PPQ-100_12

100W Quad Output with PFC Function Features : PPQ-100 Universal AC input / Full range Built-in active PFC function, PF>0.95 Protections: Short circuit / Overload / Over voltage Cooling by free air convection 100% full load burn-in test Fixed switching frequency at 70KHz(Optional) 3 years warranty series SPECIFICATION MODEL OUTPUT NUMBER DC VOLTAGE RATED CURRENT CURRENT RANGE RATED POWER (max.) OUTPUT VOLTAGE ADJ. RANGE VOLTAGE TOLERANCE Note.3 LINE REGULATION LOAD REGULATION SETUP, RISE TIME HOLD UP TIME (Typ.) VOLTAGE RANGE FREQUENCY RANGE POWER FACTOR (Typ.) INPUT EFFICIENCY(Typ.) AC CURRENT (Typ.) INRUSH CURRENT (Typ.) LEAKAGE CURRENT OVERLOAD PROTECTION OVER VOLTAGE WORKING TEMP. WORKING HUMIDITY ENVIRONMENT STORAGE TEMP., HUMIDITY TEMP. COEFFICIENT VIBRATION SAFETY STANDARDS SAFETY & WITHSTAND VOLTAGE ISOLATION RESISTANCE EMC (Note 4) EMC EMISSION EMC IMMUNITY MTBF OTHERS DIMENSION PACKING NOTE PPQ-100B CH1 5V 10A 2 ~ 15A 101W CH1:4.75 ~ 5.5V 3.0% 8.0% 1.0% 2.0% 2.0% 6.0% CH2 12V 3.4A 0.3 ~ 4A CH3 -12V 0.6A 0 ~ 1A CH4 -5V 0.6A 0 ~ 1A PPQ-100C CH1 5V 10A 2 ~ 15A 101W CH2 15V 2.6A 0.3 ~ 4A CH3 -15V 0.6A 0 ~ 1A CH4 -5V 0.6A 0 ~ 1A PPQ-100D CH1 5V 8A 2 ~ 10A 102.4W CH2 24V 2A 0.3 ~ 4A CH3 12V 0.6A 0 ~ 1A CH4 -12V 0.6A 0 ~ 1A RIPPLE & NOISE (max.) Note.2 100mVp-p 150mVp-p 100mVp-p 100mVp-p 100mVp-p 150mVp-p 100mVp-p 100mVp-p 100mVp-p 200mVp-p 100mVp-p 100mVp-p 5.0% 2.0% 2.0% 5.0% 1.0% 2.0% 3.0% 1.0% 2.0% +10,-6% 2.0% 6.0% 5.0% 2.0% 2.0% 5.0% 1.0% 2.0% 3.0% 1.0% 2.0% 8.0% 2.0% 6.0% 5.0% 2.0% 2.0% 5.0% 1.0% 2.0% 800ms, 50ms/230VAC 24ms/230VAC 90 ~ 264VAC 47 ~ 63Hz PF>0.95/230VAC 75% 1.65A/115VAC COLD START 30A 0.98/115VAC at full load 76% 0.85A/230VAC 78% 105% ~ 135% rated output power Protection type : Hiccup mode, recovers automatically after fault condition is removed CH1: 5.75 ~ 6.75V Protection type : Shut down o/p voltage, re-power on to recover -10 ~ +60 (Refer to "Derating Curve") 20 ~ 90% RH non-condensing -20 ~ +85 , 10 ~ 95% RH 0.03%/ (0 ~ 50 ) 10 ~ 500Hz, 2G 10min./1cycle, period for 60min. each along X, Y, Z axes UL60950-1, TUV EN60950-1 approved I/P-O/P:3KVAC I/P-FG:1.5KVAC O/P-FG:0.5KVAC I/P-O/P, I/P-FG, O/P-FG:100M Ohms / 500VDC / 25 / 70% RH Compliance to EN55022 (CISPR22) Class B, EN61000-3-2,-3 Compliance to EN61000-4-2,3,4,5,6,8,11, EN55024, light industry level, criteria A 162.5K hrs min. MIL-HDBK-217F (25 177.8*107.95*40mm (L*W*H) 0.62Kg; 24pcs/15.9Kg/1.34CUFT ) 1. All parameters NOT specially mentioned are measured at 230VAC input, rated load and 25 of ambient temperature. 2. Ripple & noise are measured at 20MHz of bandwidth by using a 12" twisted pair-wire terminated with a 0.1uf & 47uf parallel capacitor. 3. Tolerance : includes set up tolerance, line regulation and load regulation. 4. The power supply is considered a component which will be installed into a final equipment. The final equipment must be re-confirmed that it still meets EMC directives. For guidance on how to perform these EMC tests, please refer to “EMI testing of component power supplies.” (as available on http://www.meanwell.com) 5. Heat Sink HS1,HS2 can not be shorted. F ile Name:PPQ-100-SPEC 2012-02-21 100W Quad Output with PFC Function Mechanical Specification 1 77.8 6.35 165.1 PPQ-100 series Unit:mm CN3 1 2 3 4 5 6 7 8 1 2 3 4 5 6.35 AC Input Connector (CN1) : JST B5P-VH or equivalent Pin No. 1 2,4 3 5 Assignment FG No Pin AC/L AC/N Mating Housing JST VHR or equivalent Terminal JST SVH-21T-P1.1 or equivalent 107.95 95.25 HS1 HS2 FS1 AC FUSE T5A/250V CN1 FG 12 3 4 5 SVR1 CN2 DC Output Connector (CN2) : JST B5P-VH or equivalent Pin No. 1,2 3 4 5 Assignment V2 NC V3 V4 Mating Housing JST VHR or equivalent Terminal JST SVH-21T-P1.1 or equivalent LED 4- 3.96 DC Output Connector (CN3) : JST B8P-VH or equivalent Pin No. 1~4 5~8 Assignment V1 COM Mating Housing JST VHR or equivalent Terminal JST SVH-21T-P1.1 or equivalent 40 HS1,HS2 can not be shorted 3max. Block Diagram RECTIFIERS & FILTER I/P EMI FILTER & RECTIFIERS PFC CIRCUIT POWER SWITCHING PWM & PFC CONTROL RECTIFIERS & FILTER RECTIFIERS & FILTER RECTIFIERS & FILTER O.V.P. REGULATOR REGULATOR V4 fosc : 70KHz (Option) V3 V2 +5V COM FG DETECTION CIRCUT Derating Curve Output Derating VS Input Voltage 17.8CFM Forced Air Cooling(10cm) 100 90 80 100 90 80 70 60 LOAD (%) 40 LOAD (%) 0 0 10 20 30 40 50 60 (HORIZONTAL) 60 50 40 20 -10 -10 90 100 115 135 155 230 264 AMBIENT TEMPERATURE ( ) INPUT VOLTAGE (V) 60Hz File Name:PPQ-100-SPEC 2012-02-21