NEHH2.2M350CB

ALUMINUM ELECTROLYTIC 160V to 450V SUBMINIATURE HIGH VOLTAGE (NEVH: Radial Lead, NEHH: Axial Leads) MECHANICAL SPECIFICATIONS Lead Solderability: Meets the requirements of MIL−STD 202, Method 208 Marking: Consists of series type, nominal capacitance, rated voltage, temperature range, anode and/or cathode identification, vendor identification. Recommended Cleaning Solvents: Methanol, isopropanol ethanol, isobutanol, petroleum ether, propanol and/or commercial detergents. Halogenated hydrocarbon cleaning agents such as Freon (MF, TF, or TC), trichloroethylene, trichloroethane, or methylchloride are not recommended as they may damage the capacitor. The NEVH and NEHH series subminiature aluminum electrolytic capacitors are ideal for polarized capacitor applications requiring small size, high capacitance, high voltage, low cost, and dependability over broad temperature ranges. RATINGS Capacitance Range: 1.0 f to 470 f Tolerance: −10%, +75% Voltage Range: 160V to 450V PERFORMANCE SPECIFICATIONS Operating Temperature Range: For 160V and 250V: −40 C to +85 C (−40 F to +185 F) For 350V and 450V: −25 C to +85 C (−13 F to +185 F) Leakage Current: I 0.02CV + 100 A (measured after 3 minutes of applied voltage) I = Leakage Current ( A) C = Nominal Capacitance ( f) V = Rated Voltage (V) Capacitance Tolerance (M): at +20 C (+68 F), 120Hz Capacitance Values through 4.7 f −10% to +75% −10% to +50% Capacitance Values above 4.7 f Dissipation Factor: at +20 C (+68 F),120Hz Rated Voltage 160, 250, and 350 450 0.20 0.25 1.0 f to 470 f CASE SIZE AND DIMENSIONS: NEVH SERIES Insulating Sleeve 18.0 Min Impedance Ratio at Low Temperature: 120Hz Comparison Z WV 160−250 350 450 Z @ −25 C (−13 F)/ Z @ +20 C (+68 F) 2 2 2 Z @ −40 C (−40 F)/ Z @ +20 C (+68 F) 4 − − D’ Ø = D Ø + 0.5 Max 5.0 Min D’ Ø L’ = L + 1.0 Max at D Ø 8.0 L’ = L + 2.0 Max at D Ø 10.0 NEHH SERIES (Insulating Bar = Negative) DC Rated Voltage 160 250 350 450 Surge Voltage 200 300 400 500 L Load Life: 1000 12Hrs @ +85 C (+185 F), at rated voltage Leakage Current: Within values specified above Dissipation Factor: Within 200% of specified value Capacitance Change Max: See Table Rated Voltage DØ L L’ Surge Voltage: 160V to 450V A 0.5 dØ Insulating Sleeve dØ 2.3 Max DØ 35.0 Min L’ 35.0 Min D’ Ø Capacitance Change Max D’ Ø = D Ø + 0.5 Max Within 20% of the initial value Shelf Life: 1000 Hrs @ +85 C (+185 F), no voltage applied Leakage Current: Within 200% of specified value Dissipation Factor: Within 150% of specified value Capacitance Change Max: Within 20% of initial value L’ = L + 1.0 Max at D Ø 8.0 L’ = L + 2.0 Max at D Ø 10.0 ORDERING INFORMATION NEVH 47 M 160 Series Capacitance Tolerance Voltage NTE Electronics, Inc. Voice (973) 748−5089 FAX (973) 748−6224 http://www.nteinc.com 35 ALUMINUM ELECTROLYTIC 160V to 450V NEVH, NEHH SERIES NEVH Series (Radial Type) Dimensions: Diameter (D Ø) x Length (L): mm WV 160 250 1.0 6.3 x 11 6.3 x 11 2.2 6.3 x 11 8 x 11.5 3.3 6 x 11 4.7 6 x 11 Cap ( f) 350 450 8 x 11.5 10 x 12.5 10 x 12.5 10 x 16 10 x 12.5 10 x 16 10 x 20 10 x 12.5 10 x 16 13 x 20 10 10 x 12.5 10 x 15 13 x 21 13 x 25 22 10 x 20 10 x 20 13 x 25 16 x 31.5 33 13 x 21 13 x 25 16 x 26 18 x 35.5 47 13 x 25 16 x 25 16 x 31 22 x 35 100 16 x 25 18 x 36 22 x 35 25 x 40 220 18 x 35 330 22 x 35 470 22 x 40 * These dimensions are for reference only, please consult the factory for actual size. NEVH Series (Radial Type) Mechanical Specifications: mm Outside Diameter (D Ø) 6.3 8 10 13 16 18 22 25 Lead Spacing (A) 2.5 3.5 5 5 7.5 7.5 10 12.5 Lead Diameter (d Ø) 0.5 0.6 0.6 0.6 0.8 0.8 0.8 1.0 * These dimensions are for reference only, please consult the factory for actual size. NEHH Series (Axial Type) Dimensions: Diameter (D Ø) x Length (L): mm WV 160 Cap ( f) 250 350 450 1.0 6.3 x 16 8 x 16 10 x 20 2.2 8 x 16 8 x 20 10 x 20 10 x 20 3.3 8 x 16 10 x 20 10 x 20 10 x 20 4.7 8 x 20 10 x 20 10 x 20 13 x 25 10 10 x 25 10 x 20 13 x 25 16 x 28 22 10 x 20 13 x 25 13 x 30 16 x 33 33 13 x 25 13 x 30 16 x 30 16 x 40 47 13 x 30 16 x 30 16 x 40 16 x 33 100 16 x 30 16 x 40 18 x 40 22 x 40 220 22 x 40 330 25 x 52 470 22 x 52 * These dimensions are for reference only, please consult the factory for actual size. NEHH Series (Axial Type) Mechanical Specifications: mm Outside Diameter (D Ø) 6.3 8 10 13 16 18 22 25 Lead Diameter (d Ø) 0.6 0.6 0.6 0.8 0.8 0.8 0.8 0.8 * These dimensions are for reference only, please consult the factory for actual size. 36 NTE Electronics, Inc. Voice (973) 748−5089 FAX (973) 748−6224 http://www.nteinc.com