835-IF240.0M-D

Oscilent Corporation IF SAW Filter | 835-IF240.0M-D Page 1 of 2 IF SAW Filter Part Number Package Application Last Modified 835-IF240.0M-D TYPE : 35.0 x 12.8 Thru Hole Base Station & Repeater Jan. 01, 2007 240.0 MHz Bandpass Filter PART NUMBER : 835-IF240.0M-D OPERATING CONDITIONS / ELECTRICAL CHARACTERISTICS PARAMETERS Center Frequency Insertion Loss Source Impedance (single ended)* Load Impedance (single ended)* 1.5dB Bandwidth 3.0dB Bandwidth 40.0dB Bandwidth Amplitude Ripple (Fo+/-6.875 MHz) Group Delay Variation (Fo+/-6.875 MHz) Absolute Delay at Fo Ultimate Rejection Temperature Coefficient Storage Temperature Operating Temperature Minimum 239.85 13.9 14.1 -40 -30 Typical 240.00 29.5 50 50 14.12 14.32 15.52 0.9 65 3.18 52 -20 Maximum 240.15 31.5 15.8 1.5 120 +85 +70 Units MHz dB ohm ohm MHz MHz MHz dBp-p ns µs dB ppm/°C °C °C * with Matching Network (Ref. Testing Environment Circut as shown below). Those impedances could be modified with different impedances values and/or structures, if necessary. ** Custom SAW IF Filters available. Contact Oscilent for assistance. PACKAGE OUTLINE (mm) Oscilent Corporation IF SAW Filter | 835-IF240.0M-D Page 2 of 2 PIN Descriptions: IN-1, OUT 5, GROUND -2,3,4,6,Case TEST ENVIRONMENT Source & Load Impedance: 50 ohm FREQUENCY RESPONSE Part No.: 835-IF240.0M-D Crystal Oscillators | Quartz Crystal | TCXO | VCXO | IF SAW Filter | RF SAW Filter | Ceramic Resonator Crystal Filter | Ceramic Filter | SAW Filter / SAW Devices | Site Map