SF61-TP

MCC TM Micro Commercial Components SF61 THRU SF66
  omponents 20736 Marilla Chatsworth    !"# $ %    !"# Features • • • x x x x Lead Free Finish/RoHS Compliant(Note 1) ("P" Suffix designates RoHS Compliant. See ordering information) Epoxy meets UL 94 V-0 flammability rating Moisture Sensitivity Level 1 Halogen free available upon request by adding suffix "-HF" High current capability,High reliability Low forward voltage drop High surge current capability 6.0 Amp Super Fast Rectifier 50 to 400 Volts DO-201AD Maximum Ratings x x x Operating Temperature: -65к to +125к Storage Temperature: -65к to +150к For capacitive load, derate current by 20% Maximum Maximum Recurrent MCC RMS Peak Reverse Part Number Voltage Voltage SF61 50 35 SF62 100 70 SF63 150 105 SF64 200 140 SF65 300 210 SF66 400 280 Maximum DC Blocking Voltage D 50 100 150 200 300 400 A Cathode Mark B Electrical Characteristics @ 25qC Unless Otherwise Specified Average Forward Current Peak Forward Surge Current Maximum Instantaneous Forward Voltage SF61-SF64 SF65-SF66 Maximum DC Reverse Current At Rated DC Blocking Voltage Typical Junction Capacitance SF61-SF64 SF65-SF66 Maximum Reverse Recovery Time D IF(AV) 6.0A TC = 55к IFSM 150A 8.3ms, half sine VF 0.975V 1.3V IFM = 6.0A; TC = 25к 5.0uA 50uA TC = 25к TC = 100к C DIMENSIONS IR CJ TRR 120pF 60pF 35nS Measured at 1.0MHz, VR=4.0V DIM A B C D INCHES MIN MAX --.370 --.250 .048 .052 1.000 --- MM MIN ----1.20 25.40 MAX 9.50 6.40 1.30 --- NOTE IF=0.5A, IR=1.0A, IRR=0.25A Notes: 1. High Temperature Solder Exemption Applied, see EU Directive Annex Notes 7. 2. Pulse Test: Pulse width 300 usec, Duty cycle 1%. Revision: B www.mccsemi.com 1 of 4 2013/01/01 MCC SF61 thru SF66 TM Micro Commercial Components Figure1 Reverse Recovery Time Characteristic And Test Circuit Diagram 50: 10: trr +0.5A 0 Pulse Generator Note 2 50Vdc 1: -0.25 Oscilloscope Note 1 -1.0 1cm Set Time Base for 20/100ns/cm Notes: 1. Rise Time = 7ns max. Input impedance = 1 megohm, 22pF 2. Rise Time = 10ns max. Source impedance = 50 ohms 3. Resistors are non-inductive Figure 3 Typical Reverse Characteristics Figure 2 Forward Derating Curve 60 100 Single Phase, Half Wave 60Hz Resistive or Inductive Load 50 40 TJ=100qC 10 30 Amps 20 10 0 µAmps 1.0 TJ=25qC 150 25 50 100 75 0 125 Average Forward Rectified Current Per Leg - Amperes versus Ambient Temperature - qC 0.1 .01 0 20 40 60 80 100 140 Volts Instantaneous Reverse Leakage Current -MicroAmperes versus Percent Of Rated Peak Reverse Voltage - Volts Revision: B www.mccsemi.com 2 of 4 2013/01/01 MCC SF61 thru SF66 TM Micro Commercial Components Figure 4 Typical Forward Characteristics Figure 5 Peak Forward Surge Current 150 100 125 8.3ms Single Hale Sine Wave JEDEC METHED 100 75 10 Amps 50 25 0 SF61-SF64 1 2 4 6 8 10 20 40 60 80 100 Cycles Amps 1.0 Peak Forward Surge Current - Amperes versus Number Of Cycles At 60Hz - Cycles SF65-SF66 .1 TJ=25к Pulse Width=300µs 1% Duty Cycle .01 0 0.4 0.2 0.6 10 0.8 1.4 Volts Instantaneous Forward Current - Amperes versus Forward Voltage - Volts Figure 6 Typical Junction Capacitance 180 160 140 pF SF61-SF64 120 TJ=25к 100 SF65-SF66 80 60 .1 .5 1 2 5 10 20 50 100 200 Volts Junction Capacitance – pF Reverse Voltage - Volts Revision: B www.mccsemi.com 3 of 4 2013/01/01 MCC TM Micro Commercial Components Ordering Information : Device Packing Part Number-TP Tape&Reel: 1.2Kpcs/Reel Part Number-AP Ammo Packing: 1.2Kpcs/Ammo Box Part Number-BP Bulk: 12Kpcs/Carton Note : Adding "-HF" suffix for halogen free, eg. Part Number-TP-HF ***IMPORTANT NOTICE*** Micro Commercial Components Corp. reserves the right to make changes without further notice to any product herein to make corrections, modifications , enhancements , improvements , or other changes . Micro Commercial Components Corp . does not assume any liability arising out of the application or use of any product described herein; neither does it convey any license under its patent rights ,nor the rights of others . The user of products in such applications shall assume all risks of such use and will agree to hold Micro Commercial Components Corp . and all the companies whose products are represented on our website, harmless against all damages. ***LIFE SUPPORT*** MCC's products are not authorized for use as critical components in life support devices or systems without the express written approval of Micro Commercial Components Corporation. ***CUSTOMER AWARENESS*** Counterfeiting of semiconductor parts is a growing problem in the industry. Micro Commercial Components (MCC) is taking strong measures to protect ourselves and our customers from the proliferation of counterfeit parts. MCC strongly encourages customers to purchase MCC parts either directly from MCC or from Authorized MCC Distributors who are listed by country on our web page cited below. Products customers buy either from MCC directly or from Authorized MCC Distributors are genuine parts, have full traceability, meet MCC's quality standards for handling and storage. MCC will not provide any warranty coverage or other assistance for parts bought from Unauthorized Sources. MCC is committed to combat this global problem and encourage our customers to do their part in stopping this practice by buying direct or from authorized distributors. Revision: B www.mccsemi.com 4 of 4 2013/01/01 3