SFP-MR-45IR2

Pluggables Datasheet SFP Multi Rate Bidirectional Transceivers SFP-MR-45IR2 and SFP-MR-54IR2 Features OP 100 Mbps-2.7 Gbps data rates OC-48/STM-16 standard compliances IEEE 802.3ah, 1000Base-BX10 compatibility Simplex LC connector 16 dB minimum power budget 40 km reach Single 3.3 V supply 1490 nm or 1570 DFB laser Digital Diagnostic SFF-8472 compliance Telcordia GR-468 compliance GR 253/STM G.957 compliance RoHS and China RoHS compliance SFP MSA SFF-8074i compliance 21CFR 1040.10 and 1040.11 compliance TÜV compliance Commercial temperature rating Class 1 Laser Color coded bail latch: Purple or Orange General Operating Parameter Supply Voltage Total Current Power Supply Noise Rejection Operating Temperature Storage Temperature Data Rate Symbol Vcc Icc PSR Top Tst DR Min. 3.135 100 -5 -40 100 Typical 3.3 Max. 3.465 300 70 85 2700 Unit V mA mVp-p ºC ºC Mbps Transmitter Specifications (Optical) Parameter Optical Power Optical Crosstalk Average Launch Power (Tx: Off ) Extinction Ratio Eye Mask Optical Rise Time (20% - 80% values) Optical Fall Time (20% - 80% values) Mean Wavelength: Spectral Width (20 dB) Relative Intensity Noise Transmitter Reflectance Dispersion Penalty (at 40 km)¹ Side Mode Suppression Ration Reflectance Tolerance SFP-MR-45IR2 SFP-MR-54IR2 tr tf λ λ Δλ RIN dp SMSR rp 1480 1560 30 -24 Symbol Pop Min -2 8.2 Typical 0.5 - Max 3 -45 -45 160 160 1500 1580 1 -120 -12 1 - Unit dBm dB dBm dB ps ps nm nm nm dB/Hz dB dB dB dB XT Poff ER IEEE 802.3 and SONET/SDH compliant 1490 1570 0.5 - 1) Measured at 2.7 Gbps, BER of 10-12, PRBS of 223-1, at eye center sales@mrv.com Pluggables Transmitter Specifications (Electical) Parameter Input Differential Impedence PECL Single Ended Data Input Swing TxFault_Fault TxFault_Normal TxDisable_Disable TxDisable_Enable Symbol Rin Vin,p-p Vfault Vnormal Vd Ven Min 80 250 2 Vee 2 Vee Typical 100 Max 120 1200 Vcc Vee+0.5 Vcc Vee+0.8 Unit Ω mV V V V V Receiver Specifications (Optical) Parameter Receive Power Low² Receive Power High² Damage Threshold for Receiver Wavelength: LOS Assert LOS De-assert LOS Hysteresis Receiver Reflectance SFP-MR-45IR2 SFP-MR-54IR2 Symbol Rsens,low Rsens,high Pin,damage λ λ - Min 0 1560 1480 -28 0.5 - Typical -20 - Max -18 0 1580 1500 -18 -12 Unit dBm dBm dBm nm nm dBm dBm dB dB 2) Measured at 10-10 BER, 2.7 Gbps, 223-1 PRBS, and 10-12 BER, 1250 Mbps, 27-1 PRBS Receiver Specifications (Electrical) Parameter PECL Single Ended Data Output Swing Data Output Rise Time Data Output Fall Time Timing and Electrical Parameter Tx Disable Negate Time Tx Disable Assert Time Time to Initialize, Including Reset of Tx Fault Tx Fault Assert Time Tx Disable to Reset LOS Assert Time LOS De-assert Time Serial ID Clock Rate RX_LOS Voltage (High) RX_LOS Voltage (Low) LOS Output Voltage-Fault LOS Output Voltage-Normal MOD_DEF (0:2)-High MOD_DEF (0:2)-Low Symbol t_on t_off t_init t_fault t_reset t_loss_on t_loss_off f_serial_clock RX_LOSH RX_LOSL VLOS fault VLOSnormal Vh Vl Min 10 2 2 Vee 2 Vee Typical Max 1 10 300 100 100 100 100 0.8 Vcc Vee+0.5 Vcc Vee+0.5 Unit ms µs ms µs µs µs µs KHz V V V V V V Symbol Vout, p-p tr tf Min 185 Typical Max 800 175 175 Unit mV ps ps sales@mrv.com Pluggables Digital Diagnostics Parameter Temperature Voltage Bias Current TX Power RX Power Range -5 to 70 0 to Vcc 0 to 120 -2 to 3 -18 to 0 Accuracy ±3 0.1 5 ±2 dB ±2 dB Unit ºC V mA dBm dBm Calibration Internal Internal External External External Bit Value 1/256 C 100 µV 0.002 mA 0.1µW 0.1µW Formula Tc(C)=Tad(16 bit signed twos complement)/256 V(Volts)=Vad(16 bit unsigned integer)*0.1 I(mA)=Islope*Iad(16 bit unsigned integer)+Ioffset TX_PWR(µW)=TX_PWRslope*TX_PWRad(16 bit unsigned RX_PWR(µW)=A0+A1*x+A2*x^2+A3*x^3+A4*x^4 Pin 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 Function VeeT TX_FAULT TX_DISABLE MOD_DEF2 MOD_DEF1 MOD_DEF0 NC LOS Notes TX Ground Open Collector Internally Pulled High Serial Data Input Serial Clock Input Internally Grounded Not Connected Open Collector RX Ground RX Ground RX Ground RX Data Negative RX Data Positive RX Ground RX Power TX Power TX Ground TX Data Positive TX Data Negative TX Ground VeeR VeeR VeeR RXDRXD+ VeeR VccR VccT VeeT TXD+ TXDVeeT sales@mrv.com Pluggables Outline Drawing Units in mm (inches) Ordering Information Wavelength (nm) Description Distance Range (km) 0 -40 0 -40 Data Rate SFP-MR-45IR2 SFP Multi Rate Bidirectional Transceiver SFP Multi Rate Bidirectional Transceiver 100 - 2700 Mbps 1490/1570 Purple SFP-MR-54IR2 100 - 2700 Mbps 1570/1490 Orange MRV has more than 50 offices throughout the world. Addresses, phone numbers, and fax numbers are listed at www.mrv.com. Please e-mail us at sales@mrv.com or call us for assistance. MRV (West Coast USA) 20415 Nordhoff St. Chatsworth, CA 91311 800-338-5316 818-773-0900 MRV (East Coast USA) 295 Foster St. Littleton, MA 01460 800-338-5316 978-952-4700 MRV (International) Business Park Moerfelden Waldeckerstrasse 13 64546 Moerfelden-Walldorf Germany Tel. (49) 6105/2070 Fax. (49) 6105/207-100 All statements, technical information and recommendations related to the products herein are based upon information believed to be reliable or accurate. However, the accuracy or completeness thereof is not guaranteed, and no responsibility is assumed for any inaccuracies. Please contact MRV Communications for more information. MRV Communications and the MRV Communications logo are trademarks of MRV Communications, Inc. Other trademarks are the property of their respective holders. MRV-OP-SFPMR4554IR2-092507 3020021-001 Rev. A1 Copyright ©2007 MRV Communications, Inc. All Rights Reserved. Bail Latch Color Model