AE414

E-pHEMT MMIC Product Features • Small size (3X3 mm) • Higher Gain • Higher linearity • DFN SMD Type package • Higher productivity • Lower manufacturing cost • -60dBc CSO 135 Channels @ +30dBmV/ch • -71dBc CTB 135 Channels @ +30dBmV/ch • -71dBc XMD 135 Channels @ +30dBmV/ch • Low Noise Figure AE414 (Preliminary) Application • Low Noise Amplifier for CATV, Satellite • Cable Modem • FTTH (G-PON, GE-PON) • Optical node Package : DFN Description AE414 is designed as low cost drive amplifiers for many applications including FTTH, CATV System. This MMIC is based on Gallium Arsenide Enhancement Mode pHEMT which shows low current draw and very low noise. The data in this spec sheet is valid only for 75 ohm application. 50 ohm data is in a separate spec sheet. Specifications PARAMETER Frequency Gain Input Return Loss Output Return Loss Output IP3 1dB Compression Point Noise Figure CSO CTB XMOD DC Current NOTE 1. Test conditions unless otherwise noted. 1000MHz, T=25℃, Vdd=8V, 75Ω system 2. OIP3 measured with 2 tones at an output power of +10dBm/tone separated by 1MHz UNIT MHz dB dB dB dBm dBm dB dBc MIN TYP 50 ~ 2200 MAX Condition 18.5 20 -20 -10 35 22 38 25 2 -60 -71 -71 140 2.5 -55 -66 -66 135 channel, +30dBmV/ch 135 channel, +30dBmV/ch 135 channel, +30dBmV/ch Vdd = 8.0V 30 ~ 870MHz dBc dBc mA Absolute Minimum and Maximum Ratings PARAMETER Device Voltage Operating Temperature Storage Temperature UNIT VDC MIN TYP +8 -40 -40 MAX +8.5 +85 +150 ℃ ℃ ▪ Tel : 82-31-250-5011 ▪ rfsales@rfhic.com ▪ All specifications may change without notice. ▪ Version 0.1 E-pHEMT MMIC +8 V 680 Ω AE414 (Preliminary) Application Circuit: 50~ 2200MHz, 8v, 75ohm System 4.7uF / 16v (Tantalium) 0Ω 10 nF 1 2 8 7 820 nH (Wire wound) Input 100 nF 2.2 nH 3 4 AE414 6 5 3.9 nH 100 nF Output 0.3 pF 3.3 nH 82 Ω 680 Ω 10 nF PCB material (FR4), PCB thickness (0.8t), Via hole (Φ0.4) S-Parameter 25 20 Gain (dB) 15 10 20 Noise Figure 6 5 10 Return Loss (dB) S21 0 4 NF (dB) 3 2 1 0 10 400 800 1200 1600 2000 2400 S22 5 0 0.0 -10 S11 0.5 1.0 1.5 2.0 -20 2.5 Frequency (GHz) Frequency (MHz) Multi-Tone Test 135CH_FLAT@Output Power +30dBmV Level: +30dBmV FRQ 55.25 77.25 109.25 211.25 331.25 445.25 547.25 637.25 745.25 859.25 Tilt: 135CH_FLAT CTB_RAW 75.2 75.6 74.8 74.9 73.5 74.5 73 73 72.9 71.4 CTB_COR 79.6 80 79.2 79.3 77.8 78.8 77.3 77.3 77.2 75.7 N-FLR 76.5 76.5 76.3 76.1 74.9 76.1 73.9 74.4 74 72.1 CSU_RAW 76 72.6 75.9 75.5 71.4 69.3 65.6 64.1 61.8 60 CSU_COR 80.4 74.8 80.2 79.8 73.9 70.3 66.3 64.5 62.1 60.3 CSU_FRQ 56.06 77.99 110 212.49 332.5 446.5 548.5 638.49 746.49 860.49 CSL_RAW 72.4 76 71.5 69.9 67.1 66.1 64.5 65.7 68.3 70.3 8V CSL_COR 74.6 80.4 73.1 71 68 66.6 65 66.3 69.7 74.6 680 ohm CSL_FRQ 53.99 75.89 107.99 209.99 329.99 443.99 545.99 635.98 743.98 858.49 XMD(NCTA) 73.2 74 74.2 73.4 73.5 72.5 71.9 72.3 71.9 71.5 Min Max 71.5 74.2 71.4 75.6 75.7 80 72.1 76.5 60 76 60.3 80.4 56.06 860.49 64.5 76 65 80.4 53.99 858.49 ▪ Tel : 82-31-250-5011 ▪ rfsales@rfhic.com ▪ All specifications may change without notice. ▪ Version 0.1 E-pHEMT MMIC AE414 (Preliminary) 5v Application, Bias Resistor(Rb) 2 kohm Application Circuit: 50~ 2200MHz, 5v, 75ohm System +5 V Rb 2000 Ω 0Ω 10 nF 1 2 8 7 820 nH (Wire wound) 4.7uF / 16v (Tantalium) Parameter Gain OIP3 Output 3.9 nH 100 nF Unit dB dBm dBm dBc dBc dBc mA Typical Data 19 33 19 -53 -63 -63 100 Input 100 nF 2.2 nH 3 4 AE414 P1dB CSO CTB XMOD 6 5 0.3 pF 1.8 nH 51 Ω 560 Ω 10 nF DC Current *Test condition: 1000MHz, 25℃ S-Parameter 25 20 Gain (dB) 15 10 5 0 0.0 20 6 5 Noise Figure 10 Return Loss (dB) 0 NF (dB) S21 4 3 2 1 S22 S11 0.5 1.0 1.5 2.0 -10 -20 2.5 0 10 400 800 1200 1600 2000 2400 Frequency (GHz) Frequency (MHz) Multi-Tone Test 135CH_FLAT@Output Power +30dBmV Level: +30dBmV FRQ 55.25 77.25 109.25 211.25 331.25 445.25 547.25 637.25 745.25 859.25 Tilt: 135CH_FLAT CTB_RAW 74.3 74.8 74 73.4 70.8 70.1 68.8 67.4 67.2 66.6 CTB_COR 78.6 79.1 78.4 76.4 73 71.3 70.4 68.4 68.1 67.9 N-FLR 76.5 76 76.2 76.2 74.8 75.9 73.8 74.3 74.1 72.4 CSU_RAW 74.6 55.4 72.4 67.4 63 61.2 60.3 59.3 58 57.4 CSU_COR 79 55.4 74.9 68 63.3 61.3 60.5 59.4 58.1 57.5 CSU_FRQ 55.99 78 110 212.5 332.5 446.49 548.49 638.5 746.49 860.49 CSL_RAW 56.1 76 55.8 56.2 57 58.4 59.8 61.8 65.6 68.4 5V CSL_COR 56.1 80.3 55.8 56.2 57 58.4 59.9 62.1 66.3 70.6 2 kohm CSL_FRQ 53.99 76.15 108 209.99 329.98 443.99 545.98 635.99 743.99 858.49 XMD(NCTA) 71.1 70.9 72.2 71.9 71.5 70.5 69.8 68.8 67.8 66.3 Min Max 66.3 72.2 66.6 74.8 67.9 79.1 72.4 76.5 55.4 74.6 55.4 79 55.99 860.49 55.8 76 55.8 80.3 53.99 858.49 ▪ Tel : 82-31-250-5011 ▪ rfsales@rfhic.com ▪ All specifications may change without notice. ▪ Version 0.1 E-pHEMT MMIC +8 V Rb 680 Ω 0Ω AE414 (Preliminary) S-Parameter Application Circuit: 50~ 1000MHz, 8v, 75ohm System 25 4.7uF / 16v (Tantalium) 20 10 20 Gain (dB) 10 nF 1 2 8 7 820 nH (Wire wound) S21 15 10 0 -10 -20 -30 1.4 Return Loss (dB) Input 100 nF 10 nH 3 4 AE414 6 5 6.8 nH 100 nF Output S22 5 0 0.0 S11 1.5 pF 0Ω 150 Ω 910 Ω 0.2 0.4 0.6 0.8 1.0 1.2 10 nF Frequency (GHz) Application Circuit: 50~ 1000MHz, 5v, 75ohm System Rb 25 20 S-Parameter 20 10 S21 Gain (dB) 15 10 5 0 0.0 0 Return Loss (dB) S11 S22 0.2 0.4 0.6 0.8 1.0 1.2 -10 -20 -30 1.4 Frequency (GHz) Specifications Parameter Frequency Supply Voltage Bias resistor Gain OIP3 P1dB Noise Figure CSO CTB XMOD DC Current NOTE *. Test conditions unless otherwise noted. 500MHz, T=25℃, 75Ω system **. OIP3 measured with 2 tones at an output power of +10dBm/tone separated by 1MHz ***. OIP3 measured with 2 tones at an output power of +5dBm/tone separated by 1MHz Unit MHz V Typical Data 50~1000 Condition 8 680 21.4 39** 25 1.7 -60 -71 -71 140 5 2k 21 36*** 20 1.7 -53 -63 -63 100 135 channel, +30dBmV/ch 135 channel, +30dBmV/ch 135 channel, +30dBmV/ch Rb Ω dB dBm dBm dB dBc dBc dBc mA ▪ Tel : 82-31-250-5011 ▪ rfsales@rfhic.com ▪ All specifications may change without notice. ▪ Version 0.1 E-pHEMT MMIC Block Diagram AE414 (Preliminary) PIN No 1 2, 7 3 4, 5, 8 6 Description Bias Control No Connection RF Input Ground RF Output Package Dimensions (Type: DFN 3 x 3 -8L) RFHIC Corporation (RFHIC) reserves the right to make changes to any products herein or to discontinue any product at any time without notice. RFHIC do not assume any liability for the suitability of its products for any particular purpose, and disclaims any and all liability, including without limitation consequential or incidental damages. The product specifications herein expressed have been carefully checked and are assumed to be reliable. However, RFHIC disclaims liability for inaccuracies and strongly recommends buyers to verify that the information they are using is current before placing purchase orders. RFHIC products are not intended for use in life support equipment or application where malfunction of the product can be expected to result in personal injury or death. Buyer uses or sells such products for any such unintended or unauthorized application, buyer shall indemnify, protect and hold RFHIC and its directors, officers, stockholders, employees, representatives and distributors harmless against any and all claims arising out of such use. RFHIC’s liability under or arising out of damages, claims of whatsoever kind and nature which RFHIC products could cause shall be limited in amount to the net purchase price of the products sold to buyer by RFHIC. ▪ Tel : 82-31-250-5011 ▪ rfsales@rfhic.com ▪ All specifications may change without notice. ▪ Version 0.1