MTH305027AH-24.000MHZ-T

MTH Series Ο Low Profile SMD Package Ο Hermetically Sealed Ο Standby & Tristate Available Ο Wide Frequency Range Frequency Range Electrical Specifications: Temperature Stability* Aging (+25°C ±3°C) Operating Temperature Range Storage Temperature Range Supply Voltage (±10%) 1.000MHZ to 34.999MHZ 35.000MHZ to 60.000MHZ Supply Current 60.001MHZ to 99.999MHZ 100.000MHZ to 106.250MHZ 106.251MHZ to 160.000MHZ Output Type Symmetry (50% of waveform) Rise/Fall Time (10% to 90% of Supply Voltage) Load Start-up Time Period Jitter: pk-pk Period Jitter: One Sigma Phase Jitter (12KHZ to 20MHZ) * Inclusive of Temperature., Load and Voltage Pin 1 Function Tri-state Operation 1.000MHZ to 160.000MHZ +1.80 VDC 8mA 10mA 25mA 35mA 35mA 1.000MHZ to 1.000MHZ to 1.000MHZ to 160.000MHZ 160.000MHZ 106.250MHZ (See Part Number Guide for Options) ±3ppm, ±5ppm for first year (See Part Number Guide for Options) -55°C to +125°C +2.50 VDC +3.30 VDC +5.00 VDC 10mA 16mA 25mA 20mA 25mA 50mA 30mA 40mA 60mA 40mA 50mA 80mA 40mA 50mA NA HCMOS 40%/60% (45%/55% option) 10nS max 15pF 10mSec max ±100ps max ±25ps max 1ps max Standby Current Vih = 70% of Vdd min to Enable Output Vil = 30% max or grounded to Disable Output (High Impedance) 10µA max Revised M: 12/25/09 Page 2 of 6 www.mmdcomp.com MTH Series Part Number Guide Please Consult with MMD Sales Department for any other Parameters or Options Mechanical Details Pin Connections Pin 1 NC, Tri-state or Stand-by Pin 2 Case Ground Pin 3 Output Pin 4 Supply Voltage Dimension in brackets are in inches. Recommended Land Pattern External Bypass Capacitor is recommended. Pads Plating 1. Base or under conductor Ni thickness; 1.3 to 8.8 microns 2. Final plating; A(99.97%0.5 to 1.2 microns Tape & Reel Dimensions Pitch Tape Width Reel DIA Count Pin 1 Orient 4.00 [0.157] 8.00 [0.315] 180 [7.0] 1000 Q1 Notes: UNLESS OTHERWISE SPECIFIED 1. Applicable Standards / Specifications ANSI Y14.5M, Dimensions and Tolerances EIA-481-B, 8mm through 200mm Embossed Carrier Tapping and 8mm and 12mm Punched Carrier Tapping of Surface Mount Components for Automatic Handling. 2. Dimensions are in millimetres [inch]. 3. Tolerances are ±0.1 [0.004] mm unless otherwise specified. 4. Do not scale drawing. INTERNAL ONLY INFORMATION Revised M: 12/25/09 Page 3 of 6 www.mmdcomp.com