144432-1

Application specification CRIMPING JUNIOR POWER TIMER RECEPTACLE CONTACT REF. 144432 (1 to 3 mm2) ON APPLICATOR 114-15051 12 DEC 06 Rev. C 1. SCOPE This specification covers general requirements for cirmping JUNIOR POWER TIMER receptacle contacts manufactured by AMP de France. These requirements must be maintained to have satisfying parformance product. Figure 1 Drawing by : J.-C. JOLY Date : Juin 1991 Approved by : J. -J. REVIL Tyco Electronics France SAS, B.P. 30039 95301 CERGY-PONTOISE Cedex Tél. : 01 34 20 88 88 Fax : 01 34 20 86 00 Ce document géré par Tyco Electronics France est archivé dans la base de donnée Startec. Une impression ne peut être considérée comme un document contrôlé. This document, managed by Tyco Electronics France, is archived in the Startec database. A printout cannot be considered as a controlled document. Date : 01 Avril 1998 1 de 2 CRIMPING JUNIOR POWER TIMER RECEPTACLE CONTACT REF. 144432 (1 to 3 mm2) ON APPLICATOR 114-15051 2. CRIMPING REQUIREMENTS ON APPLICATOR Chek items Specified requirements See figure n° A Cut off tab 0,5 mm max (1) B Rear bellmouth Must be visually identified (2) C Alowed deviation after crimping Bend-up 7° max Bend down 6° maxi Rolling 5° maxi Twisting 10° maxi (3) D Wire end protrusion length 0,8 ± 0,4 mm (4) E Insulation stripping 5 ± 0,5 (5) 3. CRIMPING VALUES Wire crimp Contact p/n Wire size Strip form (mm2) anvil width height mm (± (mm) ±0.05) (8) 144432-1 Insulation crimp Disc code anvil width heigth mm (± 0.1) (mm) (9) Crimping tensile strength (daN) 0.35 + 1 1.57 C 3.24 15 0.35 + 1.4 1.69 C 3.24 20 0.35 + 2 1.86 B 3.65 20 0.6 + 0.6 1.52 D 2.85 15 0.75+0.75 1.63 C 3.24 20 0.6 + 1 1.64 C 3.24 20 0.6 + 1.4 1.76 B 3.65 20 0.6 + 2* 1.94 B 3.65 20 1.46 D 2.85 15 1+1 1.76 B 3.65 20 1 + 1.4* 1.88 B 3.65 20 1.4 1.58 C 3.24 20 1.4 + 1.4* 2.00 A 3.90 20 1.5 1.61 C 3.03 20 2.0 1.76 B 3.65 20 2.5 1.90 A 3.78 20 3.0 2.05 A 3.90 25 1 2.79 3.84 (*) Not used (blocking up). 2 de 2 Rev. C