WCR0805-10KFI

General Purpose Surface Resistors Mounted Resistors General Purpose Surface General PurposeResistors Surface Mounted WCR Series Welwyn Components Welwyn Components Mounted Resistors WCR Series Excellent reliability Wide range of sizes and ohmic values Excellent reliability Wrap around terminations WCR Series Wide range of sizes and ohmic values Inner electrode protection Excellent reliability Wrap around terminations Wide range of sizes and ohmic values Inner electrode protection Wrap around terminations Inner electrode protection AEC-Q200 grade available Electrical Data All parts are Pb-free and comply with EU Directive 2011/65/EU amended by (EU) 2015/863 (RoHS3) 0201 Electrical Data Power rating @ 70°C 0402 0603 0805 1206 1210 2010 2512 0.1 0.125 0.25 0.5 1.0 0.25 0.05 0.063 watts Resistance range ohms 10R to 1M0 1R0 to 1M0 1R0 to 10M 0603 0805 1206 2010 2512 1210 0402 0201 Resistance Range AEC-Q200 10R to 1M0 ohms 0.1 0.125 0.25 0.5 0.05 0.25 0.063 Power ratingLimiting @ 70°Celement votage watts 150 25 50 75 2001.0 volts Resistance range ohms 10R to 1M0 1R0 to 1M0 1R0 to 10M 100 200 250 TCR* ppm/°C Resistance Range AEC-Q200 10R to 1M0 ohms 1 Resistance Tolerance % 150 25 50 75 Limiting element votage volts E24 or E96 200 Standard values 100 200 250 TCR* ppm/°C -55 to 155 Ambient temperature range °C 1 Resistance Tolerance % 1.5 2 0.5 1 Zero-ohm Jumper Chip Rating amps E24 or E96 Standard values 10K, 100K >100K, 1M0 >1M0 E96 1% components that can not be marked with 4 digits will be marked with a standard 3 digit code. Details can be supplied upon request. Noise dB -10 0 +15 +20 +30 Solvent Resistance The protective epoxy lacquer and marking are resistant to all normal industrial cleaning fluids suitable for printed circuits. Performance Data Maximum Change 0201 0402 0603 Load: 1000 hrs at 70°C R% 10R-100K : 1 4R7-100K : 1 1R-100K : 1 Shelf life: 12 months at room temp. R% 0805 1206 1210 2010 2512 1R-100K : 1 >100K : 2 1R-100K : 1 >100K : 2 1R-100K : 1 >100K : 2 3% + 0.1R 0.2 0.2 0.2 0.2 >100K : 2 >100K : 2 >100K : 2 1R-100K : 1 >100K : 2 0.2 0.2 0.2 0.2 zero @ 155 °C Derate linearly to zero from 70°C R% 2 2 2.5 2.5 2.5 2.5 2.5 5 Max voltage volts 50 100 100 200 400 400 400 400 Climatic R% 3 3 3 3 3 3 3 3 Short term overload (6.25 x rated power) Climatic Catagory 55/125/56 1 Long term damp heat R% Temperature rapid change R% 1 1 1 1 1 1 1 1 Resistance to solder heat R% 2.5 2.5 2.5 2.5 2.5 2.5 2.5 2.5 Vibration and bump R% 1 1 1 1 1 1 1 1 500 500 500 500 Noise see table 1 Insulation resistance ohms Voltage proof volts > 1G 100 300 500 Packaging Packaging All chips in 1210 size and smaller are tape mounted and supplied on standard 8mm paper tape, 2010 size on 12mm paper All chips are tape mounted and supplied on standard 8mm Resistor Labstock tape or plastic tape, and 2512 size on 12mm plastic tape reel, as Chip IEC publication 286-3. For Designers tape reel, as IEC publication 286-3. WCR chip resistors are available in a special package of the most 180mm (7 inch) reel is standard 180mm (10 (7 inch) standard carriesthe 5,000 pieces. popular sizes containing 50 each of the E24 values. 250mm inch)reel reeliscarrying double standard quantity (Except 0402 carries 10,000 pieces) Please contact the sales desk for full details of this excellent can be supplied by agreement. Note: For zero ohm jumper chips use the dummy value & tolerance code R005J General Note BI Technologies IRC Welwyn TT Electronics reserves the right to make changes in product specification without notice or liability. All information subject TT Electronics’ own data is considered time of going to print.· Website: www.welwyn-tt.com Telephone: +44is (0) 1670to822181 · Facsimile: +44 and (0) 1670 829465accurate · Email:atinfo@welwyn-tt.com © Welwyn Components Limited Bedlington, Northumberland NE22 7AA, UK Issue D · 01.11 07.03 www.ttelectronics.com/resistors © TT Electronics plc 05.21 General Purpose Surface Mounted Resistors WCR Series Ordering Procedure Ordering Procedure This product has two valid part numbers: European (Welwyn) Part Number: WCR1206-10KFI (1206, 10 kilohms ±1%, Pb-free) W C R 1 2 1 0 6 - 1 0 2 K 3 1 2 3 4 Type Size Value1 Tolerance1 E24 = 3 characters E96 = 4 characters R = ohms K = kilohms M = megohms F = ±1% WCR 0201 0402 0603 0805 1206 1210 2010 2512 F I 4 5 5 Grade / Packing I = Standard A = AEC-Q200 grade 2 Both grades use standard packing as follows: 0201 0402 0603, 0805, 1206, 1210 2010, 2512 20000/reel 10000/reel 5000/reel 4000/reel Note 1: For zero ohm jumper chips use the dummy value & tolerance code R005J Note 2: AEC-Q200 grade on resistor chips is not available in 0201 size. USA (IRC) Part Number: WCR-WCR1206LF-1002-F-P-LT W C R - W 1 R 1 2 2 21 Family Model WCR C WCR 0 6 L 3 F - (1206, 10 kilohms ±1%, Pb-free) 1 0 4 0 5 2 - F - P - 6 L T 7 3 4 5 6 7 Size Termination Value Tolerance Packing 0201 0402 0603 0805 1206 1210 2010 2512 LF = Pb-free 3 digits + multiplier R = ohms for values