ATM2400C-J57

Data Sheet 2.5Gb/s APD preamp Mini-DIL receiver ATM2400C This product is a high sensitivity optical receiver optimized for OC-48 optical transport systems. The high sensitivity performance given by the avalanche photodiode (APD) and preamp make the product ideal for maximizing unamplified transmission distances. The receiver supports FEC data rates up to 2.7Gb/s. The DC component cancellation function offered by the preamp allows the product to operate error free under high input power conditions. The receiver contains an APD, a low noise preamplifier, a precision thermistor and a single-mode connectorized fiber pigtail, all housed in an industry-standard Mini-DIL package. Features: • High sensitivity, -34dBm typical • Better than 0dBm overload • Industry-standard Mini-DIL package footprint • Differential data outputs • -40°C to +85°C maximum operating temperature range • RoHS 5/6 compliant Applications: • OC-48 Optical transport Systems • OC-48 DWDM Metro and Long Haul Systems • STM-16 SDH or OC-48 SONET Systems 1 Data Sheet Operating characteristics All parameters are measured with outputs 50 Ohm AC coupled, specified at a case temperature of 25°C unless otherwise stated. Optical wavelength between 1525-1575nm. Data to 1610nm available on request. Parameter APD breakdown voltage APD temperature coefficient of breakdown voltage Differential Transimpedance gain Bandwidth[1] Lower cut-off frequency[1] APD sensitivity over temperature Symbol Vbr TVbr ZT S21 S21 Iph = 40µA mean -3dB from 100MHz -3dB from 100MHz PRBS, 2.5Gb/s, 2 extinction ratio = 15dB BER < 1x10-10 -5°C to +70°C case 2.5Gb/s, 223-1 PRBS extinction ratio = 15dB BER < 1x10-10 25°C case Psat 2.5Gb/s, 223-1 PRBS, extinction ratio 15dB 1x10-10 BER, M=3 -5°C to +70°C case Peak-to-peak differential -3 23-1 Measurement Conditions Id=10µA Min 50 0.09 2.8 1.7 Typ Max 65 Unit V V/°C kΩ GHz 0.1 3.5 2.0 0.12 4.5 50 -32 -33.5 kHz dBm APD sensitivity -34 dBm APD overload over temperature +1 dBm Output voltage swing at overload Optical return loss Power supply current Power supply voltage Output return loss up to 1.8GHz Output return loss up to 3.0GHz Thermistor resistance Note: [1] Pin = 30dBm, M = 10. VOUT ORL ICC VCC S22 S22 RTH 220 30 280 400 mV dB 28 3.0 10 5 Beta constant = 3950 10 3.3 45 3.6 mA V dB dB kΩ 2 Data Sheet Absolute Maximum Ratings Parameter Operating case temperature Storage temperature Optical input power Power supply voltage APD supply voltage[1] Fiber bend radius Lead soldering time at 260°C -0.5 0 20 10 Symbol Top Tstg Min -40 -40 Max +85 +85 +1 6.0 Vbr Unit °C °C dBm V V mm s Note: [1] APD bias requirements vary from device to device. APD breakdown voltage and bias data, relative to a thermistor resistance of 10kΩ will be supplied with each device. Class 1 ESD precautions must be observed when handling these devices. Outline Drawing Gull-wing formed leads 3 Data Sheet Pin Out Pin # 1 2 3 4 5 6 7 8 Symbol VAPD GND OUT_P GND RTH OUT_N GND VCC Description APD supply voltage (+ve) Case ground Data out +ve Case ground Thermistor Data out -ve Case ground Power supply (+ve) Schematic Diagram 4 Data Sheet RoHS Compliance Bookham is fully committed to environment protection and sustainable development and has set in place a comprehensive program for removing polluting and hazardous substances from all of its products. The relevant evidence of RoHS compliance is held as part of our controlled documentation for each of our compliant products. RoHS compliance parts are available to order, please refer to the ordering information section for further details. Ordering Information: ATM2400C - (Connector) J28 = SC/PC J57 = LC e.g. ATM2400C-J28 is a 3.3 volt 2.5Gb/s APD preamp Mini-DIL receiver with gull-wing-formed leads and an SC/PC connector. Other options available on request. Contact Information North America Bookham Worldwide Headquarters 2584 Junction Ave. San Jose CA 95134 USA • Tel: +1 408 919 1500 • Fax: +1 408 919 6083 Europe Paignton Office Brixham Road Paignton Devon TQ4 7BE United Kingdom • Tel: +44 (0) 1803 66 2000 • Fax: +44 (0) 1803 66 2801 Asia Shenzhen Office 2 Phoenix Road Futian Free Trade Zone Shenzhen 518038 China • Tel: +86 755 33305888 • Fax: +86 755 33305805 +86 755 33305807 www.bookham.com sales@bookham.com Important Notice Performance figures, data and any illustrative material provided in this data sheet are typical and must be specifically confirmed in writing by Bookham before they become applicable to any particular order or contract. In accordance with the Bookham policy of continuous improvement specifications may change without notice. The publication of information in this data sheet does not imply freedom from patent or other protective rights of Bookham or others. Further details are available from any Bookham sales representative. 5 ISO14001:1996 EMS 504193 TL9000 Rev 3.0 (ISO9001:2000) FM15040 BH12849 Rev 1.0 January 2007. ©Bookham 2006. Bookham is a registered trademark of Bookham Inc.