EVAL5980

EVAL5980 0.7 A step-down switching regulator demonstration board based on the L5980 Data Brief Features ■ 0.7 A DC output current ■ 2.9 V to 18 V input voltage ■ Output voltage adjustable from 0.6 V to 16 V ■ 250 kHz switching frequency, programmable up to 1 MHz ■ Internal soft-start and inhibit ■ Low dropout operation: 100 % duty cycle ■ Zero-load current operation ■ Over-current and thermal protection ■ VFQFPN8 3 mm x 3 mm package EVAL5980 !-V Description The compensation network on the demonstration board allows the use of MLCC as output filter to keep the loop stable. The inductor saturation current and forward current of the Schottky diode are within the current limit values. The EVAL5980 demonstration board provides the design engineer with a fully functional step-down switching regulator with an output current of up to 0.7 A. The L5980 integrates STMicroelectronics step-down switching regulator, together with all the external components required for a typical application. The switching frequency on the demonstration board is set to 500 kHz by means of the R5 resistor connected to pin Fsw. The rated voltage of the input capacitor and the Schottky diode rectifier repetitive peak reverse voltage are both 25 V, making the board capable of covering the entire 2.9 V - 18 V input voltage range of the L5980 device. The board features an external resistor divider (R1 and R2) designed for an output voltage of 3.3 V. The output voltage can be set to a level from 0.6 V up to the rated voltage of the output capacitor (16 V). March 2009 Rev 1 For further information contact your local STMicroelectronics sales office. 1/6 www.st.com 6 EVAL5980 1 EVAL5980 application circuit and component list EVAL5980 application circuit and component list Figure 1. Application circuit VIN=3.3V to 18V VCC INH GND C1 C6 10uF 68nF L1 15uH OUT 8 1 3 2 SYNCH D1 STPS2L25U L5985 L5980 7 Vout=3.3V C2 R1 4.99K FB 22uF 5 6 FSW 4 C4 10nF COMP R5 100K R3 180 R4 3.9K C3 3.3nF R2 1.1K C5 150pF Table 1. Component list Reference Part number Description Manufacturer C1 GRM31CR61E106KA12 10 µF, 25 V MURATA C2 GRM32ER61E226KE15 22 µF, 25 V MURATA C3 3.3 nF, 50 V C4 10 nF, 50 V C5 150 pF, 50 V C6 68 nF, 25 V R1 4.99 kΩ, 1 %, 0.1 W 0603 R2 1.1 kΩ, 1 %, 0.1 W 0603 R3 180 Ω, 1 %, 0.1 W 0603 R4 3.9 kΩ, 1 %, 0.1 W 0603 R5 100 kΩ, 1 %, 0.1 W 0603 D1 STPS2L25V 2 A, 25 V STMicroelectronics L1 7447779115 15 µH, 20 %, 2.2 A Wurth elektronik 2/6 EVAL5980 2 PCB layout PCB layout Figure 2. PCB layout (component side) Figure 3. PCB layout (bottom side) Figure 4. PCB layout (front side) 3/6 EVAL5980 3 Package mechanical data Package mechanical data In order to meet environmental requirements, ST offers these devices in different grades of ECOPACK® packages, depending on their level of environmental compliance. ECOPACK® specifications, grade definitions and product status are available at: www.st.com. ECOPACK® is an ST trademark. 4/6 EVAL5980 4 Revision history Revision history Table 2. Document revision history Date Revision 02-Mar-2009 1 Changes Initial release 5/6 EVAL5980 Please Read Carefully: Information in this document is provided solely in connection with ST products. STMicroelectronics NV and its subsidiaries (“ST”) reserve the right to make changes, corrections, modifications or improvements, to this document, and the products and services described herein at any time, without notice. All ST products are sold pursuant to ST’s terms and conditions of sale. Purchasers are solely responsible for the choice, selection and use of the ST products and services described herein, and ST assumes no liability whatsoever relating to the choice, selection or use of the ST products and services described herein. No license, express or implied, by estoppel or otherwise, to any intellectual property rights is granted under this document. If any part of this document refers to any third party products or services it shall not be deemed a license grant by ST for the use of such third party products or services, or any intellectual property contained therein or considered as a warranty covering the use in any manner whatsoever of such third party products or services or any intellectual property contained therein. UNLESS OTHERWISE SET FORTH IN ST’S TERMS AND CONDITIONS OF SALE ST DISCLAIMS ANY EXPRESS OR IMPLIED WARRANTY WITH RESPECT TO THE USE AND/OR SALE OF ST PRODUCTS INCLUDING WITHOUT LIMITATION IMPLIED WARRANTIES OF MERCHANTABILITY, FITNESS FOR A PARTICULAR PURPOSE (AND THEIR EQUIVALENTS UNDER THE LAWS OF ANY JURISDICTION), OR INFRINGEMENT OF ANY PATENT, COPYRIGHT OR OTHER INTELLECTUAL PROPERTY RIGHT. UNLESS EXPRESSLY APPROVED IN WRITING BY AN AUTHORIZED ST REPRESENTATIVE, ST PRODUCTS ARE NOT RECOMMENDED, AUTHORIZED OR WARRANTED FOR USE IN MILITARY, AIR CRAFT, SPACE, LIFE SAVING, OR LIFE SUSTAINING APPLICATIONS, NOR IN PRODUCTS OR SYSTEMS WHERE FAILURE OR MALFUNCTION MAY RESULT IN PERSONAL INJURY, DEATH, OR SEVERE PROPERTY OR ENVIRONMENTAL DAMAGE. ST PRODUCTS WHICH ARE NOT SPECIFIED AS "AUTOMOTIVE GRADE" MAY ONLY BE USED IN AUTOMOTIVE APPLICATIONS AT USER’S OWN RISK. Resale of ST products with provisions different from the statements and/or technical features set forth in this document shall immediately void any warranty granted by ST for the ST product or service described herein and shall not create or extend in any manner whatsoever, any liability of ST. ST and the ST logo are trademarks or registered trademarks of ST in various countries. Information in this document supersedes and replaces all information previously supplied. The ST logo is a registered trademark of STMicroelectronics. All other names are the property of their respective owners. © 2009 STMicroelectronics - All rights reserved STMicroelectronics group of companies Australia - Belgium - Brazil - Canada - China - Czech Republic - Finland - France - Germany - Hong Kong - India - Israel - Italy - Japan Malaysia - Malta - Morocco - Singapore - Spain - Sweden - Switzerland - United Kingdom - United States of America www.st.com 6/6