PSAW6I-10-USB

POWER PARTNERS: PSAW6I Features:  Interchangeable plugs for worldwide use  Class II configura on  Energy Efficiency Level VI  No load power consump on ≤100mW  Short circuit/over‐voltage/over‐current  No load opera on *Safety approvals may be model dependent. Consult TT Electronics for specifics or for additional safety approvals required. Descrip on: The PSAW6I series of AC/DC wall mount switching power supplies provide 2.5 ‐ 6 wa s of con nuous power. They are Class II input devices with interchangeable AC blades for worldwide use. All models meet FCC PART 15, EN55032, EN61000, and CISPR32 Class B emissions limits and comply with 62368 and 61558 standards. Load  Line  Regula on  Regula on  Ripple  & Noise  (P‐P)  Model  Voltage  Current  Total  Power  PSAW6I‐10‐B1 5VDC 500mA 2.5W ±5% ±1% 200mV PSAW6I‐10A‐B1 5VDC 1000mA 5W ±5% ±1% 200mV PSAW6I‐10B‐B1 5VDC 1200mA 6W ±5% ±1% 200mV PSAW6I‐11‐B1 9VDC 670mA 6W ±5% ±1% 200mV PSAW6I‐12‐B1 12VDC 500mA 6W ±5% ±1% 200mV PSAW6I‐14‐B1 24VDC 250mA 6W ±5% ±1% 200mV Notes:   1. Ripple & Noise is measured by using a 20MHz bandwidth limited oscilloscope and terminated with a 0.1µF ceramic capacitor in parallel with a 47µF aluminum electroly c capacitor at full load and nominal line. 2. Line regula on is defined by changing input voltage ±10% from nominal line at rated load. 3. Shipped with USA AC Blades; others ordered separately. General Note All data sheets are subject to change without no ce. © TT Electronics plc TT Electronics h p://www. electronics.com/power‐supplies Rev 0 10 December 2021 Page: 1 POWER PARTNERS: PSAW6I Specifica ons: Input  Input Voltage 90 ‐ 264VAC Input Frequency 47 ‐ 63Hz Input Current ≤0.3A at 230VAC Inrush Current (Typical) ≤40A at 230VAC, cold start No Load Power Consump on ≤100mW; meets DOE Level VI requirements Safety Isola on 3000VAC input to output Output  Total Output Power See Table Output Voltage See Table Hold Up Time (Typical) ≥8.3 mS at 115VAC/60Hz, full load ≥16.6mS at 230VAC/50Hz, full load Turn on Delay ≤3S Turn on Rise Time ≤30mS Minimum Load No minimum load requirement Line Regula on See Table Load Regula on See Table Average Efficiency ≥73.62% at nominal input Protec on Features  Over‐voltage 150%. Latching, cycle power to reset. Over‐current 120 ‐ 200%. Hiccup mode. Auto‐recovery. Short Circuit Hiccup mode. Auto‐recovery. Environmental  Opera ng Temperature 0° ‐ +60°C (See Dera ng Curve) Storage Temperature ‐ Opera ng Humidity 10 ‐ 90% non‐condensing Al tude 100,000 hours per MIL‐HDBK‐217F at full load and 25°C ambient AC Input Connector Interchangeable plugs for worldwide use DC Output Connector Barrel Type Safety  IEC62368 CE, UL, CCC, CB, KC, UKCA IEC61558 PSE, SAA, CB, CCC Approvals* *Safety approvals may be model dependent. Consult TT Electronics for specifics or for additional safety approvals required. EMC  Conducted Emission Radiated Emission Harmonic Currents Voltage Flicker EN55032:2015 + AC:2016, FCC PART 15, Class B EN55032:2015 + AC:2016, FCC PART 15, Class B EN61000‐3‐2 EN61000‐3‐3:2013 Electrosta c Discharge Radiated Immunity EFT/Burst Surge Immunity Conducted Immunity Power Frequency Magne c Field Immunity Dips/Interrup ons IEC61000‐4‐2:2008 (±8kV air, ±4kV contact) IEC61000‐4‐3:2006+A1:2007+A2:2010 (3V/m) IEC61000‐4‐4:2012 (±1kV) IEC61000‐4‐5:2014/AMD1:2017 (1kV diff) IEC61000‐4‐6:2013 (3Vrms) IEC61000‐4‐8:2009 IEC61000‐4‐11:2004 General Note All data sheets are subject to change without no ce. © TT Electronics plc TT Electronics h p://www. electronics.com/power‐supplies Rev 0 10 December 2021 Page: 3 POWER PARTNERS: PSAW6I Mechanical Outline: Dera ng Curves: General Note All data sheets are subject to change without no ce. © TT Electronics plc TT Electronics h p://www. electronics.com/power‐supplies Rev 0 10 December 2021 Page: 4