OSW4XME1E1E

Xeon 1 Power Pure White LED OSW4XME1E1E VER C.0 ■Features ● ■Outline Dimension Highest Luminous Flux Super energy efficiency Long Lifetime Operation Built-in Zener Diode For ESD Protection Superior UV Resistance 3.6 ● ● ● ● BackView ■Applications ● Read lights (car, bus, aircraft) Portable (flashlight, bicycle) Bollards / Security / Garden Traffic signaling / Beacons In door / Out door Commercial lights Automotive Ext Anode Cathode ESD Protection Diode Unit:mm Tolerance:±0.30mm ● ● ● ● ● ■Absolute Maximum Rating Item DC Forward Current Pulse Forward Current* Reverse Voltage Power Dissipation Operating Temperature Storage Temperature Lead Soldering Temperature *Pulse width Max.10ms (Ta=25℃) Symbol IF IFP VR PD Topr Tstg Tsol ■Directivity Unit mA mA V mW 0 0 Value 400 500 5 1600 -30 ~ +85 -40~ +100 260℃/5sec ℃ ℃ - Duty ratio max 1/10 ■Electrical -Optical Characteristics Item DC Forward Voltage DC Reverse Current Luminous Flux Color Temperature Chromaticity Coordinates* 50% Power Angle (Ta=25℃) Min. 3.0 90 - ■Forward Operating Current (DC) Unit ) ( , 250 200 150 100 50 0 0 25 50 75 100 125 /W RJ-A=60℃ RJ-A=50℃ /W RJ-A=40℃ /W RJ-A=30℃ /W 400 350 300 Symbol VF IR Φv CCT x y 2θ1/2 Condition IF=350mA VR=5V IF=350mA IF=350mA IF=350mA IF=350mA IF=350mA Typ. 3.3 100 6500 0.31 0.33 140 Max. 4.0 10 - V µA lm K deg ) Ambient Temperature, TA (℃ Note: Don’t drive at rated current more than 5s without heat sink for Xeon 1 emitter series. LED & Application Technologies http://www.optosupply.com 1/2 VER C.0 Xeon 1 Power Pure White LED OSW4XME1E1E VER C.0 ■ Handling of Silicone Lens LEDs Notes for handling of silicone lens LEDs ● Please do not use a force of over 3kgf impact or pressure on the silicone lens, otherwise it will cause a catastrophic failure. ● The LEDs should only be picked up by making contact with the sides of the LED body. ● Avoid touching the silicone lens especially by sharp tools such as Tweezers. ● Avoid leaving fingerprints on the silicone lens. ● Please store the LEDs away from dusty areas or seal the product against dust. ● When populating boards in SMT production, there are basically no restrictions regarding the form of the pick and place nozzle, except that mechanical pressure on the silicone lens must be prevented. ● Please do not mold over the silicone lens with another resin. (epoxy, urethane, etc) LED & Application Technologies http://www.optosupply.com 2/2 VER C.0