WM8326GEFL00E/RV

w WM8326 Processor Power Management Subsystem DESCRIPTION FEATURES The WM8326 is an integrated power-management subsystem which provides a cost-effective, flexible, single-chip solution for power management. It is specifically targeted at the requirements of a range of low-power portable consumer products, but is suitable to any application with a multimedia processor. The WM8326 is designed to operate as a system PMIC supporting the ARM9™, ARM11™ and ARM Cortex-A™ processors, but is also capable of supporting the majority of application and mobile processors at the heart of a wide range of low-power consumer multimedia applications. Power Management The start-up behaviour and configuration is fully programmable in an integrated OTP non-volatile memory. This highly flexible solution helps reduce time-to-market, as changing application requirements can be very easily accommodated in the OTP. TM The InstantConfig interface enables an external EEPROM to configure the WM8326. The WM8326 power management subsystem comprises four programmable DC-DC converters and eleven LDO regulators (four of which are low-noise for supplying sensitive analogue subsystems). The integrated OTP bootstrap circuitry controls the start-up sequencing and voltages of the converters and regulators as well as the sequencing of system clocks. The DC-DC converters deliver high performance and high efficiency across a wide range of operating conditions. They are optimised to support the high load current transients seen in modern processor core domains. DC-DC3 / DC-DC4 can be connected together and operated in ‘dual’ mode to support an increased current load of up to 1.6A An on-chip regulator provides power for always-on PMIC functions such as register map and the RTC. The device provides autonomous backup battery switchover. A low-power LDO is included to support ‘Alive’ processor power domains external to the WM8326. A 12-bit Auxiliary ADC supports a wide range of applications for internal as well as external analogue sampling, such as voltage detection and temperature measurement. WM8326 includes a crystal oscillator and an internal RC oscillator to generate all clock signals for autonomous system start-up and processor clocking. A Secure Real-time Clock (SRTC) and alarm function is included, capable of waking up the system from low-power modes. A watchdog function is provided to ensure system integrity. To maximise battery life, highly-granular power management enables each function in the WM8326 subsystem to be independently powered down through a control interface or alternatively through register and OTP-configurable GPIOs. The device offers a standby power consumption of 2.7V 200 ILOAD =100mA, VOUT 1.8V to 2.7V 250 ILOAD =100mA, VOUT < 1.8V 400 Quiescent Current IQ Power Supply Rejection Ratio PSRR On Resistance (Switch mode) RDSON w VOUT Falling % %/V VOUT LOAD VOUT mA 0.1 Load Regulation Undervoltage level mV 88 % A Normal mode, no load 30 Low power mode, LDOn_LP_MODE=0, no load 10 Low power mode, LDOn_LP_MODE=1, no load 5 ILOAD = 1mA to 100mA IQ (no load) + 1% of load ILOAD = 50mA, = 1.71V mA % 0.025 %/V Load Regulation VOUT LOAD ILOAD =1mA to 200mA 0.003 %/mA Dropout Voltage VIN - VOUT ILOAD =100mA, VOUT =1.8V 95 mV ILOAD =100mA, VOUT =2.5V 65 ILOAD =100mA, VOUT =3.3V 60 Undervoltage level Quiescent Current VOUT IQ VOUT Falling 93 % Normal mode, no load 110 A Low Power mode, no load 70 ILOAD = 1mA to 200mA Power Supply Rejection Ratio PSRR Output noise voltage VOUT On Resistance (Switch mode) RDSON Current Limit (Switch mode) Start-up time Shutdown time IQ (no load) + 0.1% of load ILOAD = 100mA, = 1.71V MAX UNIT +2.5 % 0.025 %/V Load Regulation VOUT LOAD ILOAD =1mA to 150mA 0.004 %/mA Dropout Voltage VIN - VOUT ILOAD =100mA, VOUT =1.8V 135 mV ILOAD =100mA, VOUT =2.5V 100 ILOAD =100mA, VOUT =3.3V 90 Undervoltage level Quiescent Current Power Supply Rejection Ratio VOUT IQ VOUT Falling Normal mode, no load Output noise voltage VOUT On Resistance (Switch mode) RDSON 70 ILOAD = 1mA to 150mA IQ (no load) + 0.1% of load ILOAD = 75mA,