MUR3060B-BP

MUR3060B Features • Lead Free Finish/RoHS Compliant(Note 1) ("P" Suffix Designates Compliant. See Ordering Information) • Halogen Free Available Upon Request By Adding Suffix "-HF" • High Frequency Operation • High Surge Forward Current Capability • Epoxy Meets UL 94 V-0 Flammability Rating • Moisture Sensitivity Level 1 • Planar Structure Die and Soft Recovery Characteristics 30 Amp Ultra Fast Recovery Rectifier 600 Volts Maximum Ratings • Operating Junction Temperature Range: -55⁰C to +175⁰C • Storage Temperature Range: -55⁰C to +175⁰C • Maximum Thermal Resistance: 0.8°C/W Junction to Case MCC Part Number Device Marking Maximum Recurrent Peak Reverse Voltage MUR3060B MUR3060B 600V Maximum RMS Voltage Maximum DC Blocking Voltage 420V 600V Electrical Characteristics @ 25°C Unless Otherwise Specified Average Rectified Forward Current IF(AV) Peak Forward Surge Current IFSM 30A TC=120⁰C VF Maximum Reverse Current At Rated DC Blocking Voltage IR Typical Junction Capacitance CJ 300A 8.3ms,Half Sine 2.3V(Max.) 1.95V(Typ.) 10μA IF=30A; TJ=25⁰C TJ=25⁰C; TJ=125⁰C 500μA 180pF 31ns(Typ.) Measured at 1.0MHz, VR=4V trr 35ns(Max.) IF=0.5A; IR=1.0A; IRR=0.25A 60ns(Typ.) 110ns(Typ.) TJ=25⁰C TJ=125⁰C Peak recovery current IRRM 3.4A(Typ.) 9.7A(Typ.) TJ=25⁰C TJ=125⁰C Reverse recovery charge Qrr 100nC(Typ.) 535nC(Typ.) TJ=25⁰C TJ=125⁰C IF = 30 A diF/dt = 200 A/μs VR = 200 V Note:1. High Temperature Solder Exemptions Applied, See EU Directive Annex 7a. Internal Structure PIN 2 Rev.3-4-04262021 E U O T D C S B P G I Dynamic Recovery Characteristics @ 25°C Unless Otherwise Specified PIN 1 K A R Instantaneous Forward Voltage Reverse Recovery Time TO-247AD J F H Q 1 DIM A B C D E F G H I J K O P Q R S T U 2 INCHES MIN MAX 0.602 0.642 0.799 0.839 0.189 0.205 0.242 0.091 0.106 0.768 0.807 ----- 0.189 0.428 0.075 0.087 0.044 0.054 0.189 0.205 0.073 0.085 0.087 0.103 0.020 0.030 0.512 0.535 0.640 0.663 0.134 0.150 ----- 0.287 MM MIN MAX 15.30 16.30 20.30 21.30 4.80 5.20 6.15 2.30 2.70 19.50 20.50 ----- 4.80 10.88 1.91 2.21 1.11 1.36 4.80 5.20 1.85 2.15 2.21 2.61 0.51 0.75 13.00 13.60 16.25 16.85 3.40 3.80 ----- 7.30 NOTE BSC. BSC. Φ Φ CASE 1/3 MCCSEMI.COM MUR3060B Curve Characteristics 35 350 30 300 Peak Forward Surge Current (A) Average Forward Current (A) Fig. 1 - Forward Current Derating Curve 25 20 15 10 5 0 250 200 150 100 50 Resistive or Inductive Load 0 35 Fig. 2 - Maximum Non-Repetitive Peak Forward Surge Current 70 140 105 0 175 8.3 ms Single Half Sine-Wave 1 Number of Cycles at 60 Hz Fig. 4 - Typical Reverse Leakage Characteristics Fig. 3 - Typical Instantaneous Forward Characteristics 1000 Instantaneous Reverse Leakage Current (μA) Instantaneous Forward Current (A) 30 10 TJ=175°C TJ=125°C TJ=25°C 1 0.2 0.6 1.0 1.8 1.4 10 TJ=125°C 1 0.1 0.01 TJ=25°C 0.001 20 2.2 TJ=175°C 100 40 60 Percent of Rated Peak Reverse Voltage (%) Fig. 5 - Capacitance Characteristics Fig. 6 - Reverse Recovery Waveform and Definitions (3) TJ=25°C f=1MHz trr IF ta tb 0 400 Qrr (2) 300 (1) diF/dt IRRM (4) 0.5 IRRM di(rec)M/dt (5) 0.75 IRRM 200 (1) diF/dt - rate of change of current through zero crossing 100 0 100 80 Instantaneous Forward Voltage (V) 500 Capacitance Between Terminals (pF) 100 10 Case Temperature (°C) (2) IRRM - peak reverse recovery current 0 5 10 15 20 25 (3) trr - reverse recovery time measured from zero crossing point of negative going IF to point where a line passing through 0.75 IRRM and 0.50 IRRM extrapolated to zero current. 30 Reverse Voltage (V) Rev.3-4-04262021 2/3 (4) Qrr - area under curve defined by trr and IRRM Qrr = trr x IRRM 2 (5) di(rec)M/dt - peak rate of change of current during tb portion of trr MCCSEMI.COM MUR3060B Ordering Information Device Packing Bulk:30pcs/Tube,360pcs/Box,1.8Kpcs/Carton Part Number-BP Note : Adding "-HF" Suffix For Halogen Free, eg. Part Number-BP-HF ***IMPORTANT NOTICE*** Micro Commercial Components Corp. reserves the right to make changes without further notice to any product herein to make corrections, modifications , enhancements , improvements , or other changes . Micro Commercial Components Corp . does not assume any liability arising out of the application or use of any product described herein; neither does it convey any license under its patent rights ,nor the rights of others . The user of products in such applications shall assume all risks of such use and will agree to hold Micro Commercial Components Corp . and all the companies whose products are represented on our website, harmless against all damages. Micro Commercial Components Corp. products are sold subject to the general terms and conditions of commercial sale, as published at https://www.mccsemi.com/Home/TermsAndConditions. ***LIFE SUPPORT*** MCC's products are not authorized for use as critical components in life support devices or systems without the express written approval of Micro Commercial Components Corporation. ***CUSTOMER AWARENESS*** Counterfeiting of semiconductor parts is a growing problem in the industry. Micro Commercial Components (MCC) is taking strong measures to protect ourselves and our customers from the proliferation of counterfeit parts. MCC strongly encourages customers to purchase MCC parts either directly from MCC or from Authorized MCC Distributors who are listed by country on our web page cited below. Products customers buy either from MCC directly or from Authorized MCC Distributors are genuine parts, have full traceability, meet MCC's quality standards for handling and storage. MCC will not provide any warranty coverage or other assistance for parts bought from Unauthorized Sources. MCC is committed to combat this global problem and encourage our customers to do their part in stopping this practice by buying direct or from authorized distributors. Rev.3-4-04262021 3/3 MCCSEMI.COM