862-RF1086.0M-A

Oscilent Corporation RF SAW Filter | 862-RF1086.0M-A Page 1 of 3 RF SAW Filter Part Number Package Application Last Modified 862-RF1086.0M-A . TYPE : 3.0 x 3.0 SMD Wireless Jan. 01, 2007 Wireless, Balanced RF SAW Filter PART NUMBER : 862-RF1086.0M-A .. OPERATING CONDITIONS / ELECTRICAL CHARACTERISTICS PARAMETERS Center Frequency (Fo) Maximum Insertion Loss Stop Band Attenuation: Condition 1081.0~ 1091.0 MHz 500.0~ 988.0 MHz 988.0~ 1002.0 MHz 1038.0~ 1046.0MHz 1156.0~ 1600.0 MHz 2040.0~ 2148.0 MHz Amplitude Ripple Input/ Output VSWR Source Impedence (balanced ended)* Load Impendance (balanced ended)* Group Delay Ripple Maximum DC Voltage Phase Balance Maximum Input Power Operating Temperature * No Matching Network 1081.0~ 1091.0 MHz 1081.0~ 1091.0 MHz 1081.0~ 1091.0 MHz 1081.0~ 1091.0 MHz Minimum 50 45 35 40 30 -40 Typical 1086.0 3.5 57 50 40 45 35 0.6 2.0 200 200 7.0 10 Maximum 4.5 1.5 2.5 0 0 +85 dB ohm ohm ns V deg. dBm ºC dB Units MHz dB . PACKAGE OUTLINE (mm) PIN LAYOUT A B C D E F G H In Ground In Ground Out Ground Out Ground TEST FIXTURE Oscilent Corporation RF SAW Filter | 862-RF1086.0M-A Page 2 of 3 Load Impedance = 200 ohms Source Impedance = 200 ohms FREQUENCY RESPONSE VSWR SMITH CHART Oscilent Corporation RF SAW Filter | 862-RF1086.0M-A Page 3 of 3 Part No.: 862-RF1086.0M-A Crystal Oscillators | Quartz Crystal | TCXO | VCXO | IF SAW Filter | RF SAW Filter | Ceramic Resonator Crystal Filter | Ceramic Filter | SAW Filter / SAW Devices | Site Map