NTE424

MATERIAL SAFETY DATA SHEET Finished Product Date-Issued: July, 2005 MSDS Ref. No: NTE424 Date-Revised: 3/19/2007 Revision No: Rev. 2 NTE424 Non-Silicone Heat Sink Compound Product Code 11 I. PRODUCT AND SUPPLIER INFORMATION PRODUCT NAME: NTE424 Product Synonyms: Non-Silicone Thermal Compound Chemical family or Formula: Complex Mixture Marketer: NTE Electronics, Inc. Phone: 973-748-5089 44 Farrand Street Fax: 973-748-6224 Bloomfield, NJ 07003 Website: www.nteinc.com Product Information: 973-748-5089 Email: general@nteinc.com Transportation Emergency: 973-748-5089 MSDS number: NTE424 Publication Date: Replaces: Rev. 1 Note: The purpose of this MSDS is to provide safe handling, shipping and disposal information for users of the product. It is not intended to, nor does it, provide complete or extensive toxicological data on the product or its components. Users who require this information are referred to primary suppliers of the ingredients of interest. II. COMPOSITION AND INFORMATION ON INGREDIENTS CAS # Proprietary information Concentration >20% Component Name Poly Synthetic Fluid Zinc Oxide* * Material in non-airborn form 1314-13-2 >60% III. HAZARDS IDENTIFICATION OSHA Hazard Classification: No warning statements required. Routes of Entry: Inhalation, skin contact, ingestion Chemical Interactions: Avoid contact with all oxidizing agents IV FIRST AID Inhalation Remove individual to fresh air. If not breathing, give artificial respiration or oxygen as appropriate. Keep patient warm. Seek immediate medical advice. Not an expected route of entry. Overexposure may cause irritation of the mucous membranes and respiratory tract. Skin Contact: Flush skin thoroughly with soap and water. Rinse thoroughly. Seek medical advice if contact was extensive. Prolonged direct skin contact may cause dermatitis or irritation. Eyes: Immediately flush eyes with plenty of water while holding eyelids apart. Seek immediate medical advice Overexposure to direct eye contact may cause redness, irritation, discomfort or tearing. Ingestion: May produce laxative effect. Seek immediate medical advice. Never give anything by mouth to an unconscious person. Symptoms may include: Headache, dizziness, nausea, intestinal disorders and unconsciousness. Not an expected route of exposure. Ingestion may cause abdominal pains, cramping, nausea or vomiting. Notes To Physician: Treat symptomatically. V. FIRE FIGHTING MEASURES Flammability Summary: Heavy Grease Flash Point: > 400 F Fire/Explosion Hazards: This material is not considered a potential fire and explosion hazard under normal operating conditions. Extinguishing Media: Foam, dry chemical, CO2. Water spray may be used to cool containers. Do not allow, contaminated water to enter sewers or waterways. Fire Fighting Instructions: In case of fire, use normal fire fighting equipment including a NIOSH approved self-contained breathing apparatus (SCBA). Use water to cool containers. Hazardous Combustion Products: Oxides of carbon. 1. ACCIDENTAL RELEASE MEASURES Personal Protection for Emergency Situations: Evacuate the area of all unnecessary personnel. Eliminate any ignition sources until the area is determined to be free from explosion and fire hazards. Contain the release and eliminate its source if this can be done safely. Wear protective clothing. Keep unprotected persons away from spill. Spill Mitigation Procedures Air Release: Low volatility makes this hazard unlikely. Provide adequate ventilation. Keep away from ignition sources Water Release: Contain all liquid for treatment and/or disposal as a (potential) hazardous waste. Notify all downstream users of possible contamination. Keep away from ignition sources. Do not flush to sewer! US regulations (CERCLA) require reporting spills and releases to soil, water and air in excess of stipulated quantities. US Coast Guard National Response Center is 800-424-8802. Spill Mitigation Procedures (Cont’d) Land Release: Create a dike or trench to contain materials. Absorb spill with inert material (e.g., dry sand, clay, earth or commercial absorbent), then place in a chemical waste container. Decontaminate all clothing and the spill area using a detergent and flush with large amounts of water. Contain all contaminated water for disposal and/or treatment. Additional Spill Information: Stop source of spill as soon as possible and notify appropriate personnel. Utilize emergency response personal protection equipment prior to the start of any response. Evacuate all non-essential personnel. Dispose of spill residues per guidelines under Section XIII, Disposal Considerations. VII HANDLING AND STORAGE Do not take internally. Avoid contact with skin, eyes and clothing. Upon contact with skin or eyes, wash with soap and water. Avoid breathing vapor or mist. Handling: Storage Keep container tightly closed. Store in a cool area away from ignition sources and oxidizers. No special precautions need be taken if product is handled according to directions. VIII EXPOSURE CONTROLS/ PERSONAL PROTECTION Ventilation: Local exhaust ventilation or other engineering controls are normally NOT necessary when handling or using this product. General exhaust ventilation is usually sufficient for general worker safety and comfort. Explosion proof motors and fans are not required for unheated handling. Respirator Type(s): Air purifying respirators should not be used in oxygen deficient or IDLH atmospheres or if exposure concentrations exceed ten (10) times the published limit. Skin: Wear impervious gloves (butyl rubber, Viton, e.g.) to avoid skin contact. Follow good industrial hygiene practices. Eyes: Use chemical safety glasses with side shields, safety goggles and/or a full face shield where splashing is possible. Protective Clothing Type: Impervious IX PHYSICAL AND CHEMICAL DATA Explosive limits: No data. Low volatility makes ambient explosive vapor concentrations impossible. Vapor Density (Air = 1): Vapor Pressure: (@ 20 Deg. C): Evaporation Rate (Estimated): Flash Point, (Estimated) Volatiles % by vol.: Approximate Boiling Point (deg.F): Drop Point: No data 400 None Physical State: Heavy grease Color: White Odor: Nil Molecular Weight: Not applicable to mixtures pH (@ 25 Deg. C): Not applicable Octanol/Water Coeff: No data Solubility in Water: negligible Bulk Density: Not applicable Specific Gravity (68 Deg.F): 2.7 X STABILITY AND REACTIVITY Stability and Reactivity Summary: Stable under normal conditions. Reactive Properties: Sensitivity to mechanical shock: None Hazardous Polymerization: Will not occur Conditions to Avoid: High temperatures, ignition sources, oxidizing materials. Chemical Incompatibility: Oxidizers. Incompatible materials: No data Hazardous Decomposition Products: CO, CO2 Decomposition Temperature: No data Product May Be Unstable At Temperatures Above: No data XI TOXICOLOGICAL INFORMATION Component Animal Toxicology Oral LD50 Value: No data Dermal LD50: No data Inhalation LC50: No data Product Animal Toxicity: No data Skin Irritation: This material is expected to be slightly irritating to the skin and mucous membranes. Eye Irritation: This material is expected to be irritating. Reproductive and Developmental Toxicity: No reproductive or developmental risk to humans is expected from exposure to this product. Component Data: All data refer to finished product Mutagenicity: Not known or reported to be mutagenic. Carcinogenicity: This chemical is not known or reported to be carcinogenic by any reference source including IARC, EPA OSHA, NTP, or ACGIH. XII ECOLOGICAL INFORMATION Ecological Toxicity Values: Do not allow this material to be released to the environment without appropriate governmental permits. Environmental fate: No information found Environmental Toxicity: No information found XIII DISPOSAL CONSIDERATIONS Consult current local, state and national regulations to ensure proper disposal. Waste Disposal Summary: Product as made does not qualify as an "Unlisted Hazardous Waste" for disposal situations. Disposal Methods: Dispose of in accordance with local, state and federal regulations for hazardous waste. XIV TRANSPORATION INFORMATION Proper Shipping Name, Hazard Class, UN/NA Number Packing Group, Emergency Response Guide Number Not regulated Labels required per 49 CFR 172.101: None Size for "Limited quantity" per 49 CFR 173.150-.155: Not applicable Reportable Quantity ("RQ") per 49 CFR172.101: None Air (IATA/ICAO): Passenger & Cargo: Not applicable Eff. Jan 1, 2001 Cargo only: Not applicable Special Provisions: Not applicable Emergency response Group Code: Not applicable XV REGULATORY INFORMATION UNITED STATES: Toxic Substances Control Act (TSCA): The components of this product are listed on the TSCA Inventory of Existing Chemical Substances. Superfund Amendments and Reauthorization Act (SARA) Title III:Section 313 – Toxic Chemicals: Zinc Oxide CAS# 1314-13-2 Safety Phrases: Keep container tightly closed in a well ventilated area, away from sources of ignition. No smoking. Do not breathe gas, fumes, vapor or spray from this poduct. Do not empty into drains. State Right-to-Know Regulations Status of Ingredients Pennsylvania: No information New Jersey: No information Massachusetts: No information Hazard Category Classifications and Ratings Hazard Categories: Health Fire Pressure Reactivity HMIS Hazard Ratings: Health 1 Fire 1 Instability 0 Other B (Goggles, gloves) NFPA 704 Hazard Ratings: Health 1 Flammability 1 Reactivity 0 Special N/A Hazard Ratings: Least: 0 Slight: 1 Moderate: 2 High: 3 Extreme: 4 XVI ADDITIONAL INFORMATION THIS MATERIAL SATFTY DATA SHEET (MSDS) HAS BEEN PREPARED IN COMPLIANCE WITH THE FEDERAL OSHA HAZARD COMMUNICATION STANDARD, 29 CFR 1910.1200. THE INFORAMTION IN THE MSDS SHOULD BE PROVIDED TO ALL WHO WILL USE, HANDLE, STORE, TRANSPORT, OR OTHERWISE BE EXPOSED TO THIS PRODUCT. WE BELIEVE THIS INFORMATION TO BE RELIABLE AND UP TO DATE AS OF ITS PUBLIATION DATE, BUT MAKE NO WARRANTY THAT IT IS. IF THIS MSDS IS MORE THAN THREE YEARS OLD YOU SHOULD CONTACT THE SUPPLIER TO MAKE CERTAIN THAT THE INFOMATION IS CURRENT. The information is furnished without warranty or implied, except that is accurate to the best of our knowledge. The data on this sheet relates only to the specific material designed herein. NTE Electronics, Inc. assumes no legal responsibility for use or reliance upon these data.