PI49FCT3807HEX

PI49FCT3807 3.3V Fast CMOS Clock Driver Features Description • • • • • • • 3.3V version of PI49FCT807 Ultra low skew: 0.35ns Low Input Capacitance Minimum duty cycle distortion 1:10 fanout High speed: 3.5ns propogation TTL input and CMOS output compatible – VOH =3.3V (typical) – VOL =0.3V (typical) • Industrial Temperature: –40°C to +85°C • 3.3V ±10% operation • Packaging (Pb-free & Green Available): – 20-pin 300-mil wide SOIC (S) – 20-pin 150-mil wide QSOP (Q) – 20-pin 209-mil wide SSOP (H) Pericom Semiconductor’s PI49FCT3807 is a 3.3V 1-to-10 clock driver. This low skew clock driver features one input and ten outputs fanout. The large fanout from a single input line reduced loading on input clock. TTL level outputs reduce noise levels on the part. Typical applications are clock and signal distributon Block Diagram Pin Configuration A GND B0 VCC B1 GND B2 VCC B3 GND B0 B1 B2 B3 B4 A B5 1 2 3 4 5 6 7 8 9 10 20 19 18 17 16 15 14 13 12 11 VCC B9 B8 GND B7 VCC B6 GND B5 B4 B6 Pin Description B7 Pin Name A B0-B9 GND VCC B8 B9 09-0005 1 Description Input Outputs Ground Power PS7010F 11/16/09 PI49FCT3807 3.3V Fast CMOS Clock Driver Maximum Ratings (Above which the useful life may be impaired. For user guidelines, not tested.) Storage Temperature ............................................................ –65°C to +150°C Ambient Temperature with Power Applied ........................... –40°C to +85°C Supply Voltage to Ground Potential (Inputs & VCC Only) .....–0.5V to +7.0V Supply Voltage to Ground Potential (Outputs & D/O Only) ..–0.5V to +7.0V DC Input Voltage ....................................................................–0.5V to +7.0V DC Output Current............................................................................... 120mA Note: Stresses greater than those listed under MAXIMUM RATINGS may cause permanent damage to the device. This is a stress rating only and functional operation of the device at these or any other conditions above those indicated in the operational sections of this specification is not implied. Exposure to absolute maximum rating conditions for extended periods may affect reliability. Power Dissipation ................................................................................... 0.5W DC Electrical Characteristics (TA = –40°C to +85°c VCC = 3.3V ±0.3V) Symbol Test Condition(1) Parameter Min. Typ. Max. Units 0.2 0.4 0.5 V VOH Output High Voltage VCC = Min., VIN = VIL or VIH IOH = -0.1mA VCC - 0.2 IOH = -8mA 2.4 – 3.0 VOL Output Low Voltage VCC = Min., VIN = VIL or VIH IOH = 0.1mA IOH = 16mA IOH = 24mA – 0.2 0.3 VIH Input High Voltage Guaranteed Logic HIGH Level (Input pins) 2.0 5.5 VIL Input Low Voltage Guaranteed Logic LOW Level (Input pins) -0.5 0.8 IIH Input High Current VCC = Max. VIN = VCC 1 IIL Input Low Current VCC = Max. VIN = GND -1 VIK Clamp Diode Voltage VCC = Min., IIN = -18mA IOH IOL -1.2 -35 -60 -110 VOUT = 1.5V, VIN =VIL or VIH, VCC = 3.3V 50 90 200 VCC = Max., VOUT = GND -60 -135 -240 VOUT = 1.5V, VIN =VIL or VIH, VCC = 3.3V LOW Current(4,5) Output HIGH Output -0.7 Current(4,5) Circuit Current(4,5) IOS Short VH Input Hysteresis 150 μA V mA mV Notes: 1. For Max. or Min. conditions, use appropriate value specified under Electrical Characteristics for the applicable device type. 2. Typical values are at VCC = 3.3V, +25°C ambient and maximum loading. 3. VOH = VCC – 0.6V at rated current. 4. This parameter is determined by device characterization but is not production tested. 5. Not more than one output should be shorted at one time. Duration of the test should not exceed one second. 09-0005 2 PS7010F 11/16/09 PI49FCT3807 3.3V Fast CMOS Clock Driver Power Supply Characteristics Parameters Test Conditions(1) Description ICC Quiescent Power Supply Current Min. Typ(2) Max. 3 30 VCC = Max. VIN = GND or VCC — ΔICC Supply Current per Inputs @ TTL HIGH VCC = Max. VIN = VCC 0.6V(3) — ICCD Supply Current per Input per MHz(4) VCC = Max., Outputs Open Per Output Toggling 50% Duty Cycle VIN = VCC VIN = GND — Units μA 2.0 300 mA/ MHz Notes: 1. For Max. or Min. conditions, use appropriate value specified under Electrical Characteristics for the applicable device. 2. Typical values are at VCC = 3.3V, +25°C ambient. 3. Per TTL driven input (VIN = VCC – 0.6V); all other inputs at VCC or GND. 4. This parameter is not directly testable, but is derived for use in Total Power Supply Calculations. 5. Values for these conditions are examples of the IC formula. These limits are guaranteed but not tested. Capacitance (TA = 25°C, f = 1 MHz) Parameters(1) Description CIN Input Capacitance COUT Output Capacitance Test Conditions Typ Max. VIN = 0V 4.5 6.0 VOUT = 0V 5.5 8.0 Units pF Notes: 1. This parameter is determined by device characterization but is not production tested. Maximum Switching Characteristics (Over operating range) Symbol Description tPLH tPHL Propagation Delay A to BN tSK(O) Skew between two outputs of same package(3) tSK(P) Skew between opposite transitions of the same output (tPHL - tPHL)(3) FIN Skew between outputs of different packages at the same power supply, temp. and speed grade(3) Test Conditions 3807 3087A 3087B 3807C Com. Com. Com. Com. Min. Max. Min. Max. Min. Max. Min. Max. 1.5 CL = 15pF RL = 500Ω 4.5 1.5 4.0 1.5 3.8 1.5 Units 3.5 0.5 0.5 0.5 0.5 0.5 0.5 0.35 0.35 1.0 1.0 0.75 0.75 ns Notes: 1. Other loading condition is described on page 4, “Test Circuits for All Outputs.” 2. These parameters are guaranteed by design. 3. Minimum propagation delay of 1.5ns is guaranteed by design. 09-0005 3 PS7010F 11/16/09 PI49FCT3807 3.3V Fast CMOS Clock Driver Phase Jitter Measurement Data Frequency Band 12kHz-10MHz 12kHz-20MHz Input 342 493 Output 483 642 Additive Jitter 341 411 Tests Circuits for All Outputs Switch Position Test Disable LOW Enable LOW Disable HIGH Enable HIGH All Other Inputs VCC Pulse Generator f = 125MHz D.U.T. 50Ω 09-0005 Unit fsRMS fsRMS Switch 6V GND Open CL 15pF 4 PS7010F 11/16/09 PI49FCT3807 3.3V Fast CMOS Clock Driver Switching Waveforms Propagation Delay Pulse Skew – tSK(p) 3V Input 3V 1.5V tPLH tPHL Input VOH Output 0.5V tF 0V VOH 1.5V tR tPHL tPLH 2.0V Output 1.5V 0V 1.5V VOL VOL tSK(p) = | tPHL – tPLH | Output Skew – tSK(o) Package Skew – tSK(t) 3V Input 3V 1.5V tPLHx Input 0V tPHLx tPLH1 VOH Ox 1.5V tSK(o) tSK(o) 1.5V VOH Package 1 Output VOL 1.5V tSK(t) VOH Oy tPHLy VOL VOL VOH 1.5V tPLH2 tSK(o) = | tPLHy – tPLHx | or | tPHLy – tPHLx | 09-0005 tSK(t) Package 2 Output 1.5V tPLHy 0V tPHL1 tPHL2 VOL tSK(t) = | tPLH2 – tPLH1 | or | tPHL2 – tPHL1 | 5 PS7010F 11/16/09 PI49FCT3807 3.3V Fast CMOS Clock Driver 1 DATE: 04/10/08 DESCRIPTION: 20-Pin, 209-Mil Wide, SSOP PACKAGE CODE: H20 REVISION: E DOCUMENT CONTROL #: PD-1240 08-0140 DOCUMENT CONTROL NO. PD - 1202 20 REVISION: H .008 0.20 MIN. .150 .157 3.81 3.99 DATE: 10/22/07 .008 .013 0.20 0.33 Guage Plane .010 0.254 1 Detail A .337 8.56 .344 8.74 .058 REF 1.47 .041 1.04 REF .015 x 45˚ 0.38 .053 1.35 .069 1.75 Detail A 1 .007 .010 SEATING PLANE .025 BSC 0.635 0˚-6˚ .016 .035 0.41 0.89 .008 0.203 .012 0.305 .004 0.101 .010 0.254 0.178 0.254 .228 .244 5.79 6.19 X.XX DENOTES DIMENSIONS X.XX IN MILLIMETERS Pericom Semiconductor Corporation 3545 N. 1st Street, San Jose, CA 95134 1-800-435-2335 • www.pericom.com Note: 1) Controlling dimensions in inches. 2) Ref: JEDEC MO-137B/AD 3) Dimensions do not include mold flash, protrusions or gate burrs DESCRIPTION: 20-Pin, 150-Mil Wide, QSOP PACKAGE CODE: Q 09-0005 6 PS7010F 11/16/09 PI49FCT3807 3.3V Fast CMOS Clock Driver $/#5-%.4#/.42/,./ 0$   2%6)3)/.$ $!4%        Xƒ        2%&             3%!4).' 0,!.%  "3#     ƒ             888 $%./4%3#/.42/,,).' 888 $)-%.3)/.3).-),,)-%4%23 Pericom Semiconductor Corporation 3545 N. 1st Street, San Jose, CA 95134 1-800-435-2335 • www.pericom.com .OTES  #ONTROLLINGDIMENSIONSINMILLIMETERS  2EF*%$%#-3 $!# $%3#2)04)/. 0IN -IL7IDE3/)# 0!#+!'%#/$%3 Note: • For latest package info, please check: http://www.pericom.com/products/packaging/mechanicals.php 09-0005 7 PS7010F 11/16/09 PI49FCT3807 3.3V Fast CMOS Clock Driver Ordering Information Ordering Code Package Code Speed Grade Package Description PI49FCT3807AHEX H A Pb-free & Green, 20-pin 209-mil SSOP PI49FCT3807AQEX Q A Pb-free & Green, 20-pin 150-mil QSOP PI49FCT3807ASEX S A Pb-free & Green, 20-pin 300-mil SOIC PI49FCT3807BHEX H B Pb-free & Green, 20-pin 209-mil SSOP PI49FCT3807BQEX Q B Pb-free & Green, 20-pin 150-mil QSOP PI49FCT3807BSEX S B Pb-free & Green, 20-pin 300-mil SOIC PI49FCT3807CHEX H C Pb-free & Green, 20-pin 209-mil SSOP PI49FCT3807CQEX Q C Pb-free & Green, 20-pin 150-mil QSOP PI49FCT3807CSEX S C Pb-free & Green, 20-pin 300-mil SOIC PI49FCT3807DHEX H D Pb-free & Green, 20-pin 209-mil SSOP PI49FCT3807DQEX Q D Pb-free & Green, 20-pin 150-mil QSOP PI49FCT3807DSEX S D Pb-free & Green, 20-pin 300-mil SOIC PI49FCT3807HEX H Blank Pb-free & Green, 20-pin 209-mil SSOP PI49FCT3807QEX Q Blank Pb-free & Green, 20-pin 150-mil QSOP PI49FCT3807SEX S Blank Pb-free & Green, 20-pin 300-mil SOIC Notes: • Thermal characteristics can be found on the company web site at www.pericom.com/packaging/ • E = Pb-free and Green • Adding an X suffix = Tape/Reel Pericom Semiconductor Corporation • 1-800-435-2336 • www.pericom.com 09-0005 8 PS7010F 11/16/09