2690

2690 Series Coaxial Limiters Rev. V4 Features • • • • • Broadband Frequency Ranges Environmentally Sealed Feedback Leveling Small Size Reduced VSWR Outline 1 .19 (4.83 mm) INPUT SMA PLUG .19 (4.83 mm) .38 (9.65 mm) SMA JACK .90 (22.9 mm) .38 (9.65 mm) Description M/A-COM’s standard limiter series 2690 is a line of completely passive solid state receiver protectors. They exhibit octave and multi-octave performance using a unique construction technique involving PIN diodes in broadband microstrip circuits. Careful diode selection allows a variety of device performance, trading off peak and average power handling, spike leakage and recovery time. Typical insertion loss and VSWR curves are shown below. Outline 2 .19 (4.83 mm) .19 (4.83 mm) INPUT SMA PLUG .38 (9.65 mm) SMA JACK 1.25 (31.75 mm) .38 (9.65 mm) Electrical Specifications: TA = 25°C Part Number 2690-1001 2690-1003 2690-1005 2690-1007 2690-1009 2690-1011 2690-1013 2690-1014 2690-1015 1. 2. 3. 4. 2.0 - 18.0 8.0 - 18.0 2.0 - 8.0 Frequency Range (GHz) 1.0 - 2.0 Insertion Loss (dB) 0.7 0.9 1.1 1.3 1.8 2.3 2.0 2.2 2.3 VSWR Average Power (W) 1.0 3.0 1.0 3.0 1.0 3.0 1.0 2.0 3.0 Peak Power (W) 100 1000 100 1000 100 1000 100 500 1000 Recovery Time (nS) 100 1000 100 1000 100 1000 100 250 1000 Leakage Power (mW) 75 100 50 100 50 100 50 75 100 Outline Drawing 1 2 1 2 1 2 1 1 2 1.5:1 1.5:1 1.6:1 1.6:1 2.0:1 2.0:1 2.0:1 2.0:1 2.0:1 Insertion Loss and VSWR measured at 0 dBm input power. Peak input power rated at 1 microsecond pulse width, 1% duty into 1.5:1 source VSWR and 1.15 load VSWR. Spike leakage energy: 0.5 ergs max. 1 dB compression: +7 dBm min. 1 ADVANCED: Data Sheets contain information regarding a product M/A-COM Technology Solutions • North America Tel: 800.366.2266 • Europe Tel: +353.21.244.6400 is considering for development. Performance is based on target specifications, simulated results, • India Tel: +91.80.4155721 • China Tel: +86.21.2407.1588 and/or prototype measurements. Commitment to develop is not guaranteed. Visit www.macomtech.com for additional data sheets and product information. PRELIMINARY: Data Sheets contain information regarding a product M/A-COM Technology Solutions has under development. Performance is based on engineering tests. Specifications are M/A-COM Technology Solutions Inc. and its affiliates reserve the right to make typical. Mechanical outline has been fixed. Engineering samples and/or test data may be available. changes to the product(s) or information contained herein without notice. Commitment to produce in volume is not guaranteed. 2690 Series Coaxial Limiters Rev. V4 Environmental Test Non-Destructive Bond Pull Internal Visual Stabilization Bake Thermal Cycle Constant Acceleration Burn-In Seal Fine Gross MIL-STD 883 883 883 883 883 883 883 883 883 Method 2023 2017 1008 1010 2001 1015 1014 1014 2009 Cond — — B B A (Y1 Axis) 125°C A1 C1 — Absolute Maximum Ratings 5 Parameter Operating Temperature Storage Temperature Absolute Maximum -55°C to +85°C -65°C to +125°C 5. Operation of this device above any one of these parameters may cause permanent damage. External Visual Devices are designed to meet the above screening conditions. Typical Performance Curves Insertion Loss 0.0 VSWR 3.00 2.75 Insertion Loss (dB) VSWR (Ratio) 2 4 6 10 12 14 16 18 -1.0 2.50 2.25 2.00 1.75 1.50 1.25 -2.0 -3.0 - 4.0 1.00 2 4 6 8 10 12 14 16 18 F re que nc y ( G H z) F re que nc y ( G H z) Leakage Power at 100 mW 25 Power Out (dBm) 20 15 10 5 0 0 10 20 30 40 50 60 P o we r In ( dB m ) 2 ADVANCED: Data Sheets contain information regarding a product M/A-COM Technology Solutions • North America Tel: 800.366.2266 • Europe Tel: +353.21.244.6400 is considering for development. Performance is based on target specifications, simulated results, • India Tel: +91.80.4155721 • China Tel: +86.21.2407.1588 and/or prototype measurements. Commitment to develop is not guaranteed. Visit www.macomtech.com for additional data sheets and product information. PRELIMINARY: Data Sheets contain information regarding a product M/A-COM Technology Solutions has under development. Performance is based on engineering tests. Specifications are M/A-COM Technology Solutions Inc. and its affiliates reserve the right to make typical. Mechanical outline has been fixed. Engineering samples and/or test data may be available. changes to the product(s) or information contained herein without notice. Commitment to produce in volume is not guaranteed.