USP-225-12

TOTAL POWER INT'L 225W Single Output with PFC Function Features : USP-225 series Universal AC input / Full range Built in active PFC circuit compliance to EN61000-3-2 Protections:Short circuit/Over load/Over voltage/Over temperature Free air convection for 150W and forced air convection for 225W High power density 4.7w/in 3 Active AC surge current limiting U-bracket low profile:38mm 3 years warranty SPECIFICATION MODEL DC VOLTAGE RATED CURRENT CURRENT RANGE RATED POWER OUTPUT USP-225-3.3 3.3V 40A 0 ~ 40A 132W USP-225-5 5V 40A 0 ~ 40A 200W 100mVp-p USP-225-12 12V 18.7A 0 ~ 18.7A 224.4W 100mVp-p 10.8 ~ 13.2V USP-225-15 15V 15A 0 ~ 15A 225W 100mVp-p 13.5 ~ 16.5V USP-225-24 24V 9.4A 0 ~ 9.4A 225.6W 150mVp-p 21.6 ~ 26.4V USP-225-48 48V 4.7A 0 ~ 4.7A 225.6W 250mVp-p 43.2 ~ 52.8V 2.0% 0.5% 1.0% RIPPLE & NOISE (max.) Note.2 100mVp-p VOLTAGE ADJ. RANGE 2.97 ~ 3.6V VOLTAGE TOLERANCE Note.3 2.0% LINE REGULATION LOAD REGULATION SETUP, RISE, HOLD TIME VOLTAGE RANGE FREQUENCY RANGE POWER FACTOR INPUT EFFICIENCY (Typ.) AC CURRENT 115VAC 230VAC INRUSH CURRENT (max.) 4.5 ~ 5.5V 2.0% 0.5% 0.5% 1.0% 1.0% 500ms, 30ms, 22ms/230VAC 2.0% 2.0% 0.5% 0.5% 1.0% 1.0% 1200ms, 30ms, 22ms/115VAC at full load 2.0% 0.5% 1.0% 90 ~ 264VAC 47 ~ 63Hz PF>0.93/230VAC 72% 2.2A 1.1A 20A/115VAC 0.97/115VAC at full load 77% 3.3A 1.6A 30A/230VAC 85% 84% 87% 86% LEAKAGE CURRENT OVER LOAD PROTECTION OVER VOLTAGE 105 ~ 150% rated output power Protection type : Constant current limiting, recovers automatically after fault condition is removed 3.6 ~ 4.4V 5.5 ~ 7.4V 13.2 ~ 16.3V Protection type : Shut down o/p voltage, re-power on to recover 95 5 (RTH2 : Detect on heatsink of power transistor) -20 ~ +65 -40 ~ +85 16.5 ~ 20.2V 26.4 ~ 32.4V 52.8 ~ 64.8V OVER TEMPERATURE WORKING TEMP. WORKING HUMIDITY ENVIRONMENT STORAGE TEMP., HUMIDITY TEMP. COEFFICIENT VIBRATION SAFETY STANDARDS WITHSTAND VOLTAGE SAFETY & EMC (Note 4) Protection type : Shut down o/p voltage, recovers automatically after temperature goes down (Refer to output load derating curve) , 10 ~ 95% RH 20 ~ 90% RH non-condensing 0.03%/ (0 ~ 50 10 ~ 500Hz, 2G 10min./1cycle, 60min. each along X, Y, Z axes UL60950, TUV EN60950 Approved I/P-O/P:3KVAC I/P-FG:1.5KVAC O/P-FG:0.5KVAC I/P-O/P, I/P-FG, O/P-FG:100M Ohms/500VDC Compliance to EN55022 (CISPR22) Class B ISOLATION RESISTANCE EMI CONDUCTION & RADIATION HARMONIC CURRENT EMS IMMUNITY MTBF Compliance to EN61000-3-2,-3 Compliance to EN61000-4-2,3,4,5,6,8,11; ENV50204, Light industry level, criteria A 220K hrs min. MIL-HDBK-217F (25 ) 202*101.5*38mm (L*W*H) 0.85Kg; 16pcs/13.6Kg/0.76CUFT OTHERS NOTE DIMENSION PACKING 1. All parameters NOT specially mentioned are measured at 230VAC input, rated load and 25 of ambient temperature. 2. Ripple & noise are measured at 20MHz of bandwidth by using a 12" twisted pair-wire terminated with a 0.1uf & 47uf parallel capacitor. 3. Tolerance : includes set up tolerance, line regulation and load regulation. 4. The power supply is considered a component which will be installed into a final equipment. The final equipment must be re-confirmed that it still meets EMC directives. 225W Single Output with PFC Function Mechanical Specification USP-225 Case No. 928 series Unit:mm 202 198.25 65.75 3.75 60 38 8 2- 3.2 48.5 LED 101.5 CN2 10 9 8 7 6 5 4 3 2 1 11 12 13 14 15 16 17 18 19 20 1 2 3 CN1 FS1 F6.3A/250V AC Input Connector (CN1) : JST B3P-VH or equivalent Pin No. 1 2 3 Assignment AC/N No Pin AC/L Mating Housing JST VHR or equivalent Terminal JST SVH-21T-P1.1 or equivalent DC Output Connector (CN2) : MOLEX 39-29-9206 or equivalent Pin No. 1~5 6~15 16~20 Assignment +V -V +V Mating Housing MOLEX 5557 or equivalent Terminal MOLEX 5556 or equivalent Block Diagram EMI FILTER ACTIVE INRUSH CURRENT LIMITING fosc : 100KHz RECTIFIERS & P.F.C. POWER SWITCHING RECTIFIERS & FILTER O.T.P. 101.5 93.5 2-M 3 I/P +V -V O.C.P. FG O.L.P. P WM CONTROL DETECTION CIRCUIT O.V.P. Derating Curve 3.3V,5V Model With 18CFM Forced Air Convection Static Characteristics (5V) Ta=25 With18CFM Forced Air Convection 100 100 90 80 70 80 65 60 Free Air Convection LOAD (%) 50 40 3.3V,5V Model Free Air Convection LOAD(%) 0 10 20 30 40 45 50 60 70 60 50 40 20 -20 90 100 110 135 155 230 260 AMBIENT TEMPERATURE ( ) INPUT VOLTAGE (V) 60Hz