RGP15M

TH97/10561QM TW00/17276EM IATF 0060636 SGS TH07/1033 RGP15A - RGP15M PRV : 50 - 1000 Volts Io : 1.5 Amperes FEATURES : * * * * * High reliability Low reverse current Low forward voltage drop Fast switching for high efficiency Pb / RoHS Free FAST RECOVERY RECTIFIER DO-15 0.140 (3.6) 0.104 (2.6) 1.00 (25.4) MIN. 0.300 (7.6) 0.230 (5.8) MECHANICAL DATA : * Case : DO-15 Molded plastic * Epoxy : UL94V-O rate flame retardant * Lead : Axial lead solderable per MIL-STD-202, Method 208 guaranteed * Polarity : Color band denotes cathode end * Mounting position : Any * Weight : 0.4 gram 0.034 (0.86) 0.028 (0.71) 1.00 (25.4) MIN. Dimensions in inches and ( millimeters ) MAXIMUM RATINGS AND ELECTRICAL CHARACTERISTICS Rating at 25 °C ambient temperature unless otherwise specified. Single phase, half wave, 60 Hz, resistive or inductive load. For capacitive load, derate current by 20%. RATING Maximum Recurrent Peak Reverse Voltage Maximum RMS Voltage Maximum DC Blocking Voltage Maximum Average Forward Current 0.375"(9.5mm) Lead Length Ta = 55 °C Peak Forward Surge Current, 8.3ms Single half sine wave Superimposed on rated load (JEDEC Method) Maximum Peak Forward Voltage at IF = 1.5 A Maximum DC Reverse Current at Rated DC Blocking Voltage Ta = 25 °C Ta = 150 °C SYMBOL VRRM VRMS VDC IF(AV) IFSM VF IR IR(H) Trr CJ RӨJA TJ TSTG RGP 15A 50 35 50 RGP 15B 100 70 100 RGP 15D 200 140 200 RGP 15G 400 280 400 1.5 50 1.3 5.0 200 RGP 15J 600 420 600 RGP 15K 800 560 800 RGP 15M 1000 700 1000 UNIT V V V A A V μA μA 250 500 ns pF Maximum Reverse Recovery Time ( Note 1 ) Typical Junction Capacitance ( Note 2 ) Typical Thermal Resistance ( Note 3 ) Junction Temperature Range Storage Temperature Range 150 25 30 °C/W °C °C - 65 to + 175 - 65 to + 175 Notes : ( 1 ) Reverse Recovery Test Conditions : IF = 0.5 A, IR = 1.0 A, Irr = 0.25 A. ( 2 ) Measured at 1.0 MHz and applied reverse voltage of 4.0 VDC ( 3 ) Thermal Resistance from Junction to Ambient at 0.375" (9.5mm) Lead Lengths, P.C. Board Mounted. Page 1 of 2 Rev. 03 : June 9, 2008 TH97/10561QM TW00/17276EM IATF 0060636 SGS TH07/1033 RATING AND CHARACTERISTIC CURVES ( RGP15A - RGP15M ) FIG.1 - REVERSE RECOVERY TIME CHARACTERISTIC AND TEST CIRCUIT DIAGRAM 50 Ω 10 Ω + 0.5 Trr + D.U.T. 50 Vdc (approx.) 1Ω PULSE GENERATOR ( NOTE 2 ) OSCILLOSCOPE ( NOTE 1 ) 0 - 0.25 - 1.0 A SET TIME BASE FOR 50/100 ns/cm NOTES : 1. Rise Time = 7 ns max., Input Impedance = 1 megaohm, 22 pF. 2. Rise time = 10 ns max., Source Impedance = 50 ohms. 3. All Resistors = Non-inductive Types. 1 cm FIG.2 - DERATING CURVE FOR OUTPUT RECTIFIED CURRENT AVERAGE FORWARD OUTPUT CURRENT, AMPERES 1.5 50 FIG.3 - MAXIMUM NON-REPETITIVE PEAK FORWARD SURGE CURRENT PEAK FORWARD SURGE CURRENT, AMPERES 1.2 40 0.9 T J = 25 ° C 0.6 30 20 8.3 ms SINGLE HALF SINE-WAVE (JEDEC) METHOD TJ = Tj max. 0.3 60Hz RESISTIVE OR INDUCTIVE LOAD 0.375" (9.5mm) LEAD LENGTHS 10 0 0 25 50 75 100 125 150 175 0 1 2 4 6 10 20 40 60 100 AMBIENT TEMPERATURE, ( °C) NUMBER OF CYCLES AT 60Hz FIG.4 - TYPICAL FORWARD CHARACTERISTICS 10 Pulse Width = 300 μs 2% Duty Cycle T J = 25 ° C 1.0 10 FIG.5 - TYPICAL REVERSE CHARACTERISTICS FORWARD CURRENT, AMPERES TJ = 100 °C REVERSE CURRENT , MICROAMPERES 1.0 0.1 0.1 T J = 25 ° C 0.01 0.01 0 0.2 0.4 0.6 0.8 1.0 1.2 1.4 1.6 1.8 2.0 0 20 40 60 80 100 120 140 FORWARD VOLTAGE, VOLTS PERCENT OF RATED REVERSE VOLTAGE, (%) Page 2 of 2 Rev. 03 : June 9, 2008