E-TDE1707BFPT

TDE1707BFP ® IV E INTELLIGENT POWER SWITCH SO8 -I ORDERING NUMBER: TDE1707BFP E ternal +5V supply can be used to supply external circuits (See also AN495/0692). A signal is internally generated to block the In signal, and prevent activation of the output switch, as long as an abnormal condition is detected. The power-on transition, as well as the chip overtemperature and the output overcurrent, concurr to the generation of such signal. A minimum delay of 25µs (Typ. value) is added to the trailing edge of such signal to ensure that a stable normal situation is present when the signal disappears. The delay (of the disapperance of the block signal; no delay at its on set) can be further increased connecting a capacitor between pin3 and ground. It can drive resistive or inductive loads. IV 0.5A OUTPUT CURRENT LOW SIDE OR HIGH SIDE SWITCH CONFIGURATION 6V TO 48V SUPPLY VOLTAGE RANGE OVERLOAD AND SHORT CIRCUIT PROTECTIONS INTERNAL VOLTAGE CLAMPING SUPPLY AND OUTPUT REVERSAL PROTECTION THERMAL SHUTDOWN GND AND VS OPEN WIRE PROTECTION ADJUSTABLE DELAY AT SWITCH ON INDICATOR STATUS LED DRIVER +5V REGULATED AUX. VOLTAGE HIGH BURST IMMUNITY NA CT PRODUCT PREVIEW IN AC TI VE -I NA CT DESCRIPTION The TDE1707BFP is a 0.5A Integrated Power Switch with up to 48V Power supply capability. Two output configurations are possible: - Load to Gnd. (High Side Mode) - Load to VS (Low side Mode) Especially dedicated to proximity detectors, its inBLOCK DIAGRAM September 2003 1/6 This is preliminary information on a new product now in development or undergoing evaluation. Details are subject to change without notice. TDE1707BFP Vreg Vdelay Supply Reverse Voltage Output Current -I VSr IO Parameter Supply Voltage Regulated Voltage Pin Delay Cap. Surce Pin TI VE Symbol VS NA ABSOLUTE MAXIMUM RATINGS CT IV E -I NA CT IV E PIN CONNECTION (Top view) VO Vi Output Diff. Voltage Input Voltage Value 50 Unit V 50 internally limited V A 0 to 7 0 to 5 V V 55 -10 to 50 V V Operating Temperature Range -25 to +85 °C Storage Temperature Power Dissipation -55 to 150 internally limited °C W El Energy Induct. Load 150 mJ IN AC Top Tstg Ptot THERMAL DATA Symbol Rth j-amb 2/6 Description Thermal Resistance Junction-ambient Max. Value Unit 150 °C/W TDE1707BFP ELECTRICAL CHARACTERISTICS (VS = 24V; Tj = –25 to +85°C, unless otherwise specified) Symbol Parameter Test Condition Typ. 6 Max. Unit Vs 7 Isr 7 48 V Supply Reverse Current VSR = –48V 1.5 mA Iq 7 Quiescent Current Ireg = Iled = 0; Vi < 2V; VS = 6 to 48V 1.5 mA Io 8/2 Output Current Vs = 6V to 32V Io 8/2 Vsat 8/2 Output Current Vs = 32V to 48V Output Voltage Drop V8-2 Io = 500mA Vsat 8/2 Output Voltage Drop V8-2 Io = 300mA Isc 8/2 Vcl 8/2 Short Circuit Current Internal Voltage Clamp Iolk 8/2 Output Leakage NA CT 1.1 0.7 55 ICL = 10mA 0 (Pin 2) Vi < 2V; Vo = 0 to Vs (Pin 8) Vith 5 Input Voltage Threshold Vihis 5 Ilk 5 Input Threshold Hysteresis Input Current Vi = 5V Vreg 6 Iscr 6 Regulated Output Voltage Short Circuit Regulated Ireg < 5mA Ireg 6 Ouput Regulator Current Vs = 35V Vs = 48V 500 mA 300 mA 1.6 V 1.5 V 1.5 70 A V 300 100 µA µA 3 IV Output ON (±) Ios = 2mA (±) Lead Driver (off) Leak. Del. Cap. Charge Current Delay Voltage Trigger Vi < 2V; RL < 1KΩ TJ = 25°C TJ = 25°C NA CT Current Surce Sink Led Driver Voltage Drop Led Driver -I APPLICATION INFORMATION (See Application Circuit) The LED driver tells the output status. It can source or sink current (Iold typ = 3mA), according to the output configuration chosen. The thresholds, represented by the output comparator in the Block Diagram, are set at about 1.5V - 2V. For instance, in the High Side Load case of the 4.5 6 2 2 V mV 2 5 µA 5 30 5.5 50 V mA 3 6 4 4 mA mA mA 1.2 1.6 V 10 µA 6 µA V E -I 300 Iold 1 TI VE 100 2 Vold 1 Oldlk 1 Idch 3 Vdth 3 IV E Supply Voltage Min. 4 4 Application Circuit, when the voltage on pin 8 (the output) differs from VCC less than 1.5V, the output is sensed in "OFF" state and the LED driver is disabled. If instead pin 8 differs from VCC more than 3V (the output comparator threshold value plus the drop voltage on the LED), then the output is sensed "ON" and the driver will force the current on the LED. DYNAMIC CHARACTERISTICS (VS = 24V; RL = 48Ω; TJ = 25°C) Propagation Turn on Time Vi = 0 to 5V 15 Propagation Turn off Time Delayed Turn on Time / nF Delay Capacitor Vi = 5 to 0V 15 1 td min Minimum Delayed ton Delay Capacitor = 0 IN AC ton toff tdon 0.65 25 µs 2 µs ms µs 3/6 TDE1707BFP Figure 1: Input Thresholds Voltage vs. Temperature (VS = 24V) CT IV E -I NA CT IV E APPLICATION CIRCUIT IN AC TI VE -I NA Figure 2: Saturation Voltage vs. Temperature (VS = 24V; IO = 500mA) 4/6 Figure 3: Quiescent Current) vs.Temperature (VS = 24V) TDE1707BFP mm TYP. A MIN. TYP. 1.75 0.1 0.25 a2 0.069 0.004 0.010 1.65 0.065 a3 0.65 0.85 0.026 0.033 b 0.35 0.48 0.014 0.019 b1 0.19 0.25 0.007 0.010 C 0.25 0.5 0.010 0.020 D (1) 4.8 5.0 0.189 0.197 E 5.8 6.2 0.228 0.244 e 1.27 0.050 e3 3.81 0.150 F (1) 3.8 4.0 0.15 0.157 L 0.4 1.27 0.016 0.050 M 0.6 0.024 8 ° (max.) S SO8 IN AC TI VE -I NA CT (1) D and F do not include mold flash or protrusions. Mold flash or potrusions shall not exceed 0.15mm (.006inch). -I 45° (typ.) E c1 OUTLINE AND MECHANICAL DATA MAX. IV a1 MAX. IV E MIN. inch NA CT DIM. 5/6 TI VE -I NA CT IV E -I NA CT IV E TDE1707BFP IN AC Information furnished is believed to be accurate and reliable. However, STMicroelectronics assumes no responsibility for the consequences of use of such information nor for any infringement of patents or other rights of third parties which may result from its use. No license is granted by implication or otherwise under any patent or patent rights of STMicroelectronics. Specifications mentioned in this publication are subject to change without notice. This publication supersedes and replaces all information previously supplied. STMicroelectronics products are not authorized for use as critical components in life support devices or systems without express written approval of STMicroelectronics. The ST logo is a registered trademark of STMicroelectronics. All other names are the property of their respective owners © 2003 STMicroelectronics - All rights reserved STMicroelectronics GROUP OF COMPANIES Australia – Belgium - Brazil - Canada - China – Czech Republic - Finland - France - Germany - Hong Kong - India - Israel - Italy - Japan Malaysia - Malta - Morocco - Singapore - Spain - Sweden - Switzerland - United Kingdom - United States www.st.com 6/6