BR24L08FVM-W

Memory ICs BR24L08-W / BR24L08F-W / BR24L08FJ-W BR24L08FV-W / BR24L08FVM-W 1024×8 bit electrically erasable PROM BR24L08-W / BR24L08F-W / BR24L08FJ-W / BR24L08FV-W / BR24L08FVM-W The BR24L08-W series is 2-wire (I2C BUS type) serial EEPROMs which are electrically programmable. ∗ I C BUS is a registered trademark of Philips. 2 Applications General purpose Features 1) 1024 registers × 8 bits serial architecture. 2) Single power supply (1.8V to 5.5V). 3) Two wire serial interface. 4) Self-timed write cycle with automatic erase. 5) 16byte Page Write mode. 6) Low power consumption. Write (5V) : 1.5mA (Typ.) Read (5V) : 0.2mA (Typ.) Standby (5V) : 0.1µA (Typ.) 7) DATA security Write protect feature (WP pin). Inhibit to WRITE at low VCC. 8) Small package - - - DIP8 / SOP8 / SOP-J8 / SSOP-B8 / MSOP-8 9) High reliability EEPROM with Double-Cell structure. 10) High reliability fine pattern CMOS technology. 11) Endurance : 1,000,000 erase / write cycles 12) Data retention : 40 years 13) Filtered inputs in SCL•SDA for noise suppression. 14) Initial data FFh in all address. Absolute maximum ratings (Ta=25°C) Parameter Supply voltage Symbol VCC Limits −0.3 to +6.5 800(DIP8) 450(SOP8) Power dissipation Pd 450(SOP-J8) 300(SSOP-B8) 310(MSOP8) Storage temperature Operating temperature Terminal voltage ∗1 ∗2 ∗3 ∗4 Unit V ∗1 ∗2 ∗2 ∗3 ∗4 mW Tstg Topr − −65 to +125 −40 to +85 −0.3 to VCC+0.3 °C °C V Reduced by 8.0mW for each increase in Ta of 1°C over 25°C. Reduced by 4.5mW for each increase in Ta of 1°C over 25°C. Reduced by 3.0mW for each increase in Ta of 1°C over 25°C. Reduced by 3.1mW for each increase in Ta of 1°C over 25°C. 1/25 Memory ICs BR24L08-W / BR24L08F-W / BR24L08FJ-W BR24L08FV-W / BR24L08FVM-W Symbol VCC VIN Limits 1.8 to 5.5 0 to VCC Unit V V Recommended operating conditions (Ta=25°C) Parameter Supply voltage Input voltage DC operating characteristics (Unless otherwise specified Ta=−40 to 85°C, VCC=1.8 to 5.5V) Parameter "HIGH" input volatge 1 "LOW" input volatge 1 "HIGH" input volatge 2 "LOW" input volatge 2 "LOW" output volatge 1 "LOW" output volatge 2 Input leakage current Output leakage current Symbol VIH1 VIL1 VIH2 VIL2 VOL1 VOL2 ILI ILO ICC1 Operating current ICC2 Standby current ISB − − − − 0.5 2.0 mA µA Min. 0.7VCC − 0.8VCC − − − −1 −1 − Typ. − − − − − − − − − Max. − 0.3VCC − 0.2VCC 0.4 0.2 1 1 2.0 Unit V V V V V V µA µA mA Conditions 2.5V≤VCC≤5.5V 2.5V≤VCC≤5.5V 1.8V≤VCC