TDF8548TH/N1,118

NXP quad Class-AB amplifiers TDF854x for automotive Continuous sound experience for stop/start cars Designed for use in stop/start cars, these advanced Class-AB amplifiers support listening to audio streams while the car’s internal power supply is down for engine start. They operate in the range of 6 to 18 V. Key features `` Supports stop/start cars by operating voltage range of: ` 6 -18 V `` Low Vp mute level adjustable via I2C (6, 8 V) `` Optimized for low pop (switch-on pop guaranteed in test program) `` Full (start-up) diagnostics with flexible read-out `` Programmable DIAG pin `` Second clip-detect pin for additional front/rear detection (mid-tone/bass) `` Family approach with graduated output power (25, 28 W) `` Compatible with Best-Efficiency quad amplifier (25, 28 W) Application `` Automotive infotainment The TDF854x family reflects NXP’s ongoing commitment to improving functionality and performance in automotive infotainment systems. Available in configurations with I2C-bus control or a Best Efficiency mode, they operate over a wide voltage range and reduce dissipation. I2C-bus control The TDF8541, TDF8542, and TDF8544 are quad ` Class-AB amplifiers with I2C-bus control. The TDF8541 uses an asymmetrical input configuration, delivers an output power of 25 W, and is available in a DBS27 or HSOP36 package. The TDF8542 uses a symmetrical input configuration, delivers an output power of 25 W, and is housed in an HSOP36 package. The TDF8544 uses an asymmetrical input configuration, delivers an output power of 28 W, and is available in a DBS27 or HSOP36 package. `` DC-load detection: open, short and present (woofer) `` AC-load detection: for tweeters via series capacitors `` Programmable clip detection: 2, 5 and 10%. `` Programmable thermal pre-warning `` Independent short-circuit protection per channel `` Soft thermal clipping to prevent audio holes All three devices offer the following features: `` Load dump/over voltage protection `` All amplifier outputs short circuit proof to ground, supply voltage and across the load, independent per channel `` All pins short circuit proof to ground `` Thermal protection to avoid thermal breakdown `` Selectable gain 16/26 dB `` No plops when switching: - Switch on/switch off - Standby and mute - Mute and operating `` Single mode control pin (standby, operating: mute/on) `` Low standby current `` Low power dissipation in any short-circuit condition `` Outputs short-circuit proof to ground `` Low Vp mute for fast mute Vp drops `` Line driver mode (16 dB gain in BTL mode) ``  Line driver mode supports engine start down to 6 V` (16 dB and midtap voltage 0.25 Vp). Best Efficiency mode The TDF8546 and TDF8548 are compatible I²C bus controlled Class-AB amplifiers with the added intelligence of a Best Efficiency mode. In this mode, the devices will have 62% less dissipation compared to standard Class-AB amplifiers with correlated signals between front and rear channels. There is a 4 channel best efficiency mode built in which will have 17% less dissipation than the commonly used 2*2 channel high efficiency mode when there is uncorrelated signals between the front and the rear speakers. A patented best efficiency control will have a low distortion at higher signals. The bus-controlled features are as follows: `` Diagnostic output gives clip information at selectable THD levels (2, 5 and 10%) `` Indication of a short circuit at an amplifier output, short to battery and ground Output power 14.4 V; 10% THD @ 4 Ω The TDF8546 uses an asymmetrical input configuration, delivers 25 W of output power, and is available in a DBS27 or HSOP36 package. The TDF8548 uses an asymmetrical input configuration, delivers an output power of 28 W, and is available in a DBS27 or HSOP36 package. Input configuration Package Class-AB amplifier with I2C control Class-AB amplifier with Best Efficiency mode 25 W Asymmetrical DBS27 (Best Watt) TDF8541J/JS/SD TDF8546J/JS/SD 25 W Asymmetrical HSOP36 TDF8541TH* TDF8546TH* 25 W Symmetrical HSOP36 TDF8542TH* 28 W Asymmetrical DBS27 (Best Watt) TDF8544J/JS/SD TDF8548J/JS/SD 28 W Asymmetrical HSOP36 TDF8544TH* TDF8548TH* * input pins and output pins on opposite configuration www.nxp.com © 2011 NXP Semiconductors N.V. All rights reserved. Reproduction in whole or in part is prohibited without the prior written consent of the copyright owner. The Date of release: February 2011 information presented in this document does not form part of any quotation or contract, is believed to be accurate and reliable and Document order number: 9397 750 17062 may be changed without notice. No liability will be accepted by the publisher for any consequence of its use. Publication thereof Printed in the Netherlands does not convey nor imply any license under patent- or other industrial or intellectual property rights.