819-IF100.0M-C

Oscilent Corporation IF SAW Filter | 819-IF100.0M-C Page 1 of 2 IF SAW Filter Part Number Package Application Last Modified 819-IF100.0M-C . TYPE : 19 x 6.5 SMD Base Station, Repeater, HDR, IMT-2000 May 02 2003 100.0 MHz Bandpass Filter 0.47 MHz Bandwidth PART NUMBER : 819-IF100.0M-C . Horizontal : 0.5 MHz/Div Veritical : 10 dB/Div Horizontal : 0.1 MHz/Div Veritical : 1 dB/Div Veritical : 100 ns/Div . OPERATING CONDITIONS / ELECTRICAL CHARACTERISTICS PARAMETERS Center Frequency Insertion Loss 1dB Bandwidth 3dB Bandwidth 40dB Bandwidth Passband Ripple Group Delay Variation Absolute Delay Ultimate Rejection Substrate Material Ambient Temperature Phase Linearity Minimum 99.97 0.30 0.47 45 Typical 100.0 13.7 0.34 0.55 1.38 0.8 250 2.4 55 Quartz 25 3.0 Maximum 100.03 15.0 1.40 1.5 500 6.0 Units MHz dB MHz MHz MHz dB nsec µsec dB °C deg * Custom SAW IF Filters available. Contact Oscilent for assistance. . PACKAGE OUTLINE (mm) TEST FIXTURE http://www.oscilent.com/spec_pages/if_sawfilter/if_819_if100_0c.htm 12/28/2005 Oscilent Corporation IF SAW Filter | 819-IF100.0M-C Page 2 of 2 L1 = 162nH C1 = 18pF L2 = 132nH C2 = 39pF Source/Load Impedance = 50 ohms Part No.: 819-IF100.0M-C Crystal Oscillators | Quartz Crystal | TCXO | VCXO | IF SAW Filter | RF SAW Filter | Ceramic Resonator Crystal Filter | Ceramic Filter | SAW Filter / SAW Devices | Site Map http://www.oscilent.com/spec_pages/if_sawfilter/if_819_if100_0c.htm 12/28/2005