FTR-F4

FTR-F4 SERIES POWER RELAY 2 POLE 5A/TV-3 RATED COMPACT TYPE FTR-F4 Series n FEATURES l l l RoHS compliant l l Small high density type relay 288mm2 save 24% compared to VB UL/CSA/VDE/SEMKO/CQC approved Insulation distance: minimum 6 mm between coil and contacts IEC60065 Dielectric strength: 4 KVAV Surge strength: 0 KV Card separation system for high noise resistance between coil and contacts RoHS compliant since date code: 0437L2 Please see page 5 for more information CRT monitor EMI protection Audio system speaker protection n APPLICATIONS l l n ORDERING INFORMATION [Example] (a) (b) (c) (d) (e) (f) FTR-F4 (a) A (b) K (c) 02 (d) T (e) – ** (f ) Series Name Contact Arrangement Coil Type Nominal Voltage Contact material / TV-Rating Custom Designation FTR-F4 : FTR-F4 Series A K 005 02 T : 2 form A (DPST) : Standard type (530 mW) : 5 VDC, : 2VDC, 006 : 6VDC, 024 : 24VDC, 009 : 9VDC 048 : 48VDC : Silver alloy TV-3 Special number for customized products Ordering Code: FTR-F4AK02T Actual Marking:F4AK02T  FTR-F4 SERIES n COIL DATA CHART Standard type MODEL Nominal voltage 5 VDC 6 VDC 9 VDC 12 VDC 24 VDC 48 VDC Coil resistance (±10%) 47 Ω 68 Ω 155 Ω 270 Ω 1,100 Ω 4,400 Ω Operate voltage 3.75 VDC 4.5 VDC 6.75 VDC 9.0 VDC 18.0 VDC 36.0 VDC Release voltage 0.25 VDC 0.3 VDC 0.45 VDC 0.6 VDC 1.2 VDC 2.4 VDC Nominal power 530 mW 530 mW 530 mW 530 mW 530 mW 530 mW FTR-F4AK005T FTR-F4AK006T FTR-F4AK009T FTR-F4AK012T FTR-F4AK024T FTR-F4AK048T Note: All values in the table are measured at 20°C. n SPECIFICATIONS Item Contact Arrangement Material Configuration Resistance (initial) Rating (resistive) Maximum Carrying Current* Maximum Switching Rating Maximum Switching Voltage Maximum Switching Current Minimum Switching Load*2 Maximum Inrush Current Coil Nominal Power (at 20ºC) Operate Power (at 20ºC) Operating Temperature Time Value Life Operate (at nominal voltage) Release (at nominal voltage) Mechanical Electrical Other Vibration Resistance Shock Resistance Weight Contact rating Misoperation Endurance Misoperation Endurance FTR-F4 2 form A (DPST) Silver alloy Single Maximum 100 mΩ at 1 A, 6 VDC 5A, 250VAC / 30VDC 5A ,250 VA / 50W 400 VAC / 300VDC 5A 00mA 5 VDC 20VAC, 5A (TV-3) at lamp load 530mW 300mW -40ºC to +70ºC (no frost) Maximum 5ms (no bounce) Maximum 5ms (no bounce) 2 x 06 ops minimum  x 05 ops min. 0 to 55 Hz, at double amplitude of .5mm 0 to 55Hz, at double amplitude of .5mm ,000m/s2 (6±ms) Approximately 2g 200m/s2 (±ms) Lamp load (TV-3) 2.5 x 04 ops min. * Minimum switching loads mentioned above are reference values. Please perform the confirmation test with the actual load before production since reference values may vary according to switching frequencies, environmental conditions and expected reliability levels. 2 FTR-F4 SERIES n INSULATION Item Resistance (initial) Dielectric Strength open contacts coil and contacts adjacent contacts Surge Voltage (coil and contact) FTR-F4 Minimum 1,000 MΩ ,000 VAC (50/60 Hz)  min. 3,000 VAC (50/60 Hz)  min. 4,000 VAC (50/60 Hz)  min. 0,000 V .2 x 50µs standard wave Note at 500 VDC n SAFETY STANDARDS Type UL CSA Compliance UL 508 E6364 C22.2 No. 4 LR 40304 Contact rating Flammability: UL 94-V0 (plastics) 5A, 277VAC/30VDC (resistive) /6 HP, 25VAC /4 HP, 277VAC Pilot duty: C300 TV-3 20VAC VDE 0435, 0860 Complies with CQC, SEMKO n CHARACTERISTIC DATA Nominal voltage muitiplying factor 20 Timing 100 Coil temperature rise 2.0 1.8 1.6 1.4 1.2 1.0 0.8 0.6 0 20 Operating range 0A 5A 16 Temperature rise (°C) 80 5A Time (ms) 12 Operate 60 8 Release 40 0A 4 20 volta rate Ope t coil ho of ge 0 0 0.2 0.4 0.6 0.8 1.0 Coil power (W) 0 0.2 0.4 0.6 0.8 1.0 1.2 age te volt Opera coil cool of Coil power (W) 40 60 80 100 Ambient temperature (°C) Service life (x104 operations) 10 5 Maximum Switching Power AC Resistive 200 100 70 50 30 20 10 7 5 3 2 1 0 Live Curve 250VAC/30VDC 250VAC cosφ=0.7 30VACτ=7ms Contact Current (A) 2 1 0.5 DC Resistive 250VAC cosφ=0.4 30VDC τ=15ms 0.2 10 20 50 100 200 500 1000 Contact Voltage (V) Contact load current (A) 1 2 3 4 5 6 3 FTR-F4 SERIES n REFERENCE DATA Distribution of operate and release voltage 100 Distribution (%) Distribution (%) Operate Release 60 60 Operate Release Distribution (%) 80 FTR-F4AK012T n=250 100 Distribution of operate and release time 80 FTR-F4AK012T n=250 100 Distribution of contact resistance FTR-F4AK012T n=250 80 60 40 40 40 20 20 20 0 10 20 30 40 50 60 70 80 90 100 0 1 2 3 4 Nominal voltage multiplying factor (%) Time (ms) 5 6 7 8 9 10 0 2 4 Contact resistance (m Ω ) 6 8 10 12 14 16 18 20 10 Voltage (V) 8 6 4 2 0 100 50 20 10 5 2 10 Initial A A Mechanical life test 10 Operate Voltage (V) 8 6 4 2 0 100 50 20 10 5 2 1 Initial X Electrical life test Voltage (V) 10 8 6 4 2 0 100 50 20 10 5 2 1 Initial A Electrical life test Operate Operate A Release A A A Release X Release A FTR-F4AK012T n=8 10 OP/minute 30VDC, 5 A (resistive) A Contact resistance (m) Contact resistance (m) Contact resistance (m) FTR-F4AK012T n=20 300 OP/minute AA A A A A FTR-F4AK012T n=8 10 OP/minute 250VAC, 5 A (resistive) X X A Operation (x104) 20 50 100 200 Operation (x104) 2 5 10 Operation (x104) 2 5 10 n DIMENSIONS l Dimensions FTR-F4 type 24.0 +0.3(.945+.012) 12.0+0.3(.472+.012) l Schematics (BOTTOM VIEW) l PC board mounting hole layout (BOTTOM VIEW) 1.8(.071) 25.0 +0.3(.984+.012) 15(.590) 5(.197) 1 2 3 ø0.5. (.020) 7.5(.295) 1.8(.071) (0.5(.020) 0.3(.011) 15 (0.590) 0.4(.016) 5(.197) 7.5(.295) 1.0(.039) 3.3 (.138) 6 5 4 2-ø0.9(.035) 4-ø1.3(.051) Unit: mm 7.5(.295) 4 FTR-F4 SERIES RoHS Compliance and Lead Free Relay Information 1. General Information Relays produced after the specific date code that is indicated on each data sheet are lead-free now. All of our signal and power relays are lead-free. Please refer to Lead-Free Status Info. (http://www.fujitsu.com/us/downloads/MICRO/fcai/relays/lead-free-letter.pdf) l Lead free solder paste currently used in relays is Sn-3.0Ag-0.5Cu. l All signal and power relays also comply with RoHS. Please refer to individual data sheets. Relays that are RoHS compliant do not contain the 5 hazardous materials that are restricted by RoHS directive (lead, mercury, chromium IV, PBB, PBDE). l It has been verified that using lead-free relays in leaded assembly process will not cause any problems (compatible). l “LF” is marked on each outer and inner carton. (No marking on individual relays). l To avoid leaded relays (for lead-free sample, etc.) please consult with area sales office. l We will ship leaded relays as long as the leaded relay inventory exists. Note: Cadmium was exempted from RoHS on October 2, 2005. (Amendment to Directive 2002/95/EC) l 2. Recommended Lead Free Solder Profile l Recommended solder paste Sn-3.0Ag-0.5Cu. Reflow Solder condition Flow Solder condition: Pre-heating: Soldering: maximum 120˚C dip within 5 sec. at 260˚C soler bath Solder by Soldering Iron: Soldering Iron Temperature: maximum 360˚C Duration: maximum 3 sec. We highly recommend that you confirm your actual solder conditions 3. Moisture Sensitivity l Moisture Sensitivity Level standard is not applicable to electromechanical realys. Dipped SnAgCu solder is known as low risk tin whisker. No considerable length whisker was found by our in house test. 4. Tin Whisker l 5 FTR-F4 SERIES Fujitsu Components International Headquarter Offices Japan Fujitsu Component Limited Gotanda-Chuo Building 3-5, Higashigotanda 2-chome, Shinagawa-ku Tokyo 4, Japan Tel: (8-3) 5449-700 Fax: (8-3) 5449-2626 Email: promothq@ft.ed.fujitsu.com Web: www.fcl.fujitsu.com North and South America Fujitsu Components America, Inc. 250 E. Caribbean Drive Sunnyvale, CA 94089 U.S.A. Tel: (-408) 745-4900 Fax: (-408) 745-4970 Email: components@us.fujitsu.com Web: http://www.fujitsu.com/us/services/edevices/components/ Europe Fujitsu Components Europe B.V. Diamantlaan 25 232 WV Hoofddorp Netherlands Tel: (3-23) 556090 Fax: (3-23) 5560950 Email: info@fceu.fujitsu.com Web: emea.fujitsu.com/components/ Asia Pacific Fujitsu Components Asia Ltd. 02E Pasir Panjang Road #0-0 Citilink Warehouse Complex Singapore 8529 Tel: (65) 6375-8560 Fax: (65) 6273-302 Email: fcal@fcal.fujitsu.com Web: http://www.fujitsu.com/sg/services/micro/components/ ©2007 Fujitsu Components America, Inc. All rights reserved. All trademarks or registered trademarks are the property of their respective owners. Fujitsu Components America or its affiliates do not warrant that the content of datasheet is error free. In a continuing effort to improve our products Fujitsu Components America, Inc. or its affiliates reserve the right to change specifications/datasheets without prior notice. Rev. November 30, 2007 6