PK15-D5-D12

Additional Resources: Product Page rev. 1 of 4 date 06/2009 DESCRIPTION: dc-dc converter PART NUMBER: PK15 ue d features ·industry standard pin out ·wide 2:1 input range ·fully isolated ·low ripple & noise ·over-current protection ·output voltage variation (TRM) ·HI-POT tested ·constant switching frequency ·high efficiency ·compact size 1.8”x2.0”x0.375” ·3 year warranty output power (max) input voltage output voltage PK15-D5-S3.3 PK15-D5-S5 PK15-D5-S12 PK15-D5-S15 PK15-D5-D5 PK15-D5-D12 PK15-D5-D15 PK15-D12-S3.3 PK15-D12-S5 PK15-D12-S12 PK15-D12-S15 PK15-D12-D5 PK15-D12-D12 PK15-D12-D15 PK15-D24-S3.3 PK15-D24-S5 PK15-D24-S12 PK15-D24-S15 PK15-D24-D5 PK15-D24-D12 PK15-D24-D15 PK15-D48-S3.3 PK15-D48-S5 PK15-D48-S12 PK15-D48-S15 PK15-D48-D5 PK15-D48-D12 PK15-D48-D15 6.6W 10.0W 12.0W 12.0W 10.0W 12.0W 12.0W 7.92W 12.0W 14.4W 15.0W 15.0W 14.4W 15.0W 7.92W 12.0W 14.4W 15.0W 15.0W 14.4W 15.0W 7.92W 12.0W 14.4W 15.0W 15.0W 14.4W 15.0W 4.5-7.2VDC 4.5-7.2VDC 4.5-7.2VDC 4.5-7.2VDC 4.5-7.2VDC 4.5-7.2VDC 4.5-7.2VDC 8-16.5VDC 8-16.5VDC 8-16.5VDC 8-16.5VDC 8-16.5VDC 8-16.5VDC 8-16.5VDC 18-32VDC 18-32VDC 18-32VDC 18-32VDC 18-32VDC 18-32VDC 18-32VDC 32-63VDC 32-63VDC 32-63VDC 32-63VDC 32-63VDC 32-63VDC 32-63VDC 3.3VDC 5VDC 12VDC 15VDC ±5VDC ±12VDC ±15VDC 3.3VDC 5VDC 12VDC 15VDC ±5VDC ±12VDC ±15VDC 3.3VDC 5VDC 12VDC 15VDC ±5VDC ±12VDC ±15VDC 3.3VDC 5VDC 12VDC 15VDC ±5VDC ±12VDC ±15VDC output current (min) output current (max) 0A 0A 0A 0A 0A 0A 0A 0A 0A 0A 0A 0A 0A 0A 0A 0A 0A 0A 0A 0A 0A 0A 0A 0A 0A 0A 0A 0A 2.0A 2.0A 1.0A 0.8A 1.0A 0.5A 0.4A 2.4A 2.4A 1.2A 1.0A 1.5A 0.6A 0.5A 2.4A 2.4A 1.2A 1.0A 1.5A 0.6A 0.5A 2.4A 2.4A 1.2A 1.0A 1.5A 0.6A 0.5A is co nt in MODEL1 D page ripple & noise 2 mV P-P 50 50 120 150 120/120 150/150 150/150 50 50 120 150 120/120 150/150 150/150 50 50 120 150 120/120 150/150 150/150 50 50 120 150 120/120 150/150 150/150 NOTE: 1. All models (excluding the 5 V dc input, D5) are also available in an extended temperature range of -40°C~85°C. For these models, append “M” to the model number, e.g. PK15-D12-S3.3M. 2. Ripple & noise measured with a 20MHz bandwidth, off a 10uF electrolytic and a 0.1uF ceramic cap in parallel at the ouptut. 20050 SW 112th Ave. Tualatin, Oregon 97062 phone 503.612.2300 fax 503.612.2382 efficiency (typ.) 76% 78% 80% 80% 80% 80% 80% 83% 85% 88% 88% 85% 85% 85% 84% 85% 88% 87% 86% 86% 86% 78% 80% 83% 83% 83% 83% 83% Additional Resources: Product Page rev. page 2 of 4 date 06/2009 DESCRIPTION: dc-dc converter PART NUMBER: PK15 INPUT constant TTL compatible min 4.5 8 18 32 on: 0 to 1.2 VDC or short Vin-V off: 2.4 to 5.5 VDC or open OUTPUT parameter set point accuracy line regulation load regulation conditions/description 20 MHz bandwidth PROTECTION min -2% -0.5% -1.0% -2.5% 0.0 nt parameter conditions/description min over-current continuous auto recovery 3 105% over-voltage internally zener clamped 3 110% NOTE: 3 continuous operation in a protected state may compromise long-term reliability. GENERAL conditions/description typical at full load input/case, input/output, output/case at 500 VDC approved to UL1950, EN60950, CISPR22, CE MTBF operating temperature MIL-HDBK-217F regular models extended temperature models is co parameter efficiency dielectric withstand insulation resistance agency standards case material material flammability weight operating (non-condensing) not intended for aqueous wash max 7.2 16.5 32 63 units VDC VDC VDC VDC KHz min 76% 500 100M nom nom units 1.0% Vout max 135% 140% max 87% Amps mVpp units units VAC Ohms STS 94 V-0 55 (1.94) 520k -20 -40 -40 20% max +2% +0.5% +1.0% +2.5% grams (ounces) hours +71 °C +85 °C +105 °C 90% RH D storage temperature humidity washability nom in all models single output models dual output models (10% min. load) minimum load ripple and noise nom 5 12 24 48 300 d switching frequency (CNT) remote on / off conditions/description ue parameter input voltage range 20050 SW 112th Ave. Tualatin, Oregon 97062 phone 503.612.2300 fax 503.612.2382 Additional Resources: Product Page rev. page 3 of 4 date 06/2009 DESCRIPTION: dc-dc converter PART NUMBER: PK15 DIMENSIONS (mm) Pin Assignments All dimensions are in inches (mm). 2.0 (50.0) 1 OUT 5 2 6 3 7 0.19 (4.68) Label Outside edge CL 0.3 (7.62) 0.2 0.3 (5.08) (7.62) 0.2 (5.08) 0.19 (4.68) 7- 4 0.6 (15.24) nt 5 2 6 3 7 0.3 (7.62) 0.3 (7.62) 0.2 (5.08) 0.2 (5.08) 1.4 (35.56) TOP VIEW D is co 1.4 (35.56) 0.05(1.3) 1 CL 0.37 (9.5) 0.04 (1.0) +Vout C om -V out Trim in 4 4. 5. 6. 7. +Vout No pin -Vout Tri m ue 4. 5. 6. 7. 0.2 (5.08) 0.2 (5.08) d CL IN 1. +Vin 2. -Vin 3. CNT 1. +Vin 2. -Vin 3. CNT 1.8 (45.0) 0.6 (15.24) Dual Output Single Output 20050 SW 112th Ave. Tualatin, Oregon 97062 phone 503.612.2300 fax 503.612.2382 Additional Resources: Product Page rev. page 4 of 4 date 06/2009 DESCRIPTION: dc-dc converter PART NUMBER: PK15 APPLICATION NOTES 1. OUTPUT TRIMMING The output voltages are preset to nominal values as indicated by the models table at the factory. If desired, the output voltage may d optionally be trimmed to a different value (+/- 10%) with external resistors and/or potentiometer as shown below. +Vo FIGURE 1. TRIMMING WITH Trim EXTERNAL POTENTIOMETER -Vin -Vo 10KW Trimpot ue +Vin R load To trim the output voltage with fixed resistors, the output voltage can be calculated as follows. +Vo +Vin Trim R load -Vo nt R trim-up -Vin in +Vin -Vin +Vo R trim-down Trim R load -Vo Trim-Up Trim-Down FIGURE 2: TRIM-UP VOLTAGE SETUP FIGURE 3: TRIM-DOWN VOLTAGE SETUP co Rtrim_up = Vr · R1 · R2 R2 · (Vo - Vr) - Vr · R1 Rtrim_down = (Vo - Vr) · R1 · R2 Vr · R1 - (Vo - Vr) · R2 The value of R trim-up is defined as: The value of R trim-down is defined as: Where: R trim-up is the external resistor in K Ω . V o is the Where: R trim-down is the external resistor in K Ω . V o is the desired output voltage. R 1 and R 2 and V r are internal to desired output voltage. R 1 and R 2 and V r are internal to the unit and are defined in Table 1. For example to trim down the PK15-D5-D12 up by 5% to 25.2 V, R trim-up is calculated the PK15-D5-D12 down by 5% to 22.8 V, R trim-down is calculated as follows: as follows: is the unit and are defined in Table 1. For example to trim up D Vo = 25.2 / R1 = 21 KΩ / R2 = 2.43 KΩ / Vr = 2.5 Rtrim_up = 2.5 · 21 · 2.43 2.43 · (25.2 - 2.5) - 2.5 · 21 Table 1 = 47.94 KΩ Vo = 22.8 / R1 = 21 KΩ / R2 = 2.43 KΩ / Vr = 2.5 Rtrim_down = (22.8 - 2.5) · 21 · 2.43 2.5 - 2.1 (22.8 - 2.5) · 2.43 R1 (KΩ) R2 (KΩ) Vr (V) Model 0.24 1.25 PK15-DXX-S3.3 0.402 12.7 12.7 2.5 PK15-DXX-S5 PK15-DXX-S12 9.31 2.43 2.5 PK15-DXX-S15 12.7 2.49 2.5 PK15-DXX-D5 7.5 2.49 2.5 PK15-DXX-D12 21 2.43 2.5 PK15-DXX-D15 26.7 2.43 2.5 *PK15-D5-S3.3 0.787 2.43 2.5 *PK15-D48-S3.3 0.787 2.43 2.5 20050 SW 112th Ave. Tualatin, Oregon 97062 phone 503.612.2300 fax 503.612.2382 = 326.68 KΩ