VSPLD63TE

THE CONNOR-WINFIELD CORP. 2111 COMPREHENSIVE DRIVE. AURORA, IL 60505. FAX (630) 851-5040. PHONE (630) 851-4722. WWW.CONWIN.COM PRODUCT D AT A SHEET CRYSTAL CONTROLLED OSCILLATORS 3.3V SURFACE MOUNT VCSO OSCILLATOR ABSOLUTE M AXIMUM RATING S PARAMETER Storage Temperature Supply Voltage Control Voltage (Vcc) (Vc) UNITS MINIMUM -55 -0.5 -0.5 NOMINAL M AXIMUM 125 7.0 7.0 UNITS °C Vdc Vdc TABLE 2.0 MINIMUM (Fo) NOMINAL 622.08 +/-150 3.3 -70 -105 -145 -155 M AXIMUM UNITS MHz ppm °C Vdc mA ps rms ps rms dBc/Hz dBc/Hz dBc/Hz dBc/Hz 1 NOTE TABLE 1.0 NOTE CW 0639 VSPLD63TE 622.08M VSPLD63TE DESCRIPTION OPERATING SPECIFIC ATIONS PARAMETER Center Frequency Frequency Stability Operating Temperature Range Supply Voltage Supply Current Jitter (BW=10Hz to 20MHz) Jitter (BW=12kHz to 80MHz) SSB Phase Noise at 100Hz offset SSB Phase Noise at 1KHz offset SSB Phase Noise at 10KHz offset SSB Phase Noise at 100KHz offset (Vcc) (Icc) -40 3.135 - 85 3.465 80 3.0 0.5 - The Connor-Winfield VSPLD63TE is a 3.3V Voltage Controlled SAW Oscillator (VCSO) with Differential LVPECL outputs and Enable/Disable function. The VSPLD63TE is designed for use with PLL systems in SONET/SDH systems requiring low jitter and wide pull range over the industrial temperature range. No multiplication schemes are used in this oscillator design. FEATURES VOLTAGE CONTROLLED SAW OSCILLATOR LOW PROFILE, SURFACE MOUNT PACKAGE 3.3V OPERATION INPUT CHARACTERISTICS PARAMETER Control Voltage Range Absolute Pull Range (APR) Gain Transfer (Kv) Monotonic Linearity Input Impedance Modulation Bandwidth (3dB) Enable Input Voltage (Low) Disable Input Voltage (High) (Vil) (Vih) (Vc) MINIMUM 0.3 +/-50 -15 10 2.275 NOMINAL 1.65 175 50K M AXIMUM 3.0 15 1.68 UNITS Vdc ppm ppm/volt % Ohm KHz Vdc Vdc TABLE 3.0 NOTE 2 - 3 3 TABLE 4.0 LOW JITTER