Golden Plaza 77 Mody Road Tsimshatsui East Kowloon Hong Kong Tel: (852) 2721-9778 Fax: (852) 2722-1369 ASIC/ASSP/Smart Cards Zone Industrielle 13106 Rousset Cedex, France Tel: (33) 4-42-53-60-00 Fax: (33) 4-42-53-60-01 1150 East Cheyenne Mtn. Blvd. Colorado Springs, CO 80906, USA Tel: 1(719) 576-3300 Fax: 1(719) 540-1759 Scottish Enterprise Technology Park Maxwell Building East Kilbride G75 0QR, Scotland Tel: (44) 1355-803-000 Fax: (44) 1355-242-743 Japan 9F, Tonetsu Shinkawa Bldg. 1-24-8 Shinkawa Chuo-ku, Tokyo 104-0033 Japan Tel: (81) 3-3523-3551 Fax: (81) 3-3523-7581 Literature Requests www.atmel.com/literature Disclaimer: A tmel Corporation makes no warranty for the use of its products, other than those expressly contained in the Company’s standard warranty which is detailed in Atmel’s Terms and Conditions located on the Company’s web site. The Company assumes no responsibility for any errors which may appear in this document, reserves the right to change devices or specifications detailed herein at any time without notice, and does not make any commitment to update the information contained herein. No licenses to patents or other intellectual property of Atmel are granted by the Company in connection with the sale of Atmel products, expressly or by implication. Atmel’s products are not authorized for use as critical components in life support devices or systems. © Atmel Corporation 2003 . A ll rights reserved. A tmel ® a nd combinations thereof are the registered trademarks of Atmel Corporation or its subsidiaries. Other terms and product names may be the trademarks of others. Printed on recycled paper. 4762A–AUTO–11/03