4MA187500Z3
187.50 MHz LVPECL Oscillator
High Performance Differential Oscillator
Features
Frequency:
Output Type:
Frequency Stability:
Supply Voltage:
Standard Packages:
RMS phase jitter:
Operating Temperature:
Specification
187.50 MHz
LVPECL
± 50ppm
2.5V & 3.3V
5.0 x 3.2 mm; 7.0 x 5.0 mm
0.7ps typical (12k to 20MHz)
- 40 to 85 °C
2.5 V
Specifications
Parameter
Min
Supply Voltage (VDD)
Output Frequency
Frequency Stability
Supply Current
Input LOW level
Input HIGH level
Output LOW level
Output HIGH level
Rise Time (TR)
Typ
Max
3.3 V
Specifications
Min
2.50
187.50
Typ
3.30
187.50
± 50
100
0.3VDD
0. 7VDD
0. 7VDD
VDD -1.6
VDD -1.0
VDD -1.0
300
Max
300
0.75
VDD -1.3
0.75
VDD -1.3
45
55
3
1.0
±5
This product is rated “Green”, please contact
IDT for environmental compliancy information
Units
Conditions
V
MHz
± 50 ppm
100
mA
0.3VDD
V
V
VDD -1.6 V
V
300
ps
300
Fall Time (TF)
Amplitude (VA )
Mid Level (VM)
Symmetry (SYM)
Period Jitter
Phase Jitter
Aging
ADVANCE DATASHEET
45
55
3
1.0
±5
-40 to 85°C
no load
At OE pin
At OE pin
Maximum; 20/80% of VA; Output load (CL) = 2pF
ps
V
V
%
ps
ps
ppm
Maximum; 20/80% of VA; Output load (CL) = 2pF
Single Ended output swing (Pk-Pk)
Worst case; measured at 50% of waveform
Measured over 10k cycles, rms
12k to 20MHz, rms
25°C, 10 years
Note: Above specifications are typical at room temperature (25°C ) unless otherwise specified. Frequency stability includes initial frequency tolerance, temperature variation, supply
voltage variation, reflow drift, and aging (+25 °C, 10 years).
Block Diagram
VDD
Output Waveform
OUT-
TR
OUT+
TF
80%
OE
NC
20%
GND
Part Ordering Information
Package Size
5.0 x 3.2 mm
7.0 x 5.0 mm
May 09, 2012
Voltage
3.3 V
2.5 V
3.3 V
2.5 V
VA
VM
Output
MEMS
IDT
MEMS
ASIC
Ordering Code
4MA187500Z3AACTGI
4MA187500Z3BACTGI
4MA187500Z3AACUGI
4MA187500Z3BACUGI
t1
SYM = t1 / t2
4MA
187500
Frequency
187.500 MHz
t2
Z3
Voltage
A: 3.3 V
B: 2.5 V
A
A
Package
CTG: 5.0 x 3.2
CUG: 7.0 x 5.0
CTG
Temperature
I: -40 to 85°C
I
8
Shipping
Blank: Tubes
8:
T/R
©2012 Integrated Device Technology, Inc
Datasheet 187.50 MHz LVPECL Oscillator
Package Outline and Dimensions
3.20 ±0.05
1.00 ±0.05
0.64 ±0.05
Pin #1 ID
Chamfer
0.30 x 45°
0.0-0.05
NC
5.00 ±0.05
1.27 Bsc
GND
1.30 ±0.05
Pin #1 ID
R 0.15°
OUT+
1.50
3.60
0.85 ±0.05
0.0-0.05
OE
VDD
5.08
6L SMD
NC
7.00 ±0.05
2.54 Bsc
0.25 Ref
GND
1.60
0.203 Ref.
6024 Silver Creek Valley Road
San Jose, California 95138
OUT-
0.90
0.203 Ref.
1.50 ±0.05
7.0 x 5.0mm
VDD
OE
1.08 ±0.05
5.0 ±0.05
2.60
0.85 ±0.05
2.54
6L SMD
5.0 x 3.2mm
Typical PCB Land Pattern
OUTOUT+
Pin Name
1
OE
2
NC
3 GND
4 OUT+
5 OUT6 VDD
Description
Output Enable*
No Connect
Ground
Output
Output
Power
* internally pulled high
1.60
Unit: (mm)
Sales
Technical Support
+1 408-284-8200
Fax: 408-360-1738
MEMS_Support@idt.com
www.idt.com/go/MEMS
DISCLAIMER Integrated Device Technology, Inc. (IDT) and its subsidiaries reserve the right to modify the products and/or specifications described herein at any time and at IDT’s sole discretion. All information in this document, including
descriptions of product features and performance, is subject to change without notice. Performance specifications and the operating parameters of the described products are determined in the independent state and are not guaranteed to perform
the same way when installed in customer products. The information contained herein is provided without representation or warranty of any kind, whether express or implied, including, but not limited to, the suitability of IDT’s products for any
particular purpose, an implied warranty of merchantability, or non-infringement of the intellectual property rights of others. This document is presented only as a guide and does not convey any license under intellectual property rights of IDT or any
third parties.
IDT’s products are not intended for use in life support systems or similar devices where the failure or malfunction of an IDT product can be reasonably expected to significantly affect the health or safety of users. Anyone using an IDT product in such
a manner does so at their own risk, absent an express, written agreement by IDT.
Integrated Device Technology, IDT and the IDT logo are registered trademarks of IDT. Other trademarks and service marks used herein, including protected names, logos and designs, are the property of IDT or their respective third party owners.
Copyright 2010, 2011, 2012. All rights reserved.
May 09, 2012
www.IDT.com
©2012 Integrated Device Technology, Inc
很抱歉,暂时无法提供与“4MA187500Z3AACTGI8”相匹配的价格&库存,您可以联系我们找货
免费人工找货