PSA-12E

PSA-12 Power Supplies (12 Volt) Features • 12V dc power supply delivers up to 3.5 amps to power Banner 12V continuous LED lights • Choose model with 120V ac North American power cord, or with 220V ac Euro power cord • Includes pre-wired 9-pin D-sub connector for direct connection to LED lights • Tough ABS housing PSA-12 Models Models PSA-12 Input 100-250V ac 50/60 Hz 1.1 A max @ 100V ac Input Cord North America (NEMA 5-15) Cont. Europe (Schuko CEE 7) Output Output Cable Used with Connections Pin 1 = +V Pin 2 = dc common Pin 3 = dc common Pin 4 = +V Pin 5 = +V PSA-12E 1.8 m (6') 12V dc ±5% Terminated with with voltage 9-pin D-sub regulation of ±1% connector 3.5 A max. (female pins) Continuous LED lights Environmental Rating Operating Conditions IEC IP20; NEMA 1 Temperature: 0° to 50°C (+32° to 122°F) Maximum relative humidity: 95% at 40°C (non-condensing) 86.4 mm (3.40") 149.1 mm (5.87") 1.8 m (6.0') 50.8 mm (2.00") Accessory Extension Cables Models DB906 DB910 DB9Y† † † Length 1.8 m (6') Configuration † Terminated both ends with 9-pin D-sub connector, for continuous lights 3.0 m (10') (one end male pins and opposite end female pins) 1.8 m (6') Y cable for powering 2 lights from one supply, for continuous lights These models are not stocked and are non-returnable. WARRANTY: Banner Engineering Corp. warrants its products to be free from defects for one year. Banner Engineering Corp. will repair or replace, free of charge, any product of its manufacture found to be defective at the time it is returned to the factory during the warranty period. This warranty does not cover damage or liability for the improper application of Banner products. This warranty is in lieu of any other warranty either expressed or implied. Printed in USA 05/01 P/N 67445 Banner Engineering Corp., 9714 Tenth Ave. No., Mpls., MN 55441 • Ph: 763.544.3164 • www.bannerengineering.com • Email: sensors@bannerengineering.com