6PH10

6PH SINGLE-PHASE FULL WAVE BRIDGE 6 AMPERES FOR P.C. BOARD AND HEAT SINK MOUNTING ponent der the com cognition un s, inc. dicates re This mark in derwriters Laboratorie of Un program PRV/Leg Type No. 50V 6PH05 100V 6PH10 200V 6PH20 400V 6PH40 600V 6PH60 800V 6PH80 1000V 6PH100 ELECTRICAL CHARACTERISTICS PER LEG (at TA =25 C Unless Otherwise Specified) Average Output Current, lo @ 65 C Tc (Fig.1) Max.Forward Voitage Drop,VF=1.0V @ IF = Max.DC Reverse Current @ PRV, and 25 C , IR Max.DC Reverse Current, @ PRV and 100 C , IR Max.Perk Surge Current, I FSM (8.3ms) (Fig.2) Ambient Operating Temperature Range,T A Storage Temperature Range,TSTG O 6 2.5 10 300 250 -55 to +150 -55 to +150 Amp Amp A A Amp o C o C Note 1: Derate IO by 20% for capacitive loads EDI reserves the right to change these specifications at any time without notice. 6PH FIG.1 CURRENT DERATING 6 65 O FIG.2 NON-REPETITIVE SURGE CURRENT 1000 500 FORWARD CURRENT(AMP) TC 5 TL 65 O 4 PC BOARD MOUNTING WITH 3/8" LEADS MAX.PEAK SURGE CURRENT IFSM HEAT SINK MOUNTING 200 100 3 2 BRIDGE OUTPUT RES.-IND. LOADS Derate current by 20% for capacitive loads 50 lO.AVERAGE L 1 20 10 0 0 25 50 75 O 100 125 150 1 2 5 10 20 50 100 TEMPERATURE ( C) NUMBER OF CYCLES AT 60 CPS FIG.3 CASE STYLE FOR 6PH .935 .895 .160 .140 .700 .660 .760Max. .280 .260 .185 .165 45 .085 .065 .075R.Typ. (2 Places) .455 .405 1.0Min. .260 .180 .205 .185 .220 .180 .052 .048 Dielectric test voltage 2,500 V rms., Max. 50-60Hz NOTE Maximum lead and terminal temperature for soldering, 3/8 inch from case, 5 seconds at 250 C ELECTRONIC DEVICES, INC. DESIGNERS AND MANUFACTURERS OF SOLID STATE DEVICES SINCE 1951. 21 GRAY OAKS AVENUE * YONKERS. NEW YORK 10710 914-965-4400 * FAX 914-965-5531 * 1-800-678-0828 E e-mail:sales@edidiodes.com W website: http://www.edidiodes.com *