802-RF481.2M-A

Oscilent Corporation RF SAW Filter | 802-RF481.2M-A Page 1 of 2 RF SAW Filter Part Number Package Application Last Modified 802-RF481.2M-A . TYPE : 3.0 x 3.0 SMD CDMA450(F-Band) Mar. 2, 2007 CDMA450, RF-Tx SAW Filter PART NUMBER : 802-RF481.2M-A .. OPERATING CONDITIONS / ELECTRICAL CHARACTERISTICS PARAMETERS Center Frequency (Fo) Maximum Insertion Loss Stop Band Attenuation: Condition 479.0~ 483.5 MHz 0.3~ 467.0 MHz 489.0~ 493.5 MHz 493.5~ 1700.0MHz 1700.0~ 2000.0 MHz Source Impedence (single ended)* Load Impendance (single ended)* VSWR Maximum Input Power Operating Temperature * No Matching Network 479.0~ 483.5 MHz Minimum 25 30 23 15 -30 Typical 481.2 2.0 28 50 27 22 50 50 1.3 Maximum 3.2 2.0 30 +80 ohm ohm dBm ºC dB Units MHz dB . PACKAGE OUTLINE (mm) PIN LAYOUT A B C D E F Ground Out Ground Ground In Ground TEST FIXTURE Source/ Load Impedance = 50 ohms FREQUENCY RESPONSE Oscilent Corporation RF SAW Filter | 802-RF481.2M-A Page 2 of 2 VSWR SMITH CHART Part No.: 802-RF481.2M-A Crystal Oscillators | Quartz Crystal | TCXO | VCXO | IF SAW Filter | RF SAW Filter | Ceramic Resonator Crystal Filter | Ceramic Filter | SAW Filter / SAW Devices | Site Map