FR602

FR601 THRU FR607 FAST RECOVERY RECTIFIERS Voltage – 50 to 1000 Volts Current – 6.0 Ampere Features • Low forward voltage drop • Low leakage • High current capability • High reliability • High current surge • Fast switching Mechanical Data • Case: Molded plastic. • Epoxy: UL 94V-0 rate flame retardant. • Terminals: MIL-STD-202E, method 208C guaranteed. • Polarity: Color band denotes cathode end. • Mounting Position: Any. Absolute Maximum Ratings and Characteristics @ 250C unless otherwise specified. Single phase half wave, 60Hz, resistive or inductive load. For capacitive load, derate current by 20%. Symbols Maximum repetitive peak reverse voltage Maximum RMS voltage Maximum DC blocking voltage Maximum Average forward rectified current at TA = 75 OC Peak forward surge current 8.3ms single half sine-wave, superimposed on rated load (JEDEC method) Maximum instantaneous forward voltage at IFM = 6 A , Maximum DC reverse current at rated DC blocking voltage TA = 25 OC TL = 55OC VRRM VRMS VDC I(AV) IFSM VF IR Trr CJ TJ ,TS FR601 FR602 FR603 FR604 FR605 FR606 FR607 50 35 50 100 70 100 200 140 200 400 280 400 6.0 300 1.3 10 150 150 150 -65 to +150 250 500 600 420 600 800 560 800 1000 700 1000 Units Volts Volts Volts Amps Amps Volts µA nS pF O Maximum reverse recovery time (Note 1) Typical junction capacitance (Note 2) Operating and storage temperature range C 1) Reverse recovery test conditions: IF = 0.5A, IR = 1A, Irr = 0.25A 2) Measured at 1MHZ and applied reverse voltage of 4volts D.C. SEMTECH ELECTRONICS LTD. ® (Subsidiary of Semtech International Holdings Limited, acompany listed on the Hong Kong Stock Exchange, Stock Code: 724) Dated : 12/04/2003 FR601 THRU FR607 TYPICAL FORWARD CURRENT DERATING CURVE AVERAGE FORWARD CURRENT.(A) PEAK FORWARD SURGE CURRENT.(A) MAXIMUM NON-REPETITIVE FORWARD SURGE CURRENT 8.3 ms single half sine wave JEDEC method single phase,half wave 60Hz resistive or inductive load NUMBER OF CYCLES AT 60Hz Ambient Temperature Ta ( ℃ ) TYPICAL FORWARD CHARACTERISTICS INSTANTANEOUS FORWARD CURRENT.(A) TYPICAL JUNCTION CAPACITANCE JUNCTION CAPACITANCE.(pF) TJ=25 C T j=25 C Pulse Width 300us 1% Duty Cycle FORWARD VOLTAGE .(V) REVERSE VOLTAGE.(V) T E ST C IR C U IT D IA G R A M A N D R E V E R SE R E C O V E R Y T IM E C H A R A C T E R IST IC S 50Ω N O N -IN D U C T IV E 10 Ω N O N -IN D U C TIV E trr +0.5A 0 2 5V dc (approx.) p ulse generator (N ote 2) noninductive Ω -0.25A oscilliscope (N ote 1) -1.0A 1cm set time base for 50/10ns/cm N otes: 1.R ise tim e = 2ns m ax. Input im pedance= 1m egohm .22pF 2. R ise tim e= 10ns m ax. Source im pedance= 50ohm s. SEMTECH ELECTRONICS LTD. ® (Subsidiary of Semtech International Holdings Limited, acompany listed on the Hong Kong Stock Exchange, Stock Code: 724) Dated : 12/04/2003