MUR180

MCC Features • • • •
  omponents 21201 Itasca Street Chatsworth    !"# $ %    !"# MUR105 THRU MUR1100 1 Amp Super Fast Recovery Rectifier 50 to 1000 Volts High Surge Capability Low Forward Voltage Drop High Current Capability Super Fast Switching Speed For High Efficiency Maximum Ratings • • MCC Part Number MUR105 MUR110 MUR115 MUR120 MUR140 MUR160 MUR180 MUR1100 Operating Temperature: -50°C to +150 °C Storage Temperature: -50°C to +150 °C Maximum Recurrent Peak Reverse Voltage 50V 100V 150V 200V 400V 600V 800V 1000V Maximum RMS Voltage 35V 70V 105V 140V 280V 420V 560V 700V Maximum DC Blocking Voltage 50V 100V 150V 200V 400V 600V 800V 1000V DO-41 D Electrical Characteristics @ 25° C Unless Otherwise Specified Average Forward IF(AV) 1A TA = 55°C Current Peak Forward Surge IFSM 35A 8.3ms, half sine Current Maximum Instantaneous Forward Voltage IFM = 1.0A; VF .975V MUR105-115 1.35V MUR120-160 TA = 25°C 1.75V MUR180-1100 Maximum DC IR Reverse Current At 5µA TA = 25°C Rated DC Blocking 50µA TA = 150°C Voltage Maximum Reverse Recovery Time MUR105-120 Trr 45ns IF=0.5A, IR=1.0A, MUR140-160 60ns Irr=0.25A MUR180-1100 75ns Measured at Typical Junction 20pF CJ 1.0MHz, VR=4.0V Capacitance *Pulse Test: Pulse Width 300µsec, Duty Cycle 1% A Cathode Mark B D C DIMENSIONS INCHES MIN .166 .080 .028 1.000 MM MIN 4.10 2.00 .70 25.40 DIM A B C D MAX .205 .107 .034 --- MAX 5.20 2.70 .90 --- NOTE www.mccsemi.com MUR105 thru MUR1100 Figure 1 Typical Forward Characteristics 20 10 6 4 1.25 2 25°C Amps 1 .6 .4 .2 MUR120-160 .1 .06 .04 .02 .01 .5 .7 .9 1.1 1.3 1.5 0 .25 MUR180-1100 MUR105-115 .5 Amps 1.0 1.5 MCC Figure 2 Forward Derating Curve .75 Single Phase, Half Wave 60Hz Resistive or Inductive Load 50 75 100 °C 125 150 175 25 Average Forward Rectified Current - Amperes versus Ambient Temperature - °C Volts Instantaneous Forward Current - Amperes versus Instantaneous Forward Voltage - Volts Figure 3 Junction Capacitance 100 60 40 20 pF 10 6 4 2 1 .1 .2 .4 1 Volts 2 4 10 20 40 100 200 400 1000 TJ=25°C Junction Capacitance - pF versus Reverse Voltage - Volts www.mccsemi.com MUR105 thru MUR110 Figure 4 Typical Reverse Characteristics 100 60 40 20 10 6 4 2 TA=100 °C µAmps 1 .6 .4 .2 .1 TA =25°C .06 .04 .02 .01 20 40 60 80 Volts Instantaneous Reverse Leakage Current - MicroAmperes versus Percent Of Rated Peak Reverse Voltage - Volts Figure 6 Reverse Recovery Time Characteristic And Test Circuit Diagram 50Ω 10Ω 100 120 140 Amps TA =150 °C 60 50 40 30 20 10 0 1 2 MCC Figure 5 Peak Forward Surge Current 4 6 8 10 20 Cycles 40 60 80 100 Peak Forward Surge Current - Amperes versus Number Of Cycles At 60Hz - Cycles trr +0.5A 0 25Vdc Pulse Generator Note 2 1Ω Notes: 1. Rise Time = 7ns max. Input impedance = 1 megohm, 22pF 2. Rise Time = 10ns max. Source impedance = 50 ohms 3. Resistors are non-inductive Oscilloscope Note 1 - 0.25 - 1.0 1 cm Set Time Base for 20/100ns/cm www.mccsemi.com