MAX1232MJA/883B

SCOPE: MICROPROCESSOR MONITOR Device Type 01 01 Generic Number MAX1232MJA/883B MAX1232MLP/883B SMD Number 5962-9451401MPA 5962-9451401M2C Case Outline(s). The case outlines shall be designated in Mil-Std-1835 and as follows: Outline Letter MAXIM SMD JA P LP 2 Mil-Std-1835 GDIP1-T8 or CDIP2-T8 CQCC1-N20 Case Outline Package Code 8 LEAD CERDIP 20 Pin Ceramic LCC J8 L20 Absolute Maximum Ratings Supply Voltage to Ground (VCC to GND) ................................................... -0.3V to +6V Maximum Current to any Terminal ......................................................…............... 10mA __ ______ Input Voltage to ST, TOL, PB RST, TD .......................................... -0.3V to (VCC+0.3V) Lead Temperature (soldering, 10 seconds) ................................................................ +300°C Storage Temperature ..........................................................................…..... -65°C to +160°C Continuous Power Dissipation ...............................................................................TA=+70°C 8 lead CERDIP(derate 8.0mW/°C above +70°C) ..................................................... 640mW 20 lead LCC(derate 9.1mW/°C above +70°C) ......................................................... 727mW Junction Temperature TJ ....................................................................................…. +150°C Thermal Resistance, Junction to Case, ΘJC: Case Outline 8 lead CERDIP .................................................................... 55°C/W Case Outline 20 lead LCC ........................................................................ 20°C/W Thermal Resistance, Junction to Ambient, ΘJA: Case Outline 8 lead CERDIP .................................................................. 125°C/W Case Outline 20 lead LCC ...................................................................... 110°C/W Recommended Operating Conditions. Ambient Operating Range (TA) .............................................................. -55°C to +125°C Stresses beyond those listed under “Absolute Maximum Ratings” may cause permanent damage to the device. These are stress ratings only, and functional operation of the device at these or any other conditions beyond those indicated in the operational sections of the specifications is not implied. Exposure to absolute maximum rating conditions for extended periods may affect device reliability. ---------------------------- Electrical Characteristics of MAX1232M/883B for /883B and SMD 5962-94514 19-0109 Page 2 of Rev. B 6 TABLE 1 ELECTRICAL TESTS PARAMETER Symbol High Level Input Voltage, __ ______ ST and PBRST Low Level Input Voltage, __ ______ ST and PBRST Input Leakage Current TOL and __ ST pins High Output Current RST pin Low Output ___ Current RST and RST pins Operating Current VIH Supply Current, 5% trip-point Supply Current, 10% trip-point Pushbutton Reset Input Pushbutton Reset Delay Reset Active Time __ ST Pulse Width __ ST Timeout Period CONDITIONS -55 °C