LEDRS25N

LED Highly-Diffused Light (25 mm) Features • Designed to minimize surface textures and elevation changes, while providing uniform illumination over the field of view • 25 mm x 25 mm light aperture • Provides uniform lighting for specular surfaces • Black anodized aluminum housing • The suggested field of view is 12 mm x 12 mm and the suggested stand off is 25 mm LED Highly-Diffused Light Model Models Illumination Type Color Cable 0.5 m (18") terminated with 9-pin D-sub connector (male pins) Supply Voltage Supply Current Connections Pin 3 = dc common Pin 4 = +V LEDRS25N† Continuous highly-diffused light Red 640 nm 12V dc ±10% with voltage regulation of ±1% 420 mA max. Power supply model PSA-12(E) or PS2V-12(E) is recommended (see other side) † This model is not stocked and is non-returnable. Useful Life Environmental Rating Operating Conditions 60,000 hours IEC IP20; NEMA 1 Temperature: 0° to 40°C (+32° to 104°F) Maximum relative humidity: 95% at 40°C (non-condensing) 22.3 mm (0.88") 40.1 mm 25 mm (1.58") (0.98") Light Aperture 0.5 m (18") 25 mm (0.98") Light Aperture M6 x 1.0 Thru (2x) 61.3 mm (2.41") 25.4 mm (1.00") 115.3 mm (4.54") WARRANTY: Banner Engineering Corp. warrants its products to be free from defects for one year. Banner Engineering Corp. will repair or replace, free of charge, any product of its manufacture found to be defective at the time it is returned to the factory during the warranty period. This warranty does not cover damage or liability for the improper application of Banner products. This warranty is in lieu of any other warranty either expressed or implied. Printed in USA 05/01 P/N 67441 LED Highly-Diffused Light (25 mm) Accessories Continuous Power Supplies Models PSA-12 100-250V ac 50/60 Hz PSA-12E Input Input Cord North America (NEMA 5-15) Cont. Europe (Schuko CEE 7) Output 12V dc ±5% with voltage regulation of ±1% 3.5 A max. Output Cable 1.8 m (6') Terminated with 9-pin D-sub connector (female pins) Used with Continuous types: LEDRS25N Variable Power Supplies (see data sheet p/n 67449) Models PS2V-12† PS2V-12E† Input 100-140V ac 60 Hz 200-250V ac 50 Hz Input Cord North America (NEMA 5-15) Cont. Europe (Schuko CEE 7) Output 2-channels 6 - 12V dc 2 A max. per channel Output Cable 1.8 m (6') Terminated with 9-pin D-sub connector (female pins) Used with Continuous types: LEDRS25N Extension Cables Models DB906 DB910 DB9Y † † † Length 1.8 m (6') Configuration Used with Continuous types: LEDRS25N † Terminated both ends with 9-pin D-sub connector, for continuous lights 3.0 m (10') (one end male pins and opposite end female pins) 1.8 m (6') Y cable for powering 2 lights from one supply, for continuous lights These models are not stocked and are non-returnable. Banner Engineering Corp., 9714 Tenth Ave. No., Mpls., MN 55441 • Ph: 763.544.3164 • www.bannerengineering.com • Email: sensors@bannerengineering.com