STEVAL-ISF003V1
Low standby losses power front-end with inrush current-limitation
Data brief
Description
Features
Fully electronic solution without the need for
an inrush current limiter resistor and its bulky
bypass electromechanical relay
DC bus disconnection at standby to reduce
losses below 0.3 W
Inrush current compliance with IEC61000-33
Operation allowed with PFC (continuous or
discontinuous)
Compliant with EN 55015, IEC 61000-4-11
Criteria A at 4 kV IEC 61000-4-5 and at 4 kV
IEC 61000-4-4
RoHS compliant
April 2017
The STEVAL-ISF003V1 evaluation board allows
the inrush-current which charges a DC bus
capacitor to be limited to comply with the IEC
61000-3-3 standard. This inrush-current
limitation is based on a soft-start procedure of
the mixed bridge diodes and SCRs rectifier
using progressive phase control at board
start-up.
This solution can also drastically reduce standby
losses as the DC bus can be totally disconnected
from the AC mains when it does not have to
operate. DC bus deactivation is simply achieved
by turning off SCRs, without requiring an
additional relay to open the circuit in standby.
The steady-state losses are also reduced, thanks
to the removal of the NTC / PTC resistor
traditionally used to limit inrush-current.
Therefore, no relay is required to bypass this
resistor as it is no longer used.
DocID029452 Rev 2
For further information contact your local STMicroelectronics sales
office
1/6
www.st.com
Schematic diagrams
STEVAL-ISF003V1
Schematic diagrams
Figure 1: STEVAL-IFS003V1 power and insulated control schematic
2/6
DocID029452 Rev 2
STEVAL-ISF003V1
Schematic diagrams
Figure 2: STEVAL-ISF003V1 control circuit schematic
DocID029452 Rev 2
3/6
Schematic diagrams
STEVAL-ISF003V1
Figure 3: STEVAL-ISF003V1 flyback SMPS schematic
4/6
DocID029452 Rev 2
STEVAL-ISF003V1
Revision history
Revision history
Table 1: Document revision history
Date
Version
Changes
16-Jun-2016
1
Initial release.
18-Apr-2017
2
Updated Section: "Schematic diagrams".
DocID029452 Rev 2
5/6
STEVAL-ISF003V1
IMPORTANT NOTICE – PLEASE READ CAREFULLY
STMicroelectronics NV and its subsidiaries (“ST”) reserve the right to make changes, corrections, enhancements, modifications, and
improvements to ST products and/or to this document at any time without notice. Purchasers should obtain the latest relevant information on ST
products before placing orders. ST products are sold pursuant to ST’s terms and conditions of sale in place at the time of order
acknowledgement.
Purchasers are solely responsible for the choice, selection, and use of ST products and ST assumes no liability for application assistance or the
design of Purchasers’ products.
No license, express or implied, to any intellectual property right is granted by ST herein.
Resale of ST products with provisions different from the information set forth herein shall void any warranty granted by ST for such product.
ST and the ST logo are trademarks of ST. All other product or service names are the property of their respective owners.
Information in this document supersedes and replaces information previously supplied in any prior versions of this document.
© 2017 STMicroelectronics – All rights reserved
6/6
DocID029452 Rev 2
很抱歉,暂时无法提供与“STEVAL-ISF003V1”相匹配的价格&库存,您可以联系我们找货
免费人工找货