TPAC175D-490O

UNIVERSAL AC INPUT HARMONIC CORRECTION AC-DC HOT-SWAP CompactPCI QUAD OUTPUT 175 WATTS CURRENT SHARING SWITCHING POWER SUPPLIES TPAC175P & TPAC175D SERIES FEATURES: 175W IN 3U X 8HP EUROCARD PACKAGE UNIVERSAL AC INPUT WITH PFC INTERNAL OR-ING DIODES FOR N+1 REDUNDANCY HOT-SWAPPABLE DROOP CURRENT SHARING EMI MEET EN55022 / FCC CLASS A CE MARKING COMPLIANCE FULLY COMPLIANT WITH PICMG TOTAL POWER INT'L SPECIFICATION INPUT SPECIFICATION Input Voltage: Typ. 90-264Vac with PFC. Power Factor Correction: Meet Harmonic Correction IEC1000-3-2. Power Factor typ. 0.98. Input Connector: PCIH47M400A1 for TPAC175P. DIN41612 M24/8 for TPAC175D. Input Frequency: 47-63Hz. Inrush Current: Less than 30A @ 230Vac.By thermistor. Input Current: 2.2A @115Vac/1.1A @230Vac for TPAC175D. 2.4A @115Vac/1.2A @230Vac for TPAC175P. Dielectric Withstand: Meet IEC950 regulation. EMI: Meet EN55022 / FCC Class A. Hold-up Time: 5mS @115V & 230Vac after power fail signal. Remote ON/OFF: Available at [INH#] & [EN#] pins. Power Fail Signal: Available at [FAL#] pin. Status LED: means valid input voltage. means a critical fault. Thermal Protection: Installed NTC for thermal sensor at [DEG#] pin. Earth Leakage: Less than 0.5mA @230Vac. OUTPUT SPECIFICATION Output Voltage: See Ratings Chart. Output Current: See Ratings Chart. Output Wattage: Typ. 175W continuous. Output Connector: PCIH47M400A1 for TPAC175P. DIN41612 M24/8 for TPAC175D. Line Regulation: Typ. 0.5%. Load Regulation: VO1 & VO2 typ. ±1.0%. VO3 & VO4 typ. ±2.0%. Noise & Ripple: Typ. 1% peak-peak or 50mV, which is greater. OVP: Built-in at VO1 & VO2. Adjustability: Available at VO1 & VO2. VO3 factory set. Remote Sensing: Available at VO1 & VO2. Hot-Swap: Available. N+1 Redundancy: Installed with OR-ing diodes for N+1 redundancy operation. Current Sharing: Droop current sharing at all output. Power OK Signal: Available for VO1 & VO2. Over Current Protection (OCP): Installed in all outputs. Overload Protection (OLP): Fully protected against output oveload and short circuit. Typically set at 130-150% max. load. Consult factory for special OLP setting. GENERAL SPECIFICATION Efficiency: Typ. 75-78%. Switching Frequency: 100 KHz. Circuit Topology: Half-bridge circuit. Transient Response: Typ. 1.0mS for a 25% load change. Safety Standard: IEC950/ UL1950 Class I. Construction: Eurocard 3U x 8HP x 160mm CompactPCI format. Front Panel with either Ordinary handle or Extractor handle. Operating Temperature: 0 to +50°C at full load with specified air flow. Derates linearly to 50% at +70°C. Storage Temperature: -40°C to +85°C. Temperature Coefficient: Typ. ±0.02% /°C. Cooling: At least 20cfm (600lfm) airflow is required to deliver full rating load. Power Density: 3.2 Watts /Cubic Inch. Note: All measurements are at nominal input, full load, and +25℃ unless otherwise specified. In application TOTAL POWER, INT. Tel: 877-646-0900 Fax: 978-453-7395 Email: sales@total-power.com http://www.total-power.com -1- OUTPUT VOLTAGE / CURRENT RATINGS CHART QUAD OUTPUT MAIN +VO1 @ Min. Typ. Volt. TPAC175P-490(E) 2.0A 20A +5V TPAC175P-490(O) 2.0A 20A +5V TPAC175D-490(O) 2.0A 20A +5V MODEL NO. #=⊙ Max. 35A 35A 35A AUX. +VO2 ▲ #=⊙@ Typ. Max. Volt. 10A +3.3V 20A 10A +3.3V 20A 10A +3.3V 20A AUX. +VO3▲=⊙ (@) Typ. Volt. Max. Peak 3.0A +12V # 5.0A 6A 3.0A +12V # 5.0A 6A 3.0A +12V 5.0A 6A AUX. +VO4 ● =⊙ Typ. Volt. Max. Peak 0.5A -12V 1.0A 1.0A 0.5A -12V 1.0A 1.0A 0.5A -12V 1.0A 1.0A Symbol: " " OVP built-in. "@" Adjustable. "(@)" Adjustable factory set. "#" Remote sensing. "=" Droop Load Sharing. "⊙" Installed with Or-ing diode. "▲" Magnetic Amplifier. "●" Installed with Post Regulator. Remark: Peak load less than 60sec. with duty cycle