NC7WV17L6X

DATA SHEET www.onsemi.com TinyLogic ULP-A Dual Buffer with Schmitt-Trigger Input MARKING DIAGRAMS SIP6 1.45X1.0 MicroPak CASE 127EB NC7WV17 CCKK XYZ Pin 1 The NC7WV17 is a dual buffer with Schmitt−trigger input in tiny footprint packages. The device is designed to operate for VCC = 0.9 V to 3.6 V. CC KK XY Z = Specific Device Code = 2−Digit Lot Run Traceability Code = 2−Digit Date Code = Assembly Plant Code Features • • • • • • • Designed for 0.9 V to 3.6 V VCC Operation 2.2 ns tPD at 3.3 V (Typ) Inputs/Outputs Over−Voltage Tolerant up to 3.6 V IOFF Supports Partial Power Down Protection Source/Sink 24 mA at 3.3 V Available in SC−88A and MicroPak™ Packages These Devices are Pb−Free, Halogen Free/BFR Free and are RoHS Compliant A1 1 6 Y1 GND 2 5 VCC A2 3 4 A1 1 GND Y2 6 Y1 2 5 VCC A2 3 4 Y2 6 SC−88 DF SUFFIX CASE 419AD XXXMG G 1 1 XXX = Specific Devic Code M = Date Code G = Pb−Free Package (Note: Microdot may be in either location) *Date Code orientation and/or position may vary depending upon manufacturing location. ORDERING INFORMATION See detailed ordering, marking and shipping information on page 7 of this data sheet. MicroPak SC−88A Figure 1. Pinout Diagrams (Top Views) A1 1 Y1 A2 1 Y2 Figure 2. Logic Symbol PIN ASSIGNMENT Pin FUNCTION TABLE Function Input Output 1 A1 L L 2 GND H H 3 A2 4 Y2 5 VCC 6 Y1 © Semiconductor Components Industries, LLC, 2004 July, 2022 − Rev. 4 1 Publication Order Number: NC7WV17/D NC7WV17 MAXIMUM RATINGS Symbol Value Unit VCC DC Supply Voltage −0.5 to +4.3 V VIN DC Input Voltage −0.5 to +4.3 V −0.5 to VCC + 0.5 −0.5 to +4.3 −0.5 to +4.3 V VIN < GND −50 mA VOUT < GND −50 mA VOUT Characteristics DC Output Voltage Active−Mode (High or Low State) Tri−State Mode (Note 1) Power−Down Mode (VCC = 0 V) IIK DC Input Diode Current IOK DC Output Diode Current IOUT DC Output Source/Sink Current ±50 mA DC Supply Current per Supply Pin or Ground Pin ±50 mA ICC or IGND TSTG −65 to +150 °C TL Storage Temperature Range Lead Temperature, 1 mm from Case for 10 Seconds 260 °C TJ Junction Temperature Under Bias +150 °C qJA Thermal Resistance (Note 2) SC−88A MicroPak 377 154 °C/W PD Power Dissipation in Still Air SC−88A MicroPak 332 812 mW Level 1 − Oxygen Index: 28 to 34 UL 94 V−0 @ 0.125 in − Human Body Mode Charged Device Mode 2000 1000 V ±100 mA MSL Moisture Sensitivity FR Flammability Rating VESD ILatchup ESD Withstand Voltage (Note 3) Latchup Performance (Note 4) Stresses exceeding those listed in the Maximum Ratings table may damage the device. If any of these limits are exceeded, device functionality should not be assumed, damage may occur and reliability may be affected. 1. Applicable to devices with outputs that may be tri−stated. 2. Measured with minimum pad spacing on an FR4 board, using 10 mm−by−1 inch, 2 ounce copper trace no air flow per JESD51−7. 3. HBM tested to EIA / JESD22−A114−A. CDM tested to JESD22−C101−A. JEDEC recommends that ESD qualification to EIA/JESD22−A115A (Machine Model) be discontinued. 4. Tested to EIA/JESD78 Class II. www.onsemi.com 2 NC7WV17 RECOMMENDED OPERATING CONDITIONS Symbol Parameter VCC Positive DC Supply Voltage VIN DC Input Voltage VOUT TA tr , tf DC Output Voltage Active−Mode (High or Low State) Tri−State Mode (Note 1) Power−Down Mode (VCC = 0 V) Operating Temperature Range Input Transition Rise and Fall Time Min Max Unit 0.9 3.6 V 0 3.6 V 0 0 0 VCC 3.6 3.6 −40 +85 °C 0 No Limit ns/V Functional operation above the stresses listed in the Recommended Operating Ranges is not implied. Extended exposure to stresses beyond the Recommended Operating Ranges limits may affect device reliability. DC ELECTRICAL CHARACTERISTICS TA = 255C Symbol Parameter VP Positive Threshold Voltage VN VH Negative Threshold Voltage Hysteresis Voltage Condition VCC (V) Min Typ 0.9 − 1.1 − 1.4 TA = −405C to +855C Max Min Max Unit 0.62 − − 1.0 − − V − 1.0 − − 1.25 − 1.25 1.65 − 2.3 − − 1.5 − 1.5 − 1.8 − 1.8 2.7 0.9 − − 2.2 − 2.2 − 0.34 − − − 1.1 0.15 − − 0.15 − 1.4 0.2 − − 0.2 − 1.65 0.25 − − 0.25 − 2.3 0.4 − − 0.4 − 2.7 0.6 − − 0.6 − 0.9 − 0.29 − − − 1.1 0.08 − 0.6 0.08 0.6 1.4 0.09 − 0.8 0.09 0.8 1.65 0.15 − 1.0 0.15 1.0 2.3 0.25 − 1.1 0.25 1.1 2.7 0.6 − 1.2 0.6 1.2 www.onsemi.com 3 V V NC7WV17 DC ELECTRICAL CHARACTERISTICS (continued) TA = −405C to +855C TA = 255C Symbol Parameter VOH High−Level Output Voltage Condition Low−Level Output Voltage Input Leakage Current Max Min Max − VCC – 0.1 − − − 1.1 to 1.3 VCC – 0.1 − − VCC – 0.1 − 1.4 to 1.6 VCC – 0.1 − − VCC – 0.1 − 1.65 to 1.95 VCC – 0.2 − − VCC – 0.2 − 2.3 to