USP-225-15

ELECTRONIC COMPONENTS RSG ■ RSG Electronic Components GmbH Sprendlinger Landstr. 115 D-63069 Offenbach/Germany Tel. +49 69 984047-0 Fax +49 69 984047-77 info@rsg-electronic.de www.rsg-electronic.de ■ ■ ■ ■ ■ Änderungen vorbehalten / subject to change without notice 225W Single Output with PFC Function Features : USP-225 series Universal AC input / Full range Built in active PFC circuit compliance to EN61000-3-2 Protections:Short circuit/Over load/Over voltage/Over temperature Free air convection for 150W and forced air convection for 225W 3 High power density 4.7w/in Active AC surge current limiting U-bracket low profile:38mm 3 years warranty SPECIFICATION MODEL DC VOLTAGE RATED CURRENT CURRENT RANGE RATED POWER OUTPUT VOLTAGE ADJ. RANGE LINE REGULATION LOAD REGULATION SETUP, RISE TIME HOLD TIME (Typ.) VOLTAGE RANGE FREQUENCY RANGE POWER FACTOR (Typ.) INPUT EFFICIENCY (Typ.) 230VAC INRUSH CURRENT (Typ.) LEAKAGE CURRENT OVER LOAD PROTECTION OVER VOLTAGE OVER TEMPERATURE WORKING TEMP. WORKING HUMIDITY ENVIRONMENT STORAGE TEMP., HUMIDITY TEMP. COEFFICIENT VIBRATION SAFETY STANDARDS WITHSTAND VOLTAGE SAFETY & EMC (Note 4) USP-225-3.3 3.3V 40A 0 ~ 40A 132W USP-225-5 5V 40A 0 ~ 40A 200W 100mVp-p 4.5 ~ 5.5V 2.0% 0.5% 1.0% USP-225-12 12V 18.7A 0 ~ 18.7A 224.4W 100mVp-p 10.8 ~ 13.2V 2.0% 0.5% 1.0% USP-225-15 15V 15A 0 ~ 15A 225W 100mVp-p 13.5 ~ 16.5V 2.0% 0.5% 1.0% USP-225-24 24V 9.4A 0 ~ 9.4A 225.6W 150mVp-p 21.6 ~ 26.4V 2.0% 0.5% 1.0% USP-225-48 48V 4.7A 0 ~ 4.7A 225.6W 250mVp-p 43.2 ~ 52.8V 2.0% 0.5% 1.0% RIPPLE & NOISE (max.) Note.2 100mVp-p 2.97 ~ 3.6V VOLTAGE TOLERANCE Note.3 2.0% 0.5% 1.0% 500ms, 30ms/230VAC 22ms/230VAC 90 ~ 264VAC 47 ~ 63Hz PF>0.93/230VAC 72% 115VAC 2.2A 1.1A 15A/115VAC 0.97/115VAC at full load 77% 3.3A 1.6A 30A/230VAC 83% 84% 86% 86% AC CURRENT (Typ.) 105 ~ 150% rated output power Protection type : Constant current limiting, recovers automatically after fault condition is removed 3.6 ~ 4.4V 5.5 ~ 7.4V 13.2 ~ 16.3V Protection type : Shut down o/p voltage, re-power on to recover 95 5 (RTH2 : Detect on heatsink of power transistor) -20 ~ +65 -40 ~ +85 (Refer to output load derating curve) , 10 ~ 95% RH 16.5 ~ 20.2V 26.4 ~ 32.4V 52.8 ~ 64.8V Protection type : Shut down o/p voltage, recovers automatically after temperature goes down 20 ~ 90% RH non-condensing 0.03%/ (0 ~ 50 10 ~ 500Hz, 2G 10min./1cycle, 60min. each along X, Y, Z axes UL60950-1, TUV EN60950-1 Approved I/P-O/P:3KVAC I/P-FG:1.5KVAC O/P-FG:0.5KVAC ISOLATION RESISTANCE I/P-O/P, I/P-FG, O/P-FG:100M Ohms/500VDC EMI CONDUCTION & RADIATION Compliance to EN55022 (CISPR22) Class B HARMONIC CURRENT EMS IMMUNITY MTBF DIMENSION PACKING Compliance to EN61000-3-2,-3 Compliance to EN61000-4-2,3,4,5,6,8,11; ENV50204, Light industry level, criteria A 220K hrs min. MIL-HDBK-217F (25 ) 202*101.5*38mm (L*W*H) 0.85Kg; 16pcs/14.6Kg/0.76CUFT OTHERS NOTE 1. All parameters NOT specially mentioned are measured at 230VAC input, rated load and 25 of ambient temperature. 2. Ripple & noise are measured at 20MHz of bandwidth by using a 12" twisted pair-wire terminated with a 0.1uf & 47uf parallel capacitor. 3. Tolerance : includes set up tolerance, line regulation and load regulation. 4. The power supply is considered a component which will be installed into a final equipment. The final equipment must be re-confirmed that it still meets EMC directives. File Name:USP-225-SPEC 2006-11-27 225W Single Output with PFC Function Mechanical Specification USP-225 Case No. 928 series Unit:mm 202 198.25 65.75 3.75 60 38 8 248.5 LED 3.2 101.5 CN2 10 9 8 7 6 5 4 3 2 1 11 12 13 14 15 16 17 18 19 20 1 2 3 CN1 FS1 F6.3A/250V AC Input Connector (CN1) : JST B3P-VH or equivalent Pin No. 1 2 3 Assignment AC/N No Pin AC/L Mating Housing JST VHR or equivalent Terminal JST SVH-21T-P1.1 or equivalent DC Output Connector (CN2) : MOLEX 39-29-9206 or equivalent Pin No. 1~5 6~15 16~20 Assignment +V -V +V Mating Housing MOLEX 5557 or equivalent Terminal MOLEX 5556 or equivalent Block Diagram EMI FILTER ACTIVE INRUSH CURRENT LIMITING RECTIFIERS & P.F.C. POWER SWITCHING RECTIFIERS & FILTER fosc : 100KHz +V -V O.T.P. O.C.P. I/P FG O.L.P. P WM CONTROL DETECTION CIRCUIT O.V.P. Derating Curve 3.3V,5V Model With 18CFM Forced Air Convection Static Characteristics (5V) Ta=25 With18CFM Forced Air Convection 100 100 90 80 70 80 65 60 Free Air Convection LOAD (%) 50 40 3.3V,5V Model Free Air Convection LOAD(%) 60 50 40 20 -20 0 10 20 30 40 45 50 60 70 (HORIZONTAL) 90 100 110 135 155 230 101.5 260 File Name:USP-225-SPEC 2006-11-27 ■ ■ 93.5 2-M 3 AMBIENT TEMPERATURE ( ) INPUT VOLTAGE (V) 60Hz ELECTRONIC COMPONENTS RSG ■ RSG Electronic Components GmbH Sprendlinger Landstr. 115 D-63069 Offenbach/Germany Tel. +49 69 984047-0 Fax +49 69 984047-77 info@rsg-electronic.de www.rsg-electronic.de ■ ■ ■ Änderungen vorbehalten / subject to change without notice