SIL15-12SADJ-V

SIL15 Series DC/DC CONVERTERS • • • • • • • • • • Single output 1 NEW Product 15A Non-Isolated DC/DC Converters Ultra-wide trim range (0.9V to 3.3V/5V) Current sink capable for termination applications Horizontal and vertical models available High power density design means reduced board space requirement Power good output signal (open collector) Operating ambient temperature up to +80ºC with suitable derating and forced air cooling Remote ON/OFF (active high) 0A minimum load Input undervoltage lockout Over-current and short-circuit protection The SIL15 Series is a new high density open frame non-isolated converter for spacesensitive applications. Each model has a wide input range (4.5V to 5.5V or 10.2V to 13.8V) and offer a wide 0.9V to 3.3V/5V output voltage range with a 15A load. An external resistor adjusts the output voltage from its pre-set value of 0.9V to any value up to the maximum allowed value for that model. Typical efficiencies are 89% for the 5V input version and 91% for the 12V input version. The SIL15 series offers remote ON/OFF and over-current protection as standard. With full international safety approval including EN60950 and UL/cUL60950, the SIL15 reduces compliance costs and time to market. All specifications are typical at nominal input, full load at 25°C unless otherwise stated 2 YEAR WARRANTY SPECIFICATIONS OUTPUT SPECIFICATIONS Voltage adjustability (See Note 5) 5V input models 12V input models 0.9V to 3.3V 0.9V to 5.0V ±2.5% ±0.2% max. INPUT SPECIFICATIONS Contd. Turn ON threshold Turn OFF threshold 5V input model 12V input model 5V input model 12V input model 4.5V 9.0V 4.3V 7.5V Output setpoint accuracy With 1.0% trim resistors Line regulation Load regulation Min/max load Overshoot (at turn on) Undershoot Ripple and noise 5Hz to 20MHz Transient response (See Note 2) (See Note 1) Deviation 5V input models 12V input models Low line to high line Full load to min. load GENERAL SPECIFICATIONS ±0.5% max. Efficiency 0A/15A Switching frequency 3% max. 1% max. 100mV max. See table 100mV 200µs recovery to within regulation band Approvals and standards (See Note 7) Material flammability Weight MTBF Representative model: Fixed 200kHz typ. TÜV Product Service IEC60950, UL/cUL60950 UL94V-0 14.2g (0.5oz) MIL-HDBK-217F 468,803 hours 12V model @ 40ºC 100% load, ground benign Bellcore 332 7,817,294 hours See table INPUT SPECIFICATIONS Input voltage range Input current Input current (max.) (See Note 3) Input reflected ripple (See Note 4) Remote ON/OFF Logic compatibility ON OFF Start-up time (See Note 9) Power up Remote ON/OFF 5V input model 12V input model Minimum load Remote OFF 5V input model 12V input model 5V input model 12V input model 4.5 to 5.5VDC 10.2 to 13.8VDC 65mA 20mA 11.5A @ Io max. 8.1A @ Io max. 200mA (pk-pk) 200mA (pk-pk) Active high >2.4VDC