B13JJHF

Series B Toggles Subminiature Fully Illuminated Toggles A Rockers General Specifications Electrical Capacity (Resistive Load) Logic Level: 0.4VA maximum @ 28V AC/DC maximum (Applicable Range 0.1mA ~ 0.1A @ 20mV ~ 28V) Note: Find additional explanation of operating range in Supplement section. Programmable Illuminated PB Pushbuttons Other Ratings Keylocks Contact Resistance: Insulation Resistance: Dielectric Strength: Mechanical Life: Electrical Life: Nominal Operating Force: Contact Timing: Angle of Throw: 50 milliohms maximum 500 megohms minimum @ 500V DC 500V AC minimum for 1 minute minimum 100,000 operations minimum 50,000 operations minimum 1.18N Nonshorting (break-before-make) 26° Materials & Finishes Slides Actuator: Bushing Housing: Case Housing: Support Bracket: Movable Contact: Stationary Contacts: Terminals: Polyamide Polyamide Glass fiber reinforced polyamide Phosphor bronze with tin plating Phosphor bronze with gold plating Brass with tin plating Brass with gold plating Rotaries Environmental Data Tactiles Operating Temperature Range: Humidity: Vibration: Shock: –25°C through +55°C (–13°F through +131°F) 90 ~ 95% humidity for 240 hours @ 40°C (104°F) 10 ~ 55Hz with peak-to-peak amplitude of 1.5mm traversing the frequency range & returning in 5 minutes; 3 right angled directions for 2 hours 50G (490m/s2) acceleration (tested in 3 right angled directions, with 5 shocks in each direction) Tilt PCB Processing Touch Soldering: Cleaning: Indicators Wave Soldering recommended. See Profile A in Supplement section. Manual Soldering: See Profile A in Supplement section. Automated alcohol based cleaning recommended, 5 minutes maximum. Do not use high-purity alcohol (50% alcohol or more) or organic solvent. High alcohol solution can damage clear plastic. See Cleaning specifications in Supplement section. Standards & Certifications Supplement Accessories The B Series illuminated toggles have not been tested for UL recognition or CSA certification. These switches are designed for use in a low-voltage, low-current, logic-level circuit. When used as intended in a logic-level circuit, the results do not produce hazardous energy. A20 www.nkk.com Subminiature Fully Illuminated Toggles Series B A Toggles Supplement Accessories Indicators Touch Tilt Tactiles Slides Rotaries Keylocks Programmable Illuminated PB Pushbuttons Rockers Distinctive Characteristics LED provides maximum illumination to bushing and actuator, indicating actuator status in highly visible green, red, or amber for single color or red/green for bicolor. (Patent pending.) Totally sealed body construction prevents contact contamination and allows time- and money-saving automated soldering and cleaning. Molded-in, epoxy sealed terminals lock out flux and other contaminants. Award-winning STC contact mechanism with benefits unavailable in conventional mechanisms: smoother, positive detent actuation, increased contact stability, and unparalleled logic-level reliability. (Additional STC details in Terms & Acronyms; see Supplement section.) .100” x .100” (2.54mm x 2.54mm) terminal spacing conforms to standard PC board grid spacing. Actual Size www.nkk.com A21 Series B Toggles Subminiature Fully Illuminated Toggles TYPICAL SWITCH ORDERING EXAMPLE A Pushbuttons Rockers B Poles 1 SPDT 2 1 Circuits ON NONE 2 J Actuator J P P C Terminals P Straight Right Angle Vertical C D F C LEDs Single Color Red Amber Green Bicolor CF Red/Green ON-NONE-ON & ON-OFF-ON Programmable Illuminated PB ON J Clear Combines with single color or bicolor LEDs 3 ON OFF ON Combines with bicolor LED only J H V ON-NONE-ON only Bushing Clear Keylocks DESCRIPTION FOR TYPICAL ORDERING EXAMPLE B12JJPC Rotaries Clear Toggle & Bushing with Red LED SPDT ON-NONE-ON Circuit Straight PC Terminals Tactiles Slides P OLE & CIRCUITS Toggle Position Up Center Down Connected Terminals Up Center Down Throw & Schematics Note: Terminal numbers are not actually on the switch. LED circuit is isolated and requires an external power source. Tilt Touch Pole Model Throw Slot Slot Indicators SPDT B12 B13 ON ON NONE OFF ON ON 2-3 2-3 NONE OPEN 2-1 2-1 3 2 (COM) 1 (4) Red (5) (6) (5) (6) Green Single Color Bicolor Accessories ACTUATOR & BUSHING J Clear Toggle (6.3) .248 (3.5) .138 26° (1.9) Dia .075 J Clear Bushing Supplement A22 www.nkk.com Subminiature Fully Illuminated Toggles LED COLORS & SPECIFICATIONS LEDs are an integral part of the switch and not available separately. The electrical specifications shown are determined at a basic temperature of 25°C. If the source voltage exceeds the rated voltage, a ballast resistor is required. The resistor value can be calculated by using the formula in the Supplement section. Single Color Series B A Bicolor Colors Forward Peak Current Continuous Forward Current Forward Voltage Reverse Peak Voltage I FM IF VF VRM Red 30mA 20mA 1.9V 5V Amber 30mA 20mA 1.9V 5V Green 20mA 10mA 3.4V 5V 0.28mA/°C Red/Green 30mA/20mA 20mA/10mA 1.9V/3.4V 5V/5V 0.43mA/°C/0.28mA/°C Current Reduction Rate Above 25°C ∆I F Ambient Temperature Range 0.43mA/°C –25°C ~ +55°C PC TERMINALS P Straight H Right Angle with Bracket V Vertical with Bracket TYPICAL SWITCH DIMENSIONS Straight PC 1 4 5 6 4 1 2 3 26° Slot (8.8) .346 2 3 (8.8) .346 5 6 (5.08) .200 Terminal 4 is a support pin on single color models. B 12JJPC Right Angle PC 26° 1 4 2 5 3 6 (1.9) Dia .075 6 5 4 Slot (2.7) .106 (6.3) .248 (0.4) .016 (5.08) .200 (16.42) .646 (2.54) .100 (0.5) .020 (0.6) Typ .024 (5.08) .200 (0.6) Dia Typ .024 (2.54) Typ .100 (0.8) Dia Typ .031 (5.08) .200 (8.8) .346 Terminal 4 is a support pin on single color models. B 13JJHCF (1.9) Dia .075 (6.0) Dia .236 Slot (0.6) Typ .024 (2.7) .106 (6.3) .248 (0.4) .016 (5.08) .200 (18.96) .746 (0.5) Typ .020 (2.54) Typ .100 (5.08) .200 1 4 5 6 Vertical PC (3.1) .122 2 3 4 5 6 1 2 3 (2.54) Typ .100 (5.08) .200 Terminal 4 is a support pin on single color models. www.nkk.com B 13JJVCF A23 Supplement (5.08) .200 (8.8) .346 (0.6) Dia Typ .024 (0.8) Dia Typ .031 Accessories 26° (8.8) .346 (5.08) .200 Indicators Touch Tilt (6.0) Dia .236 3 2 1 (3.1) .122 (8.8) .346 (2.54) Typ .100 (2.54) .100 Tactiles Slides (3.5) .138 (6.3) .248 (0.8) .031 (13.1) .516 (2.54) Typ .100 (3.1) .122 (0.8) Dia Typ .031 Rotaries (6.0) Dia .236 (1.9) Dia .075 (0.6) Dia Typ .024 (5.08) .200 (2.54) Typ .100 Keylocks Programmable Illuminated PB Pushbuttons Rockers C D F CF Toggles