BCIF7

BeRex 50-800 MHz Internally Matched IF Amplifier Device Features • 40 dBm Output IP3 at 70MHz, 14dBm/tone • 27.0 dB Gain at 70MHz • 21.0 dBm P1dB at 70 MHz • Highly Reliable InGaP/GaAs HBT Technology • Patented over voltage protection circuit • Application: commercial wireless system Target Device Performance (Ta = 25°C) Symbols Parameters Test Conditions Gain 70MHz 140MHz 250MHz 500MHz 70MHz 140MHz 250MHz 500MHz 70MHz 140MHz 250MHz 500MHz 70MHz 140MHz 250MHz 500MHz 70MHz 140MHz 250MHz 500MHz Vc = 5.0V BCIF7 Min 26.0 25.8 25. 24.9 Typ 27.0 26.8 26.7 25.9 -30.8 -32.4 -29.4 -27.8 -12.5 -12.5 -11.6 -8.6 41.2 40.8 43.6 41.4 21.3 21.8 21.7 20.2 95 5.0 -0.003 50 Max Unit dB S11 dB S22 dB OIP3 P1dB Ic Vc dG/dT Rth 39.2 38.5 41.6 39.4 20.3 20.8 20.7 19.2 85 dBm dBm 105 mA V °C °C/W Thermal Resistance Test conditions unless otherwise noted. 1. Device performance is measured on BeRex evaluation board at 25°C, 50 ohm system. 2. OIP3 is measured on an eval-board with two tones separated by 1 MHz. Absolute Maximum Ratings Parameter Operating Case temperature Storage Temperature Supply Voltage Max. Device Current Input RF Power Rating -40 to +85°C -40 to +155°C 6.0V 160mA 23dBm Operation of this device above any of these parameters may result in permanent damage. http: //www.berex.com BeRex BCIF7 S-parameter test circuit Chip attachment on PF083 31mil thick FR4 PCB Generic PF083 Evaluation Board I-V Characteristics Application Circuit: 50-800 MHz Typical Performance (Vdevice = 5V, Ic = 95 mA, Ta = 25°C) Freq S21 S11 S22 P1 OIP3 MHz dB dB dB dBm dBm 70 27.0 -30.8 -12.5 21.3 41.2 140 26.8 -32.4 -12.5 21.8 40.8 250 26.7 -29.4 -11.6 21.7 43.6 500 25.9 -27.8 -8.64 20.2 41.4 http: //www.berex.com BeRex Schematic Diagram C1 C2 C3 BOM 100nF *100pF 100nF *100pF 100pF BCIF7 Tolerance ± 5% ± 5% ± 5% ± 5% ± 20% ±5% C4 1000pF C5 L1 *Application for RF Bandwidth 10uF 1uH *12nH Typical Device Data S-parameters (Vc=5V, Ic=95mA, T=25°C) IF Bandwidth Application http: //www.berex.com BeRex S-parameters (Vc=5V, Ic=95mA, T=25°C) BCIF7 RF Bandwidth Application Device Performance P1dB-Gain P1 Gain http: //www.berex.com BeRex OIP3 BCIF7 S-Parameter IF Bandwidth Application (Vc=5V, Ic=95mA, T=25°C) Freq [MHz] 50 150 250 350 450 550 650 750 850 S11 [dB] -28.586 -32.368 -29.436 -30.806 -28025 -27.358 -26.156 -28.741 -28.388 S11 [Ang] -106.642 153.226 103.952 74.122 57.612 39.511 34.536 16.783 26.499 S21 [dB] 27.021 26.801 26.672 26.319 26.102 25.497 25.184 24.699 23.915 S21 [Ang] 176.006 156.233 135.931 119.315 102.363 850.096 69.233 56.366 36.370 S12 [dB] -32.384 -31.914 -32.394 -30.952 -31.721 -31.882 -31.562 -30.987 -30.922 S12 [Ang] 2.863 -7.256 -13.069 -23.766 -36.896 -41.929 -51.528 -55.955 -65.779 S22 [dB] -12.028 -12.467 -11.622 -10.324 -9.144 -8.246 -7.420 -6.775 -6.329 S22 [Ang] 22.476 -21.072 -41.718 -58.0256 -72.792 -.58.005 -94.494 102.541 -113.462 * Note : S-parameter includes 1 mil thick and 16-mil long Au wire http: //www.berex.com BeRex RF Bandwidth Application (Vc=5V, Ic=95mA, T=25°C) Freq [MHz] 500 600 700 800 900 1000 1100 1200 1300 1400 1500 S11 [dB] -9.933 -11.592 -12.970 -13.821 -14.577 -15.849 -16.947 -18.847 -19.853 -20.891 -22.903 S11 [Ang] -62.036 -69.083 -75.467 -81.199 -89.643 -105.713 -116.273 -127.822 -145.186 -168.828 162.772 S21 [dB] 26.655 27.012 26.862 26.486 26.003 25.350 25.174 24.486 23.909 23.719 23.175 S21 [Ang] 140.862 114.561 90.690 70.988 51.737 31.493 17.566 3.151 -13.503 -27.530 -42.466 S12 [dB] -32.054 -30.891 -30.452 -31.196 -30.634 -29.676 -29.279 -29.542 -29.542 -28.848 -28.517 S12 [Ang] 5.690 -10.142 -21.447 -39.664 -47.501 -65.002 -73.650 -89.241 -89.241 -96.767 -107.766 S22 [dB] -6.741 -10.421 -14.326 -16.186 -14.438 -11.274 -9.931 -8.173 -8.173 -7.982 -7.466 BCIF7 S22 [Ang] 95.975 66.190 28.112 -31.310 -74.036 -101.616 -115.456 -139.546 -139.546 -149.506 -156.464 * Note : S-parameter includes 1 mil thick and 16-mil long Au wire Die Outline NOTES: 1) DIE THICKNESS 100um 2) BONDPAD METAL THICKNESS 2.8um 3) BACKSIDE METAL Au, 5um 4) DEVICE IS GROUNDED THROUGH VIA HOLES http: //www.berex.com BeRex ESD Rating ESD Rating Value Test Standard Class 1C Passes