3003S24WFR

www.make-ps.com E-mail:info@make-ps.com 3000WFR series Single, Dual, Triple Output DC/DC Converter FEATURES • • • • • 6 sided Continuous Shielding Remote On/Off Control Wide 2:1 Input Voltage Range Efficiency to 85% Output Voltage Trim up to ±10% DESCRIPTIONS The 3000WFR series is a family of compact 25W to 30W, high performance DC/DC converters. These converters are specifically designed to provide the flexibility, power density, and reliability required to fulfill local power needs in applications ranging from telecom switch systems to portable instrumentation. 27 models operate over 2:1 input ranges of 9 to 18, 18 to 36 or 36 to 72 VDC; providing single, dual or triple output combinations of 3.3, 5, 12, 15, ±5, ±12, ±15, 5±12 and 5±15 VDC. All models are packaged in compact, low profile 2.0” X 2.0” X 0.4” metal cases. INPUT CHARACTERISTICS Min Typ Max Unit/Comments Input Voltage Range 12 VDC Input Models VDC 9 12 18 24 VDC Input Models VDC 18 24 36 48 VDC Input Models VDC 36 48 72 Remote ON / OFF Control Supply ON 5.5 VDC or Open Circuit Supply OFF 0 VDC to 0.8 VDC Logic Referenced to Negative Input Input Filter Pi Filter OUTPUT CHARACTERISTICS Min Typ Max Unit/Comments Output Voltage Accuracy Single & Dual Outputs Triple Outputs - Primary - Auxiliaries Output Voltage Trim Voltage Balance: Dual Outputs Triple Outputs (Auxiliaries) Minimum Load Line Regulation Single Outputs Dual Outputs Triple Outputs - Primary - Auxiliaries Load Regulation Single Outputs Dual Outputs Triple Outputs - Primary - Auxiliaries Ripple/Noise 5V Outputs 12V and 15V Outputs Short Circuit Protection Transient Recovery Time Temperature Coefficient Over Voltage Protection ±2 ±2 ±5 ±10 %1 %1 %1 %1 GENERAL CHARACTERISTICS Switching Frequency Isolation Voltage Isolation Resistance Min Typ Max Unit/Comments kHz 300 VDC, 1 minute 500 Mohm, 500VDC 1000 ±2 %; Equal Output Loads ±100 mV; Equal Output Loads 10% Full Load ±0.5 ±0.5 ±1 ±5 ±1 ±1 ±1 ±5 %2 %2 %2 %2 %3 % 3 ; Equal Loads %3 % 3 ; Equal Loads 75 mV; p-p, Nom.Line FL, 20Mhz B.W. using 1 μf bypass capacitor 1 % of Vout Continuous, Automatic Recovery 100 μS to within1% error band for 50% step load change ±0.01 % per oC See Model Selection Guide 1 2 3 = Output voltage at nominal line & FL = % Output voltage measured from min. input line to maximum = Output voltage measured from FL to 10% Load >> 1 www.make-ps.com ENVIRONMENTAL SPECIFICATIONS Operating Temp. Range Storage Temp. Range Relative Humidity Cooling Min -25 -55 Typ Max +71 +105 95 Unit/Comments o C; Ambient o C % Humidity; noncondensing Free-Air Convection E-mail:info@make-ps.com PHYSICAL CHARACTERISTICS Case Size Case Material Shield Connection 12V and 24V Input Models 48V Input Models Flammability Unit/Comments 2.0 X 2.0 X 0.4 inches (50.8 X 50.8 X 10.2 mm) Coated Metal with NonConductive Base Negative Input Positive Input UL94V-0 OUTLINE DRAWING 2.00 [50.8] .40 [10.2] SIDE VIEW .22 [5.6] .040 (1.0) TYP. PIN DIA. 5 6 7 8 .40 [10.2] TYP. .40 [10.2] 1.80 [45.72] 1 .20 [5.1] TYP. 2.00 [50.8] BOTTOM VIEW 3 4 .90 [22.9] PIN OUT CHART Pin 1 2 3 4 5 6 7 8 Single Dual Remote On/Off Remote On/Off No Pin No Pin - Vin - Vin + Vin + Vin Trim Trim - Vout - Vout + Vout Common No Pin + Vout Triple Remote On/Off No Pin - Vin +Vin - Aux. Out Common +5V out + Aux. Out Notes: 1. Unless otherwise specified dimensions are in inches (mm). Tolerances Inches mm X.XX = ±0.02 X.X = ±0.5 X.XXX= ±0.010 X.XX = ±0.25 2. Mounting inserts: 4-40 X .10 (2.5) Deep All specifications are typical at nominal input, nominal load and 25° C unless otherwise specified. External, low ESR, 10 microfarad (minimum) capacitor across output is recommended for operation. >> 2 www.make-ps.com HOW TO ORDER HOW TO ORDER 30 XX S XX WFR - Y Wattage Output Voltage Output Configuration (S=Single, D=Dual) E-mail:info@make-ps.com RoHs Complaint Model Series Nominal Input Voltage 30 XX / XX T XX WFR - Y Wattage Main Output Voltage Aux. Main Output Voltage Output Configuration (T=Triple) RoHs Complaint Model Series Nominal Input Voltage MODEL SELECTION CHART Model Nominal Input Voltage No Load Full Load Input Voltage Range Input Current Input Current (VDC) (VDC) (mA) (mA) 12 12 12 12 24 24 24 24 48 48 48 48 12 12 12 24 24 24 48 48 48 12 12 24 24 48 48 9 - 18 9 - 18 9 - 18 9 - 18 18 - 36 18 - 36 18 - 36 18 - 36 36 - 72 36 - 72 36 - 72 36 - 72 9 - 18 9 - 18 9 - 18 18 - 36 18 - 36 18 - 36 36 - 72 36 - 72 36 - 72 9 - 18 9 - 18 18 - 36 18 - 36 36 - 72 36 - 72 30 30 30 30 30 30 30 30 20 20 20 20 35 35 35 30 303 30 25 25 25 35 35 30 30 25 25 1860 2675 3050 3050 920 1336 1525 1525 460 660 765 765 2675 3050 3050 1336 1470 1470 660 735 735 2640 2640 1320 1320 655 655 Output Voltage (VDC) 3.3 5.0 12.0 15.0 3.3 5.0 12.0 15.0 3.3 5.0 12.0 15.0 ±5 ±12 ±15 ±5 ±12 ±15 ±5 ±12 ±15 5/±12 5/±15 5/±12 5/±15 5/±12 5/±15 Full Load Output Current (mA) 5000 5000 2500 2000 5000 5000 2500 2000 5000 5000 2500 2000 ±2500 ±1250 ±1000 ±2500 ±1250 ±1000 ±2500 ±1250 ±1000 3500/±310 3500/±250 3500/±310 3500/±250 3500/±310 3500/±250 Efficiency @ FL (%) 74 78 82 82 75 79 82 82 75 79 82 82 78 82 82 79 85 85 79 85 85 79 79 80 80 80 80 3003S12WFR 3005S12WFR 3012S12WFR 3015S12WFR 3003S24WFR 3005S24WFR 3012S24WFR 3015S24WFR 3003S48WFR 3005S48WFR 3012S48WFR 3015S48WFR 3005D12WFR 3012D12WFR 3015D12WFR 3005D24WFR 3012D24WFR 3015D24WFR 3005D48WFR 3012D48WFR 3015D48WFR 3005/12T12WFR 3005/15T12WFR 3005/12T24WFR 3005/15T24WFR 3005/12T48WFR 3005/15T48WFR >> 3