MCC
TM
Micro Commercial Components
omponents 20736 Marilla Street Chatsworth !"# $
% !"#
FS1A THRU FS1M
1 Amp Fast Recovery Silicon Rectifier 50 to 1000 Volts
DO-214AC (HSMA)
H Cathode Band
Features
•
• • • • •
Lead Free Finish/Rohs Compliant (Note1) ("P"Suffix designates Compliant. See ordering information) Epoxy meets UL 94 V-0 flammability rating Moisture Sensitivity Level 1 Easy Pick And Place High Temp Soldering: 260 °C for 10 Seconds At Terminals Superfast Recovery Times For High Efficiency
Maximum Ratings
• • • • Operating Temperature: -50 °C to +150°C Storage Temperature: -50°C to +150°C Maximum Thermal Resistance; 15 °C/W Junction To Lead Maximum Thermal Resistance; 88°C/W Junction To Ambient
MCC Catalog Number FS1A FS1B FS1D FS1G FS1J FS1K FS1M
Device Marking
FS1A FS1B FS1D FS1G FS1J FS1K FS1M
Maximum Recurrent Peak Reverse Voltage 50V 100V 200V 400V 600V 800V 1000V
Maximum RMS Voltage 35V 70V 140V 280V 420V 560V 700V
Maximum DC Blocking Voltage 50V 100V 200V 400V 600V 800V 1000V
DIM A B C D E F G H J
J
A
C
E F G
D
B
Electrical Characteristics @ 25°C Unless Otherwise Specified
Average Forward IF(AV) 1.0A Ta = 90°C current Peak Forward Surge IFSM 30A 8.3ms, half sine Current IFM = 1.0A; Maximum 1.30V Instantaneous VF TJ = 25°C* Forward Voltage Maximum DC Reverse Current At IR 5µA TJ = 25°C Rated DC Blocking 200µA TJ = 125°C Voltage Maximum Reverse Recovery Time 150ns IF=0.5A, IR=1.0A, FS1A-G Trr 250ns Irr=0.25A FS1J 500ns FS1K-M Typical Junction CJ 50pF Measured at Capacitance 1.0MHz, VR=4.0V *Pulse test: Pulse width 200 µsec, Duty cycle 2%
Note: 1. High Temperature Solder Exemptions Applied, see EU Directive Annex 7.
DIMENSIONS INCHES MIN .078 .067 .002 --.035 .065 .205 .160 .100 MM MIN 1.98 1.70 .05 --.89 1.65 5.21 4.06 2.57
MAX .116 .089 .008 .02 .055 .096 .224 .180 .112
MAX 2.95 2.25 .20 .51 1.40 2.45 5.69 4.57 2.84
NOTE
SUGGESTED SOLDER PAD LAYOUT
0.090”
0.085”
0.070”
www.mccsemi.com
Revision: A
1 of 4
2011/01/01
FS1A thru FS1M
Figure 1 Typical Forward Characteristics 20 10 6 4 2 25°C Amps 1 .6 .4 .2 .1 .06 .04 .02 .01 .6 .8 10 Volts Instantaneous Forward Current - Amperesversus Instantaneous Forward Voltage - Volts 1.2 1.4 1.6 Amps 2.4 2.2 2.0 1.8 1.6 1.4 1.2 1.0 .8 .6 .4 Figure 2 Forward Derating Curve
MCC
Micro Commercial Components
TM
Single Phase, Half Wave .2 60Hz Resistive or Inductive Load 0 0 25 50 75 °C Average Forward Rectified Current - Amperes ersus v Ambient Temperature - °C 100 125 150
Figure 3 Junction Capacitance
100 60 40 20 pF 10 6 4 2 1 .1 .2 .4 1 Volts 2 4 10 20 40 100 200 400 1000 TJ=25°C
Junction Capacitance - pFversus Reverse Voltage - Volts
www.mccsemi.com
Revision: A
2 of 4
2011/01/01
FS1A thru FS1M
Figure 4 Peak Forward Surge Current 36 30 24 18 Amps 12 6 0
MCC
TM
Micro Commercial Components
Figure 5 New SMA Assembly
Round Lead Process 1 2 4 6 8 10 Cycles Peak Forward Surge Current - Amperesversus Number Of Cycles At 60Hz - Cycles 20 40 60 80 100
Figure 7 Typical Reverse Characteristics
Figure 6 Reverse Recovery Time Characteristic And Test Circuit Diagram 50Ω 10Ω
100 60 40 20 10
25Vdc
Pulse Generator Note 2 1Ω Oscilloscope Note 1
6 4 2 µAmps 1 .6 .4 .2 .1 .06 .04 TA=25°C TA=125°C
Notes: 1. Rise Time = 7ns max. Input impedance = 1 megohm, 22pF 2. Rise Time = 10ns max. Source impedance = 50 ohms 3. Resistors are non-inductive trr +0.5A
0 -0.25
.02 .01 20 40 60 80 Volts
1cm Set Time Base for 20/100ns/cm
100
120
140
-1.0
Instantaneous Reverse Leakage Current - MicroAmperesversus Percent Of Rated Peak Reverse Voltage - Volts
www.mccsemi.com
Revision: A
3 of 4
2011/01/01
MCC
TM
Micro Commercial Components
Ordering Information :
Device
Part Number-TP
Packing
Tape&Reel: 3Kpcs/Reel
***IMPORTANT NOTICE* **
Micro Comme rcial Components Corp. reserves the right to make changes without further notice to any product herein to make corrections, modifications , enhancements , improvements , or other changes . Micro Comme rcial Components Corp . does not assume any liability arising out of the application or use of any product described herein; neither does it convey any license under its patent rights ,nor the rights of others . The user of products in such applications shall assume all risks of such use and will agree to hold Micro Commercial Co mponents Corp . and all the companies whose products are represented on our website, harmless against all damages. ***LIFE SUPPORT*** MCC's products are not authorized for use as critical components in life support devices or systems without the express written approval of Micro Commercial Components Corporation. ***CUSTOMER AWARENESS*** Counterfeiting of semiconductor parts is a growing problem in the industry. Micro Commercial Components (MCC) is taking strong measures to protect ourselves and our customers from the proliferation of counterfeit parts. MCC strongly encourages customers to purchase MCC parts either directly from MCC or from A uthorized MCC Distributors who are listed by country on our web page cited below. Products customers buy either from MCC directly or from Authorized MCC Distributors are genuine parts, have full traceability, meet MCC' s quality standards for handling and storage. MCC will not pro vide any warranty coverage or o ther assistance for parts bought from Unau thorized Source s. MCC is committed to combat this global problem and encourage our customers to do their part in stopping this practice by buying direct or from authorized distributors.
www.mccsemi.com
Revision: A
4 of 4
2011/01/01