3015S24

www.make-ps.com E-mail:info@make-ps.com 3000LP series FEATURES • • • • • • • Single, Dual, Triple Output DC/DC Converter 6 sided Continuous Shielding Synchronization and Output Trim Wide 2:1 Input Voltage Range Efficiency to 82% UL 1950 Approved CSA 22.9-950 Approved VDE / EN 60950 Approved , • >600 000 Hours MTBF DESCRIPTIONS The 3000LP series is a family of compact 25W to 30W, high performance DC/DC converters. These converters are specifically designed to provide the flexibility, power density, and reliability required to fulfill local power needs in applications ranging from telecom switch systems to portable instrumentation. 24 models operate over 2:1 input ranges of 9 to 18, 18 to 36 or 36 to 72 VDC; providing single, dual or triple output combinations of 5, 12, 15, ±5, ±12, ±15, 5±12 and 5±15 VDC. All models are packaged in compact, low profile 3.0” X 2.56” X 0.4” metal cases. INPUT CHARACTERISTICS Min Typ Max Unit/Comments Input Voltage Range 12 VDC Input Models VDC 9 12 18 24 VDC Input Models VDC 18 24 36 48 VDC Input Models VDC 36 48 72 Over Voltage Shutdown 12 VDC Input Models VDC 20 24 VDC Input Models VDC 40 48 VDC Input Models VDC 74 Remote ON / OFF Control 5.5 VDC or Open Circuit Supply ON Supply OFF 0 VDC to 0.8 VDC Logic Referenced to Negative Input Reverse Polarity Input Current Amp 12 Input Filter Pi Filter Input Fuse Rating See Model Selection Guide OUTPUT CHARACTERISTICS Min Typ Max Unit/Comments Output Voltage Accuracy Single & Dual Outputs Triple Outputs - Primary - Auxiliaries Output Voltage Adjustment Voltage Balance: Dual Outputs Triple Outputs (Auxiliaries) Minimum Load Line Regulation Single Outputs Dual Outputs Triple Outputs - Primary - Auxiliaries Load Regulation Single Outputs Dual Outputs Triple Outputs - Primary - Auxiliaries Ripple/Noise 5V Outputs 12V and 15V Outputs Short Circuit Protection Transient Recovery Time Temperature Coefficient Over Voltage Protection ±1.0 ±1.0 ±5.0 ±5.0 %1 %1 %1 % 1 ; G Case Only ±2.0 %; Equal Output Loads ±100 mV; Equal Output Loads 10% Full Load ±0.5 ±1.0 ±0.2 ±5.0 ±0.5 ±1.0 ±1.0 ±2.0 %2 %2 %2 %2 %3 % 3 ; Equal Loads %3 % 3 ; Equal Loads GENERAL CHARACTERISTICS Min Typ Max Unit/Comments Switching Frequency kHz 100 Isolation Voltage VDC, 1 minute 1000 Isolation Resistance Mohm, 500VDC 1000 Isolation Capacitance pF, 100kHz, 1Volt 190 MTBF (MIL-HBK-217F) Single and Dual Outputs 685 Thousand Hours, +25oC, Ground Benign Triple Outputs Thousand Hours, 570 +25oC, Ground Benign 75 mV; p-p, Nom.Line FL, 20Mhz B.W. using 1 μf bypass capacitor 1 % of Vout Continuous, Automatic Recovery 100 μS to within1% error band for 50% step load change ±0.01 % per oC See Model Selection Guide 1 2 3 = Output voltage at nominal line & FL = % Output voltage measured from min. input line to maximum = Output voltage measured from FL to 10% Load >> B-200 www.make-ps.com ENVIRONMENTAL SPECIFICATIONS Operating Temp. Range Thermal Shutdown Protection Storage Temp. Range Relative Humidity Cooling Min -40 -40 Typ Max Unit/Comments +75 oC; Ambient o C; Case Temp. +95 +125 oC 95 % Humidity; noncondensing Free-Air Convection E-mail:info@make-ps.com PHYSICAL CHARACTERISTICS Case Size Case Material Shield Connection 12V and 24V Input Models 48V Input Models Flammability Weight Unit/Comments 2.56 X 3.0 X 0.4 inches (65.0 X 76.2 X 10.2 mm) Coated Metal with NonConductive Base Negative Input Positive Input UL94V-0 142 Grams OUTLINE DRAWING CASE G 2.56 (65.0) 0.40 0.40 0.40 0.50 0.30 0.30 (10.2) (10.2) (10.2) (12.7) (7.6) (7.6) 0.20 (5.1) 0.040±.005 (1.01) DIA. PIN OUT CHART; CASE G Single Triple Dual Pin Remote On/Off Remote On/Off Remote On/Off 1 + Vin + Vin + Vin 2 - Vin - Vin - Vin 3 Sync Sync Sync 4 + Vout (Aux) + Vout 5 +Sense/Trim(Down)* Output Trim Common(Aux) Common 6 - Vout - Vout 7 - Sense/Trim (Up)* + Vout* + Vout (Primary) Output Trim 8 - Vout* - Vout (Primary) No Pin 9 No Pin Output Trim (Primary) No Pin 10 * Connections for single output models without sensing or external trimming: For proper operation, externally connect Pin 5 (+Sense) to Pin 8 (+Vout) and Pin 7 (-Sense) to Pin 9 (-Vout) 0.40 (10.2) 10 9 8 1.00 (25.4) 7 6 5 BOTTOM 3.00 (76.2) 1.25 (31.75) 2 1 0.30 (7.6) 0.02 MIN. (0.5) SIDE See Note 2 0.72 (18.3) 4 3 0.70 (17.8) 0.40 0.40 0.60 (10.2) (10.2) (15.2) CASE G-1 0.48 0.40 0.40 0.40 0.40 0.48 (12.2) (10.2) (10.2) (10.2) (10.2) (12.2) 0.25 (6.35) PIN OUT CHART; CASE G-1 0.25 (6.4) 6 7 8 9 10 1.25 (31.75) 3.00 (76.2) 1.25 (31.75) 1 0.040±.005 (1.01) DIA. 0.02 MIN. (0.5) 0.40 (10.2) 0.50 0.50 (12.7) (12.7) See Note 2 5 SIDE BOTTOM 4 3 2 Pin 1 2 3 4 5 6 7 8 9 10 Single Triple Dual Remote On/Off Remote On/Off Remote On/Off No Pin No Pin No Pin Input* Input* Input* Input* Input* Input* NC NC NC NC - Vout (Aux) - Vout NC + Vout (Aux) Output Common - Vout Output Common Output Common + Vout + Output (Primary) + Vout Output Trim Output Trim (Primary) Output Trim * For 12V and 24V input models, Pin 3 is Minus (-) and Pin 4 is Plus (+). For 48V models, Pin 3 is (+) and Pin 4 is Minus (-). 2.56 (65.0) Notes: 1. Unless otherwise specified dimensions are in inches (mm). Tolerances Inches mm X.XX = ±0.02 X.X = ±0.5 X.XXX= ±0.010 X.XX = ±0.25 2. Mounting inserts: 4-40 X .10 (2.5) Deep All specifications are typical at nominal input, nominal load and 25° C unless otherwise specified. External, low ESR, 10 microfarad (minimum) capacitor across output is recommended for operation. >> B-201 www.make-ps.com HOW TO ORDER E-mail:info@make-ps.com HOW TO ORDER 30 XX D XX Wattage Output Voltage Output Configuration (S=Single, D=Dual, T=Triple) Nominal Input Voltage MODEL SELECTION CHART Model Nominal Input Voltage (VDC) 12 12 12 12 12 12 24 24 24 24 24 24 48 48 48 48 48 48 12 12 24 24 48 48 Output Voltage (VDC) 5 12 15 ±5 ±12 ±15 5 12 15 ±5 ±12 ±15 5 12 15 ±5 ±12 ±15 5, ±12 5, ±15 5, ±12 5, ±15 5, ±12 5, ±15 Full Load Output Current (mA) 5000 2000 1650 ±2500 ±1000 ±830 6000 2500 2000 ±3000 ±1250 ±1000 6000 2500 2000 ±3000 ±1250 ±1000 2500, ±500 2500, ±400 3000, ±625 3000, ±500 3000, ±625 3000, ±500 No Load Input Current (mA) 55 55 55 55 55 50 50 50 50 50 50 50 50 40 40 40 40 40 60 60 55 55 45 45 Full Load Input Current (mA) 2670 2560 2640 2770 2560 2670 1560 1560 1560 1560 1560 1560 762 762 762 762 762 760 2610 2610 1560 1560 770 762 Output Over Voltage (VDC) 6.5 15.0 18.0 ±6.5 ±15.0 ±18.0 6.5 15.0 18.0 ±6.5 ±15.0 ±18.0 6.5 15.0 18.0 ±6.5 ±15.0 ±18.0 6.5, ±15.0 6.5, ±18.0 6.5, ±15.0 6.5, ±18.0 6.5, ±15.0 6.5, ±18.0 Fuse (A) Efficiency @ FL (%) 78 78 78 75 78 78 80 80 80 80 80 80 82 82 82 82 82 82 78 78 80 80 81 82 3005S12 3012S12 3015S12 3005D12 3012D12 3015D12 3005S24 3012S24 3015S24 3005D24 3012D24 3015D24 3005S48 3012S48 3015S48 3005D48 3012D48 3015D48 3005/12T12 3005/15T12 3005/12T24 3005/15T24 3005/12T48 3005/15T48 5.0 5.0 5.0 5.0 5.0 5.0 3.0 3.0 3.0 3.0 3.0 3.0 1.5 1.5 1.5 1.5 1.5 1.5 5.0 5.0 3.0 3.0 1.5 1.5 >> B-202